<sys/endian.h>. It is needed to cross-build sparc64 on
RELENG_4 and to build sparc64 on say 5.0-DP1 (on systems
without <sys/endian.h>). This will be revisited when we
create RELENG_5.
Spotted by: make universe
One of the vnodes is on different mount and is possibly on a different
kind of filesystem; treating it as an smbfs vnode then writing to it
will probably corrupt it.
PR: 48381
MFC after: 1 month
group number properly based on the board id. Perform dummy reads of
registers after writing to flush the hardware write buffers.
This gets the soon to be committed zs attachment working.
Some DVcam(ex. Panasonic NV-DS1 DV camcorder) doesn't seems to set
this bit even if it's for PAL. Fix the DSF bit for such cases so that
we can send back the stream to the DVcam without problem.
Problem Reported by: Richard Tobin <richard@cogsci.ed.ac.uk>
- Make the number of bulkxfer packets(NPACKET_T) and the number of packets
write at once(TNBUF) to be different values.
I observe some block noise for large TNBUF.
- Show the detection of NTSC or PAL.
- Pad with 0xff rather than 0x00 for broken frames.
- Bzero hdr[0].
- Remove unused code.
for the sorts of errors we run into[1]. This also gives us room to put in a
vaguely appropriate casts to silence warnings since our compiler doesn't like
when we compare ssize_t to size_t[2]. Add a cast in sblock.c[3] to silence
a warning because of signed vs. size_t hell (again). Clean up nearby
excessive parenthemutilation[4].
Reviewed by: bde [2] [3]
Suggested by: bde, many [1]
Submitted by: bde [4]
An aside about [4], bde notes that we do not check for a negative value for
the fs bsize. I'm nto going to do that in every situation we use it, one must
expect a reasonable program to pass down reasonable values. Some foot shooting
protection I will tolerate, some I will not. Also he suggests some possible
conditional improvements there, which I may take to heart.
PS: For me at least, this is now WARNS=5 clean...
Minor CIS resource allocation code cleanup
Remove some fairly useless debug writes.
This finishes the work to move as much cardbus code as possible into
pci. We wind up removing 800-odd lines from cardbus.c: we go from
1285 to 400 lines.
Reviewed by: mdodd
bus_dmamap_load() it.
- Make it so reusing mbufs when we can't allocate (or map) new ones
actually works. We were previously trying to reuse a mbuf which
was already bus_dmamap_unload()'ed.
Reviewed by: silby
libdes, and functionally close enough so that we created symlinks
(libdes -> libcrypto) to help older applications. With the import of
OpenSSL 0.9.7, this is no longer true and we no longer install these
symlinks. However, systems that are upgraded may have these symlinks,
which could cause non-obvious breakage at build-time. Therefore, blow
any old symlinks away in the `afterinstall' target.
aacp is a passthrough driver for aac, but it seems that aac kernel
module has a feature provided by aacp; so it can be removed safely.
_KPOSIX_PRIORITY_SCHEDULING provides P1003.1B realtime extension.
However, in an installation phase, it seems that it helps a little
for us, so we can remove this option from a kernel for floppy installation.
I know _KPOSIX_PRIORITY_SCHEDULING option is defined in other architecture.
However, I don't touch them at this time; I can't test it.
Anyway here's result.
Before diet:
-rwxr-xr-x 1 matusita matusita 4849883 Feb 18 11:22 kernel
-rwxr-xr-x 1 matusita matusita 1727143 Feb 18 11:47 kernel.kgz
After diet:
-rwxr-xr-x 1 matusita matusita 4840949 Feb 18 09:48 kernel
-rwxr-xr-x 1 matusita matusita 1723911 Feb 18 11:47 kernel.kgz
We've got extra 3232 bytes (using 5-current as of Feb/18/2003).
In cooperation with: jwd (test ISO installation image)
Boot tested on: several PCs around myself
Installation tested on: VMware Workstation e.x.p build-4099
