GEOM's stripeoffset overflows at 4 gigabyte margin (2^32)
because of its u_int type. This leads to incorrect data in the output
generated by "sysctl kern.geom.confxml" command, "graid list" etc.
when GEOM array has volumes larger than 4G, for example.
This change does not affect ABI but changes KBI. No MFC planned.
Differential Revision: https://reviews.freebsd.org/D13426
r287023 and r334450 added build option mechanisms to permanently disable
spammy and/or low quality entropy sources.
Follow-up those changes by updating the 'enabled' sources mask to match.
When sources are compile-time disabled, represent them as disabled in the
source mask, and prevent users from modifying that, like pure sources.
(Modifying the mask bit would have no effect, but users might think it did
if it was not prevented.)
Mostly a cosmetic change.
Reviewed by: markm
Approved by: secteam (gordon)
X-MFC-With: 334450
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D17252
Previously, route returned 1 in case of error properly signalling failure
but "route -q" it returned 0 for same case. Fix it.
PR: 186333
MFC after: 1 month
Kernel part of ipfw does not support and ignores rules other than
"pass", "deny" and dummynet-related for layer-2 (ethernet frames).
Others are processed as "pass".
Make it support ngtee/netgraph rules just like they are supported
for IP packets. For example, this allows us to mirror some frames
selectively to another interface for delivery to remote network analyzer
over RSPAN vlan. Assuming ng_ipfw(4) netgraph node has a hook named "900"
attached to "lower" hook of vlan900's ng_ether(4) node, that would be
as simple as:
ipfw add ngtee 900 ip from any to 8.8.8.8 layer2 out xmit igb0
PR: 213452
MFC after: 1 month
Tested-by: Fyodor Ustinov <ufm@ufm.su>
action to distribute traffic using the half of the VI's RSS indirection
table.
The value specified should either be the start of the VI's RSS slice
(available at dev.<ifname>.<inst>.rss_base since r339700) or the
midpoint (rss_base + rss_size/2). The traffic that hits the filter will
use the first or second half of the indirection table respectively.
The indirection table can be populated in different ways to achieve
different kinds of traffic/load distributions. For example, r339749
allows a netmap interface to have half the rx queues in the first half
of the table and the rest in the other.
Sponsored by: Chelsio Communications
If module_blacklist isn't specified, we have an empty blacklist; effectively
the same as if module_blacklist="" were specified in loader.conf(5).
This was reported when switching to a BE that predated the module_blacklist
introduction, but the problem is valid all the same and likely to be tripped
over in other scenarios.
Reported by: bwidawsk
MFC after: 3 days
In r332361 and r333439, two new parameters were added to geli attach
verb using gctl_get_paraml, which requires the value to be present.
This would prevent old geli(8) binary from attaching geli(4) device
as they have no knowledge about the new parameters.
Restore backward compatibility by treating the absense of these two
values as seeing the default value supplied by userland.
PR: 232595
Reviewed by: oshogbo
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D17680
Pointer math to find the size in bytes only works with char types.
Use correct pointer math to determine if we have enough of a header to
look at or not.
MFC After: 3 days
X-MFX-With: r339800
Noticed by: jhb@
Sponsored by: Netflix, Inc
its length. Some BIOSes pad the length of the device path to an even
amount. When we had a device path that was somehow an odd length, we'd
wind up having 1 byte left that we were bogusly interpreting as a full
device path. We'd then dereference 2 bytes into that to get a length
of the node, which had undefined (and quite undesired) effects.
Sponsored by: Netflix, Inc
MFC After: 3 days
So
./efivar --fromfile Boot0001.bin --print --load-option
will take the value from Boot0001.bin file and then decode it as if it
were a load-option. This is useful for debugging handling of such
variables that may be hanging the boot for some people.
Sponsored by: Netflix, Inc
They only make sense in the context of directory ACLs, and attempting
to set them on regular files results in errors, causing a recursive
setfacl invocation to abort.
This is derived from patches by Shawn Webb <shawn.webb@hardenedbsd.org>
and Mitchell Horne <mhorne063@gmail.com>.
PR: 155163
MFC after: 2 weeks
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D15061
Set debug.fail_point.random_fortuna_pre_read=return(1) and
debug.fail_point.random_fortuna_seeded=return(1) to return to unseeded
status (sort of). See the Differential URL for more detail.
The goal is to reproduce e.g. Lev's recent CURRENT report[1] about failing
newfs arc4random(3) usage (fixed in r338542).
No functional change when failpoints are not set.
