> Clear the PROMISC flag from the vlan interface when we remove a member. We
> checked for IFT_L2VLAN in bridge_ioctl_add() but not bridge_delete_member().
>
> Approved by: mlaier (mentor)
>
> Revision Changes Path
> 1.13 +1 -0 src/sys/net/if_bridge.c
Approved by: re (kensmith), mlaier (mentor)
Move eventhandler for 'ifnet_departure_event' at the end of the progress.
Some of the (IPv6) cleanup functions send packets to inform peers of the
departure. These packets confused users of ifnet_departure_event (pf at
the moment).
PR: kern/80627
Tested by: Divacky Roman
Approved by: re (kensmith)
hooks for each outgoing interface but also run pfil hooks _N times_ on the
bridge interface. This is changed so pfil hooks are run once for the bridge
interface (bridge0) and then only on the outgoing interfaces in the broadcast
loop.
- Simplify bridge_enqueue() by moving bridge_pfil() to the callers.
- Check (inet6_pfil_hook.ph_busy_count >= 0), it may be possible to have a
packet filter hooked for only ipv6 but we were only checking if ipv4 hooks
were busy.
- Minor optimisation for null mbuf check after bridge_pfil(), move it into the
if-block as it couldnt possibly be null outside.
Prodded by: mlaier
Approved by: re (scottl), mlaier (mentor)
redundant with respect to existing mbuf copy label routines. Expose
a new mac_copy_mbuf() routine at the top end of the Framework and
use that; use the existing mpo_copy_mbuf_label() routine on the
bottom end.
Obtained from: TrustedBSD Project
Sponsored by: SPARTA, SPAWAR
Approved by: re (scottl)
packet filter. This would cause a panic on architectures that require strict
alignment such as sparc64, ia64 and ppc.
This uses the code block from if_bridge and the newly added macro
IP_HDR_ALIGNED_P().
This /might/ be a temporary messure before all NIC drivers are educated
to align the header themself.
PR: ia64/81284
Obtained from: NetBSD (if_bridge)
Approved by: re (dwhite), mlaier (mentor)
packet filter. This would cause a panic on architectures that require strict
alignment such as sparc64 (tier1) and ia64/ppc (tier2).
This adds two new macros that check the alignment, these are compile time
dependent on __NO_STRICT_ALIGNMENT which is set for i386 and amd64 where
alignment isn't need so the cost is avoided.
IP_HDR_ALIGNED_P()
IP6_HDR_ALIGNED_P()
Move bridge_ip_checkbasic()/bridge_ip6_checkbasic() up so that the alignment
is checked for ipfw and dummynet too.
PR: ia64/81284
Obtained from: NetBSD
Approved by: re (dwhite), mlaier (mentor)
- Introducing the possibility of using locks different than mutexes
for the knlist locking. In order to do this, we add three arguments to
knlist_init() to specify the functions to use to lock, unlock and
check if the lock is owned. If these arguments are NULL, we assume
mtx_lock, mtx_unlock and mtx_owned, respectively.
- Using the vnode lock for the knlist locking, when doing kqueue operations
on a vnode. This way, we don't have to lock the vnode while holding a
mutex, in filt_vfsread.
Reviewed by: jmg
Approved by: re (scottl), scottl (mentor override)
Pointyhat to: ssouhlal
Will be happy: everyone
a cosmetic change. m_uiotombuf() produces a packet header mbuf, while
original implementation did not. When kernel is compiled with MAC
support, headerless mbuf will cause panic.
Reported by: Alexander Nikiforenko <asn rambler-co.ru>
Approved by: re (scottl)
MFC After: 2 weeks
route itself.
It fixes a bug where an IPv4 route for example has an IPv6 gateway
specified:
route add 10.1.1.1 -inet6 fe80::1%fxp0
Destination Gateway Flags Refs Use Netif Expire
10.1.1.1 fe80::1%fxp0 UGHS 0 0 fxp0
The fix rejects these illegal combinations:
route: writing to routing socket: Invalid argument
add host 10.1.1.1: gateway fe80::1%fxp0: Invalid argument
Reviewed by: KAME jinmei@isl.rdc.toshiba.co.jp
Reviewed by: andre (mentor)
Approved by: re
MFC after: 5
pointer to a softc which is no longer valid since the ifnet struct was split
out from the softc.
