"Under my tutelage Nicole did 85% of the work. At the time it seemed
simplest for a number of reasons to put my copyright on it. I now consider
that to have been a mistake."
Submitted by: Matthew Macy <mmacy@mattmacy.io>
Reviewed by: shurd
Approved by: shurd
Differential Revision: https://reviews.freebsd.org/D14766
The gcc 7 does check for switch statement fall through cases, and if legit,
such complaint can besilenced by /* FALLTHROUGH */ comment. Unfortunately
such comment is quite limited, but will still notify the reader.
This patch is backport from illumos, see
https://www.illumos.org/rb/r/941/
Reviewed by: eadler
Differential Revision: https://reviews.freebsd.org/D14663
Uses of mallocarray(9).
The use of mallocarray(9) has rocketed the required swap to build FreeBSD.
This is likely caused by the allocation size attributes which put extra pressure
on the compiler.
Given that most of these checks are superfluous we have to choose better
where to use mallocarray(9). We still have more uses of mallocarray(9) but
hopefully this is enough to bring swap usage to a reasonable level.
Reported by: wosch
PR: 225197
The value written to E1000_TARC(0) wasn't intended to have every bit but
E1000_TARC0_CB_MULTIQ_3_REQ cleared; a ~ was missing.
Also change the referenced spec update section in the comment to the correct
section.
Sponsored by: Intel Corporation
This reduces noise when kernel is compiled by newer GCC versions,
such as one used by external toolchain ports.
Reviewed by: kib, andrew(sys/arm and sys/arm64), emaste(partial), erj(partial)
Reviewed by: jhb (sys/dev/pci/* sys/kern/vfs_aio.c and sys/kern/kern_synch.c)
Differential Revision: https://reviews.freebsd.org/D10385
Email address has changed, uses consistent name (Matthew, not Matt)
Reported by: Matthew Macy <mmacy@mattmacy.io>
Differential Revision: https://reviews.freebsd.org/D13537
Mainly focus on files that use BSD 3-Clause license.
The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.
Special thanks to Wind River for providing access to "The Duke of
Highlander" tool: an older (2014) run over FreeBSD tree was useful as a
starting point.
Improved logging added in r323879 exposed an error during
attach. We need the irq, not the rid to work correctly. em uses
shared irqs, so it will use the same irq for TX as RX. bnxt does
not use shared irqs, or TX irqs at all, so there's no need to set
the TX irq affinity.
Reviewed by: sbruno
Approved by: sbruno (mentor)
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D12496
GPUs: radeonkms, i915kms
NICs: if_em, if_igb, if_bnxt
This metadata isn't used yet, but it will be handy to have later to
implement automatic module loading.
Reviewed by: imp, mmacy
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D12488
If the packet is smaller than MTU, disable the TSO flags.
Move TCP header parsing inside the IS_TSO?() test.
Add a new IFLIB_NEED_ZERO_CSUM flag to indicate the checksums need to be zeroed before TX.
Reviewed by: sbruno
Approved by: sbruno (mentor)
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D12442
This was really too big of a commit even if everything worked, but there
are multiple new issues introduced in the one huge commit, so it's not
worth keeping this until it's fixed.
I'll work on splitting this up into logical chunks and introduce them one
at a time over the next week or two.
Approved by: sbruno (mentor)
Sponsored by: Limelight Networks
by Matt Macy as well as other changes which he has accepted via pull
request to his github repo at https://github.com/mattmacy/networking/
This should bring -CURRENT and the github repo into close enough sync to
allow small feature branches rather than a large chain of interdependant
patches being developed out of tree. The reset of the synchronization
should be able to be completed on github by splitting the remaining
changes that are not yet ready into short feature branches for later
review as smaller commits.
Here is a summary of changes included in this patch:
1) More checks when INVARIANTS are enabled for eariler problem
detection
2) Group Task Queue cleanups
- Fix use of duplicate shortdesc for gtaskqueue malloc type.