[1]: https://lists.freebsd.org/pipermail/freebsd-current/2018-September/071067.html
Reported by: lev
Reviewed by: delphij, markm
Approved by: secteam (delphij)
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D17047
'i' counts the number of pools included in the array 's'. Passing 'i+1' to
reseed_internal() as the number of blocks in 's' is a bogus overrun of the
initialized portion of 's' -- technically UB.
I found this via code inspection, referencing §9.5.2 "Pools" of the Fortuna
chapter, but I would expect Coverity to notice the same issue.
Unfortunately, it doesn't appear to.
Reviewed by: markm
Approved by: secteam (gordon)
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D16985
Noticed this investigating Fortuna. Remove useless duplicate stack copies
of sensitive contents when possible, or if not possible, be sure to zero
them out when we're finished.
Approved by: secteam (gordon)
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D16935
Some of the poll code used 'fds' and some used 'ufds' to refer to the
uap->fds userspace pointer that was passed around to subroutines. Some of
the poll code used 'fds' to refer to the kernel memory pollfd arrays, which
seemed unnecessarily confusing.
Unify on 'ufds' to refer to the userspace pollfd array.
Additionally, 'bits' is not an accurate description of the kernel pollfd
array in kern_poll, so rename that to 'kfds'. Finally, clean up some logic
with mallocarray() and nitems().
No functional change.
Reviewed by: markj
Differential Revision: https://reviews.freebsd.org/D17670
Start with a short summary and cover the options in a standard list style.
Organize sections by common focus and prioritize more useful information
closer to the top.
Flesh out authors, history, caveats, and security considerations sections.
Reviewed by: markj, eadler (previous version)
Differential Revision: https://reviews.freebsd.org/D17679
The premise of dumpon -k foo.pem is that dump contents will be confidential
except to anyone holding the corresponding RSA private key.
This guarantee breaks down when weak RSA keys are used. Small RSA keys
(e.g. 512 bits) can be broken on a single personal computer in tractible
time. Marginal RSA keys (768 bits) can be broken by EC2 and a few dollars.
Even 1024 bit keys can probably be broken by sophisticated and wealthy
attackers.
NIST SP800-57 (2016) recommends a minimum of 2048 bit RSA keys, and
estimates this provides 112 bits of security.
It would also be good to protect users from weak values of 'e' (i.e., 3) and
perhaps sanity check that their public key .pem does not accidentally
contain their private key as well. These considerations are left as future
work.
Reviewed by: markj, darius AT dons.net.au (previous version)
Discussed with: bjk
Differential Revision: https://reviews.freebsd.org/D17678
The output of "ngctl ls -l" is hard to read. To make it easier, add a blank
line after each listed item much how traditional "ls -l" does when listing
the contents of multiple directories.
Sponsored by: Smule, Inc.
ioctl(2) commands only have meaning in the context of a file descriptor
so translating them in the syscall layer is incorrect.
The new handler users an accessor to retrieve/construct a pointer from
the last member of the passed structure and relies on type punning to
access the other member which requires no translation.
Unlike r339174 this change supports both places FIODGNAME is handled.
Reviewed by: kib
Obtained from: CheriBSD
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D17475
Add a counter for the LBAs, Ranges and hardware commands so that we
can provide additional color to the statistics we provide to vendors.
Sponsored by: Netflix, Inc
This driver was marked as gone in 12. We're at 13 now. Remove it.
Data from nycbug's dmesg cache shows only one potential user,
suggesting it never was used much. However, even though this device
has been obsolete for 15 years at least, sys/joystick.h is included in
a number of graphics packages still, so that remains. A full exprun
is needed before that can be removed.
RelNotes: yes
Differential Revision: https://reviews.freebsd.org/D17629
At least one NVMe drive has a bug that makeing the Command Time Out
PCIe feature unreliable. The workaround is to disable this
feature. The driver wouldn't deal correctly with a timeout anyway.
Only do this for drives that are known bad.
Sponsored by: Netflix, Inc
Differential Revision: https://reviews.freebsd.org/D17708
modify l3 pte after we loaded old value and before we stored new value.
o Preset A(accessed), D(dirty) bits for kernel mappings.
Reported by: kib
Reviewed by: markj
Discussed with: jhb
Sponsored by: DARPA, AFRL
I held the mistaken belief this was completely unused. While the
driver is unused and likely not relevant for a long time,
sys/joystick.h lives on in maybe half a dozen ports, even though
hardware to use it hasn't been widely used in maybe 15 years.
