The "blackhole" driver was used in conjunction with bhyve to sequester
pci devices intended for passthru until vmm.ko was loaded. This was
useful at one point because vmm.ko could not be loaded at boot time.
The same functionality can now be achieved by loading vmm.ko via the
loader along with the kernel.
Discussed with: grehan
Obtained from: NetApp
There is one known issue: Some probes will display an error message along the
lines of: "Invalid address (0)"
I tested this with both a simple dtrace probe and dtruss on a few different
binaries on 32-bit. I only compiled 64-bit, did not run it, but I don't expect
problems without the modules loaded. Volunteers are welcome.
MFC after: 1 month
GIANT from VFS. In addition, disconnect also netsmb, which is a base
requirement for SMBFS.
In the while SMBFS regular users can use FUSE interface and smbnetfs
port to work with their SMBFS partitions.
Also, there are ongoing efforts by vendor to support in-kernel smbfs,
so there are good chances that it will get relinked once properly locked.
This is not targeted for MFC.
GIANT from VFS. This code is particulary broken and fragile and other
in-kernel implementations around, found in other operating systems,
don't really seem clean and solid enough to be imported at all.
If someone wants to reconsider in-kernel NTFS implementation for
inclusion again, a fair effort for completely fixing and cleaning it
up is expected.
In the while NTFS regular users can use FUSE interface and ntfs-3g
port to work with their NTFS partitions.
This is not targeted for MFC.
GIANT from VFS. In addition, disconnect also netncp, which is a base
requirement for NWFS.
In the possibility of a future maintenance of the code and later
readd to the FreeBSD base, maybe we should think about a better location
for netncp. I'm not entirely sure the / top location is actually right,
however I will let network people to comment on that more specifically.
This is not targeted for MFC.
sdchi encapsulates a generic SD Host Controller logic that relies on
actual hardware driver for register access.
sdhci_pci implements driver for PCI SDHC controllers using new SDHCI
interface
No kernel config modifications are required, but if you load sdhc
as a module you must switch to sdhci_pci instead.
This has been developed during 2 summer of code mandates and being revived
by gnn recently.
The functionality in this commit mirrors entirely content of fusefs-kmod
port, which doesn't need to be installed anymore for -CURRENT setups.
In order to get some sparse technical notes, please refer to:
http://lists.freebsd.org/pipermail/freebsd-fs/2012-March/013876.html
or to the project branch:
svn://svn.freebsd.org/base/projects/fuse/
which also contains granular history of changes happened during port
refinements. This commit does not came from the branch reintegration
itself because it seems svn is not behaving properly for this functionaly
at the moment.
Partly Sponsored by: Google, Summer of Code program 2005, 2011
Originally submitted by: ilya, Csaba Henk <csaba-ml AT creo DOT hu >
In collabouration with: pho
Tested by: flo, gnn, Gustau Perez,
Kevin Oberman <rkoberman AT gmail DOT com>
MFC after: 2 months
- Stateful TCP offload drivers for Terminator 3 and 4 (T3 and T4) ASICs.
These are available as t3_tom and t4_tom modules that augment cxgb(4)
and cxgbe(4) respectively. The cxgb/cxgbe drivers continue to work as
usual with or without these extra features.
- iWARP driver for Terminator 3 ASIC (kernel verbs). T4 iWARP in the
works and will follow soon.
Build-tested with make universe.
30s overview
============
What interfaces support TCP offload? Look for TOE4 and/or TOE6 in the
capabilities of an interface:
# ifconfig -m | grep TOE
Enable/disable TCP offload on an interface (just like any other ifnet
capability):
# ifconfig cxgbe0 toe
# ifconfig cxgbe0 -toe
Which connections are offloaded? Look for toe4 and/or toe6 in the
output of netstat and sockstat:
# netstat -np tcp | grep toe
# sockstat -46c | grep toe
Reviewed by: bz, gnn
Sponsored by: Chelsio communications.
MFC after: ~3 months (after 9.1, and after ensuring MFC is feasible)
The NAND Flash environment consists of several distinct components:
- NAND framework (drivers harness for NAND controllers and NAND chips)
- NAND simulator (NANDsim)
- NAND file system (NAND FS)
- Companion tools and utilities
- Documentation (manual pages)
This work is still experimental. Please use with caution.
Obtained from: Semihalf
Supported by: FreeBSD Foundation, Juniper Networks
Winbond Super I/O chips.
With minor efforts it should be possible the extend the driver to support
further chips/revisions available from Winbond. In the simplest case
only new IDs need to be added, while different chipsets might require
their own function to enter extended function mode, etc.
Sponsored by: Sandvine Incorporated ULC (in 2011)
Reviewed by: emaste, brueffer
MFC after: 2 weeks
kernel modules that include binary-only code.
More fine-grained control is provided via MK_SOURCELESS_HOST (for native code
that runs on host CPU) and MK_SOURCELESS_UCODE (for microcode).
Reviewed by: julian, delphij, freebsd-arch
Approved by: kib (mentor)
MFC after: 2 weeks
The isci driver is for the integrated SAS controller in the Intel C600
(Patsburg) chipset. Source files in sys/dev/isci directory are
FreeBSD-specific, and sys/dev/isci/scil subdirectory contains
an OS-agnostic library (SCIL) published by Intel to control the SAS
controller. This library is used primarily as-is in this driver, with
some post-processing to better integrate into the kernel build
environment.
isci.4 and a README in the sys/dev/isci directory contain a few
additional details.
This driver is only built for amd64 and i386 targets.
Sponsored by: Intel
Reviewed by: scottl
Approved by: scottl
Tested on Qemu/KVM, VirtualBox, and BHyVe.
Currently built as modules-only on i386/amd64. Man pages not yet hooked
up, pending review.
Submitted by: Bryan Venteicher bryanv at daemoninthecloset dot org
Reviewed by: bz
MFC after: 4 weeks or so
based on Solarflare SFC9000 family controllers. The driver supports jumbo
frames, transmit/receive checksum offload, TCP Segmentation Offload (TSO),
Large Receive Offload (LRO), VLAN checksum offload, VLAN TSO, and Receive Side
Scaling (RSS) using MSI-X interrupts.
This work was sponsored by Solarflare Communications, Inc.
My sincere thanks to Ben Hutchings for doing a lot of the hard work!
Sponsored by: Solarflare Communications, Inc.
MFC after: 3 weeks
compiled into the kernel.
Do not try to build the module in case of no INET support but
keep #error calls for now in case we would compile it into the
kernel.
This should fix an issue where the module would fail to enable
IPv6 support from the rc framework, but also other INET and INET6
parts being silently compiled out without giving a warning in the
module case.
While here garbage collect unneeded opt_*.h includes.
opt_ipdn.h is not used anywhere but we need to leave the DUMMYNET
entry in options for conditional inclusion in kernel so keep the
file with the same name.
Reported by: pluknet
Reviewed by: plunket, jhb
MFC After: 3 days