Approved by: mlaier (mentor)
Approved by: re (blanket)
a DLT_NULL interface. In particular:
1) Consistently use type u_int32_t for the header of a
DLT_NULL device - it continues to represent the address
family as always.
2) In the DLT_NULL case get bpf_movein to store the u_int32_t
in a sockaddr rather than in the mbuf, to be consistent
with all the DLT types.
3) Consequently fix a bug in bpf_movein/bpfwrite which
only permitted packets up to 4 bytes less than the MTU
to be written.
4) Fix all DLT_NULL devices to have the code required to
allow writing to their bpf devices.
5) Move the code to allow writing to if_lo from if_simloop
to looutput, because it only applies to DLT_NULL devices
but was being applied to other devices that use if_simloop
possibly incorrectly.
PR: 82157
Submitted by: Matthew Luckie <mjl@luckie.org.nz>
Approved by: re (scottl)
fails.
Move detaching the ifnet from the ifindex_table into if_free so we can
both keep the sanity checks and actually delete the ifnets. [0]
Reported by: gallatin [0]
Approved by: re (blanket)
struct ifnet or the layer 2 common structure it was embedded in have
been replaced with a struct ifnet pointer to be filled by a call to the
new function, if_alloc(). The layer 2 common structure is also allocated
via if_alloc() based on the interface type. It is hung off the new
struct ifnet member, if_l2com.
This change removes the size of these structures from the kernel ABI and
will allow us to better manage them as interfaces come and go.
Other changes of note:
- Struct arpcom is no longer referenced in normal interface code.
Instead the Ethernet address is accessed via the IFP2ENADDR() macro.
To enforce this ac_enaddr has been renamed to _ac_enaddr.
- The second argument to ether_ifattach is now always the mac address
from driver private storage rather than sometimes being ac_enaddr.
Reviewed by: sobomax, sam
using the layer2, mac and mac-type keywords.
This is one of the last features that bridge.c has over if_bridge and gets us
very close to a full functional replacement.
Approved by: mlaier (mentor)
coded at 512 (BPF_MAXINSNS) to being tunable. This is useful for users
who wish to use complex or large bpf programs when filtering traffic.
For now we will default it to BPF_MAXINSNS. I have tested bpf programs
with well over 21,000 instructions without any problems.
Discussed with: phk
spanning tree support.
Based on Jason Wright's bridge driver from OpenBSD, and modified by Jason R.
Thorpe in NetBSD.
Reviewed by: mlaier, bms, green
Silence from: -net
Approved by: mlaier (mentor)
Obtained from: NetBSD
so if_tap doesn't need to rely on locally-rolled code to do same.
The observable symptom of if_tap's bzero'ing the address details
was a crash in "ifconfig tap0" after an if_tap device was closed.
Reported By: Matti Saarinen (mjsaarin at cc dot helsinki dot fi)
1. Copy a NULL-terminated string into a fixed-length buffer, and
2. copyout that buffer to userland,
we really ought to
0. Zero the entire buffer
first.
Security: FreeBSD-SA-05:08.kmem
to the mbuf. Offset cannot exceed MHLEN bytes. This is currently used to
fix Ethernet header alignment problem on alpha and sparc64. Also change all
users of m_uiotombuf to pass proper offset.
Reviewed by: jmg, sam
Tested by: Sten Spans "sten AT blinkenlights DOT nl"
MFC after: 1 week
debug.bpf_bufsize is now net.bpf.bufsize
debug.bpf_maxbufsize is now net.bpf.maxbufsize
-move function prototypes for bpf_drvinit and bpf_clone up to the
top of the file with the others
-assert bpfd lock in catchpacket() and bpf_wakeup()
MFC after: 2 weeks
a taskqueue(9) task. This fixes LORs and adds possibility
to serve such events pseudorecursively, when link state
change of interface causes subsequent change on other
interfaces.
Sponsored by: Rambler
Reviewed by: sam, brooks, mux
results in connectivty to MacOSX hosts via fwip.
Thanks to Apple's Arulchandran Paramasivam <arulchandranp@apple.com> for
letting us know what we were doing wrong.
Reviewed by: dfr
MFC After: 7 days