Some interfaces such as memguard(9) use the short description to
identify malloc types, so duplicates should be avoided.
3) Allow gtaskqueues to use ithreads in addition to taskqueues
- In some cases, this can improve performance
4) Better logging when taskqgroup_attach*() fails to set interrupt
affinity.
5) Do not start gtaskqueues until they're needed
6) Have mp_ring enqueue function enter the ABDICATED rather than BUSY
state. This moves the TX to the gtaskq and allows processing to
continue faster as well as make TX batching more likely.
7) Add an ift_txd_errata function to struct if_txrx. This allows
drivers to inspect/modify mbufs before transmission.
8) Add a new IFLIB_NEED_ZERO_CSUM for drivers to indicate they need
checksums zeroed for checksum offload to work. This avoids modifying
packet data in the TX path when possible.
9) Use ithreads for iflib I/O instead of taskqueues
10) Clean up ioctl and support async ioctl functions
11) Prefetch two cachlines from each mbuf instead of one up to 128B. We
often need to parse packet header info beyond 64B.
12) Fix potential memory corruption due to fence post error in
bit_nclear() usage.
13) Improved hang detection and handling
14) If the packet is smaller than MTU, disable the TSO flags.
This avoids extra packet parsing when not needed.
15) Move TCP header parsing inside the IS_TSO?() test.
This avoids extra packet parsing when not needed.
16) Pass chains of mbufs that are not consumed by lro to if_input()
rather call if_input() for each mbuf.
17) Re-arrange packet header loads to get as much work as possible done
before a cache stall.
18) Lock the context when calling IFDI_ATTACH_PRE()/IFDI_ATTACH_POST()/
IFDI_DETACH();
19) Attempt to distribute RX/TX tasks across cores more sensibly,
especially when RX and TX share an interrupt. RX will attempt to
take the first threads on a core, and TX will attempt to take
successive threads.
20) Allow iflib_softirq_alloc_generic() to request affinity to the same
cpus an interrupt has affinity with. This allows TX queues to
ensure they are serviced by the socket the device is on.
21) Add new iflib sysctls to net.iflib:
- timer_int - interval at which to run per-queue timers in ticks
- force_busdma
22) Add new per-device iflib sysctls to dev.X.Y.iflib
- rx_budget allows tuning the batch size on the RX path
- watchdog_events Count of watchdog events seen since load
23) Fix error where netmap_rxq_init() could get called before
IFDI_INIT()
24) e1000: Fixed version of r323008: post-cold sleep instead of DELAY
when waiting for firmware
- After interrupts are enabled, convert all waits to sleeps
- Eliminates e1000 software/firmware synchronization busy waits after
startup
25) e1000: Remove special case for budget=1 in em_txrx.c
- Premature optimization which may actually be incorrect with
multi-segment packets
26) e1000: Split out TX interrupt rather than share an interrupt for
RX and TX.
- Allows better performance by keeping RX and TX paths separate
27) e1000: Separate igb from em code where suitable
Much easier to understand separate functions and "if (is_igb)" than
previous tests like "if (reg_icr & (E1000_ICR_RXSEQ | E1000_ICR_LSC))"
#blamebruno
Reviewed by: sbruno
Approved by: sbruno (mentor)
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D12235
Do not use malloc(M_NOWAIT), wait is possible there, and the malloc
failures where not checked. Do not forget to free malloced memory.
Reported and tested by: pho
Approved by: sbruno
Sponsored by: The FreeBSD Foundation
Post-cold sleep instead of DELAY when waiting for firmware.
Convert softc mutex to an SX lock. Change all waits to sleeps
once interrupts are enabled (and it is safe to sleep).
Submitted by: Matt Macy <matt@mattmacy.io>
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D12101
according to the enabled interface capability bits. Also remove
some dead code, which tried to preserve already set contents of
E1000_WUC while that register is completely overwritten shortly
after in all cases.
recieve descriptors for the igb(4) class of devices. This will
allow a better definition for maximum going forward. Some igb(4)
devices support more than the default 4K.
