not save (restore) the global pointer (GP) in the jmpbuf in setjmp
(longjmp) because it's not needed in general. GP is considered a
scratch register at callsites and hence is always restored after a
call (when it's possible that the call resolves to a symbol in a
different loadmodule; otherwise GP does not have to be saved and
restored at all), including calls to setjmp/longjmp. There's just
one problem with this now that we use setjmp/longjmp for context
switching: A new context must have GP defined properly for the
thread's entry point. This means that we need to put GP in the
jmpbuf and consequently that we have to restore is in longjmp.
This automaticly requires us to save it as well.
When setjmp/longjmp isn't used for context switching, this can be
reverted again.
integral type to the size of a pointer type when it's known that the
cast is valid. On ia64 such casts are generally bad news and has led
us (=peter :-) to make such casts fatal. By casting to intptr_t
before casting to a pointer type, this now compiles cleanly in LP64
architectures. Note that the final cast has been changed to void*
(instead of siginfo_t*) to make it explicit that we're not trying to
pass a siginfo_t pointer but rather trying to pass an int when the
prototype says it should be a pointer.
the J_SIG0 field. While here, rename J_SIG0 to J_SIGSET and
remove J_SIG1. The main reason for this change is that the
128-bit sigset_t is now aligned on a 16-byte boundary, which
allows us to use 16-byte atomic loads and stores on CPUs that
support it. The removal of J_SIG1 is done to avoid confusion:
it is never accessed and should not be. Renaming J_SIG0 to
J_SIGSET is the icing on the cake that's better done now than
later.
password quality, not login.conf(5).
- Move warnexpire and warnpasswd from the ``Accounting Limits''
section to ``Authentication'', and nix everything else in the
former section. The accounting knobs are not available in
the base system, and the subset of them available in ports
should be documented in the ports' manpages.
PR: 47960
Reviewed by: mike (mentor), doc
file in the NFS file system when the underlying device is not a
network device. A Sparc64 specific hack for this exact problem was
already present (nfs.c:1.9, tftp.c:1.10), but the problem is not
specific to Sparc64. The hack has been promoted to a non-i386 test
because on non-i386 architectures it's either impossible to have
non-network devices coexist in the same loader with the NFS FS, or
network and non-network device coexist and NFS filesystems can only
be used on top of network devices. I believe i386 pxeboot is where
this does not hold.
The root cause of this problem is in open.c where each file system
is tried until no more file systems exist or a file system returns
success. There's no notion of a list of valid file systems given
the underlying device and the non-existence of a file can cause
the invalid combination to be tried.
in math.h; the consensus here was that __BSD_VISIBLE was correct instead.
- gamma_r, lgamma_r, gammaf_r, and lgammaf_r had no documentation in the
lgamma(3) manpage.
Reviewed by: standards@
Submitted by: Ben Mesander
The background info in this man page needs rewriting
in some parts since the last major changes
to the code, however it still accuratly reflects how to use the
API.
* use correct error detection of realloc failure
* strtol negative return check
* use strtol to validate string instead of rolling our own
validation code
* terminate the command sequence correctly
for the sorts of errors we run into[1]. This also gives us room to put in a
vaguely appropriate casts to silence warnings since our compiler doesn't like
when we compare ssize_t to size_t[2]. Add a cast in sblock.c[3] to silence
a warning because of signed vs. size_t hell (again). Clean up nearby
excessive parenthemutilation[4].
Reviewed by: bde [2] [3]
Suggested by: bde, many [1]
Submitted by: bde [4]
An aside about [4], bde notes that we do not check for a negative value for
the fs bsize. I'm nto going to do that in every situation we use it, one must
expect a reasonable program to pass down reasonable values. Some foot shooting
protection I will tolerate, some I will not. Also he suggests some possible
conditional improvements there, which I may take to heart.
PS: For me at least, this is now WARNS=5 clean...
seed->first value correlation. It breaks rand_r()... Other possible methods
like shuffling inside aray will breaks rand_r() too, because it assumes
only one word state, i.e. nothing extra can be added after seed assignment
in srand().
BTW, for old formulae seed->first value correlation is not so monotonically
increased as with other Linear Congruential Generators of this type only
becase arithmetic overflow happens. But overflow affects distribution
and lower bits very badly, as many articles says, such type of overflow
not improves PRNG.
So, monotonically increased seed->first value correlation problem remains...
Only warnings that could be fixed without changing the generated object
code and without restructuring the source code have been handled.
Reviewed by: /sbin/md5
Introdice RTLD_SELF special handle and properly process it within
dlsym() and dlinfo() functions.
The intention is to improve our compatibility with Solaris and
to make a Java port easier.
Partially submitted by: phantom
isnormal(). The current isinf() and isnan() are perserved for
binary compatibility with 5.0, but new programs will use the macros.
o Implement C99 comparison macros isgreater(), isgreaterequal(),
isless(), islessequal(), islessgreater(), isunordered().
Submitted by: David Schultz <dschultz@uclink.Berkeley.EDU>
to maintain, and had security issues which would have required a major
rewrite to address anyway.
This implementation currently starts a separate agent for each session
instead of connecting each new session to the agent started by the first
one. While this would be a Good Thing (and the old pam_ssh(8) tried to
do it), it's hard to get right. I'll revisit this issue when I've had a
chance to test some modifications to ssh-agent(1).
o Add a MD header private to libc called _fpmath.h; this header
contains bitfield layouts of MD floating-point types.
o Add a MI header private to libc called fpmath.h; this header
contains bitfield layouts of MI floating-point types.
o Add private libc variables to lib/libc/$arch/gen/infinity.c for
storing NaN values.
o Add __double_t and __float_t to <machine/_types.h>, and provide
double_t and float_t typedefs in <math.h>.
o Add some C99 manifest constants (FP_ILOGB0, FP_ILOGBNAN, HUGE_VALF,
HUGE_VALL, INFINITY, NAN, and return values for fpclassify()) to
<math.h> and others (FLT_EVAL_METHOD, DECIMAL_DIG) to <float.h> via
<machine/float.h>.
o Add C99 macro fpclassify() which calls __fpclassify{d,f,l}() based
on the size of its argument. __fpclassifyl() is never called on
alpha because (sizeof(long double) == sizeof(double)), which is good
since __fpclassifyl() can't deal with such a small `long double'.
This was developed by David Schultz and myself with input from bde and
fenner.
PR: 23103
Submitted by: David Schultz <dschultz@uclink.Berkeley.EDU>
(significant portions)
Reviewed by: bde, fenner (earlier versions)
