- Pacific/Apia will have DST on 2 April instead of 3 April in 2011.
- Turkye will go to DST on 28 April instead of 27 April in 2011.
- Cuba will go to DST on 20 April in 2011.
Obtained from: ftp://elsie.nci.nih.gov/pub/
- Pacific/Apia will have DST on 2 April instead of 3 April in 2011.
- Turkye will go to DST on 28 April instead of 27 April in 2011.
- Cuba will go to DST on 20 April in 2011.
Obtained from: ftp://elsie.nci.nih.gov/pub/
The compiler will truncate the 32-bit return value of mv_gpio_value_get()
to match the 8-bit return value of mv_gpio_in(). A conditional expression
is used to have mv_gpio_in() always return 0 or 1 instead.
Calling rfork_thread(3) does not interoperate with pthreads and global state
is not properly protected.
Remove the BUGS section suggesting LinuxThreads entirely. With the current
pthread library libthr, all threads are kernel-level entities so there seems
little reason to use LinuxThreads.
soon as possible for stack protector. However, dummy timecounter does not
have enough entropy and we don't need to sacrifice Pentium class and later.
Pointed out by: Maxim Dounin (mdounin at mdounin dot ru)
The compiler seems to assume it's a 32-bit integral and rounding to the
page size using the standard expression (((u_long)(x) + mask) & ~mask),
results in a 32-bit value. Dropping the 'U' suffix is enough to have the
compiler treat the expression as a 64-bit integral.
handlers.
o Put the IVT in its own section and keep the supporting code close.
o Make sure the VHPT is sized so that it can be mapped using a single
translation.
o Map the PAL code and VHPT with a translation that has the right size.
Assume the platform has a PAL code size that can be mapped with a
single translations.
o Pass the pointer to the bootinfo structure as an argument to ia64_init().
o Get rid of LOG2_ID_PAGE_SIZE and IA64_ID_PAGE_SIZE. It was used to map
the regions 6 & 7 and was as large as possible. The problem is that we
can't support memory attributes easily if the granuratity is not a page.
We need to support memory attributes because the new USB stack violates
the BUS_DMA(9) interface.
o Update some comments...
NOTE: this is broken for SMP kernels, because the AP startup code hasn't
been updated yet.
can be put right at the front when put in its own section. This makes
sure that when the loader can only map a relatively small part of the
PBVM, the IVT and the startup code is wired.
This does a few things in particular:
* Abstracts out the gain control settings into a separate function;
* Configure antenna diversity, LNA and antenna gain parameters;
* Configure ob/db entries - the later v4k EEPROM modal revisions have
multiple OB/DB parameters which are used for some form of
calibration. Although the radio does have defaults for each,
the EEPROM can override them.
This resolves the AR2427 related issues I've been seeing and makes
it stable at all 11g rates for both TX and RX.
sizes are not supported.
o Map the PBVM page table.
o Map the PBVM using the largest possible power of 2 that is less than
the amount of PBVM used and round down to a valid page size. Note
that the current kernel is between 8MB and 16MB in size, which would
mean that 8MB would be the typical size of the mapping, if only 8MB
wasn't an invalid page size. In practice, we end up mapping the first
4MB of PBVM in most cases.
These already worked: $# ${#} ${##} ${#-} ${#?}
These now work as well: ${#+word} ${#-word} ${##word} ${#%word}
There is an ambiguity in the standard with ${#?}: it could be the length of
$? or it could be $# giving an error in the (impossible) case that it is not
set. We continue to use the former interpretation as it seems more useful.
in the archive instead of spinning through it to get a file count for the
progress bar. This speeds up installation a lot on systems with slow
CD drives.