Reported by: Jason (j@nitrology.com)
Sponsored by: Limelight Networks
- restore newer code for vf, i350, i210, i211
- restore dmac init code for i354 and i350
- restore WUC/WUFC update
- check for igb mac type before attempting trying to assert
a media changed event.
- handle link events for igb(4) and em(4) devices differently
and appropriately for their respective model types.
Submitted by: Matt Macy <mmacy@mattmacy.io>
Sponsored by: Limelight Networks
Two blocks in e1000_ich8lan.c are misaligned, causing noise with some
compilers (gcc 6).
Reviewed by: imp, erj
Differential Revision: https://reviews.freebsd.org/D10741
so that we can use it in iflib to detect pause frames.
The igb(4) driver definitely used to use this in its old timer function and
I see no reason to restrict it to that driver only.
Sponsored by: Limelight Networks
- unconditionally enable BUS_DMA on non-x86 architectures
- speed up rxd zeroing via customized function
- support out of order updates to rxd's
- add prefetching to hardware descriptor rings
- only prefetch on 10G or faster hardware
- add seperate tx queue intr function
- preliminary rework of NETMAP interfaces, WIP
Submitted by: Matt Macy <mmacy@nextbsd.org>
Sponsored by: Limelight Networks
Do no write to PBA register on igb(4) devices unless we need
to make adjustments for the 82575 and jumbo frames.
Remove redundant LPE/~LPE assignments.
Move e1000_lv_jumbo_workaround_ich8lan() invokcation into a block
so that its not executed in the igb case.
Move em(4) class assignments of RCTL values to its own code block.
Adjust a few direct accesses of ifp->mtu to use accessor functions.
PR: 216734
Submitted by: Kaho Toshikazu <kaho@elam.kais.kyoto-u.ac.jp>
em_local_timer() executions during normal operation and was very likely
to cause a lock up on igb(4) devices.
Submitted by: Matt Macy (mmacy@nextbsd.org)
Reported by: jtl
Reviewed by: gallatin
Sponsored by: Limelight Networks & Netflix
structure:
if_gethwtsomax(), if_sethwtsomax() - if_hw_tsomax
if_gethwtsomaxsegcount(), if_sethwtsomaxsegcount() - if_hw_tsomaxsegcount
if_gethwtsomaxsegsize(), if_sethwtsomaxsegsize() - if_hw_tsomaxsegsize
Update em and vnic drivers which had already been coverted to use accessor
functions for the other ifnet structure members.
Reviewed by: erj
Approved by: sjg (mentor)
Obtained from: Juniper Networks, Inc.
Differential Revision: https://reviews.freebsd.org/D8544
Add internal tracking of smp startup status to reliably figure out
what methods are to be used to get gtaskqueue up and running.
e1000:
Calculating this pointer gives undefined behaviour when (last == -1)
(it is before the buffer). The pointer is always followed. Panics
occurred when it points to an unmapped page. Otherwise, the pointed-to
garbage tends to not have the E1000_TXD_STAT_DD bit set in it, so in the
broken case the loop was usually null and the function just returned, and
this was acidentally correct.
Submitted by: bde
Reported by: Matt Macy <mmacy@nextbsd.org>
Add internal tracking of smp startup status to reliably figure out
what methods are to be used to get gtaskqueue up and running.
e1000:
Calculating this pointer gives undefined behaviour when (last == -1)
(it is before the buffer). The pointer is always followed. Panics
occurred when it points to an unmapped page. Otherwise, the pointed-to
garbage tends to not have the E1000_TXD_STAT_DD bit set in it, so in the
broken case the loop was usually null and the function just returned, and
this was acidentally correct.
Submitted by: bde
Reviewed by: Matt Macy <mmacy@nextbsd.org>
