pages which pass a NULL virtual address. If the BUS_DMA_KEEP_PG_OFFSET
flag is set, use the physical address to compute the page offset
instead. The physical address should always be valid when adding
bounce pages and should contain the same page offset like the virtual
address.
Submitted by: Svatopluk Kraus <onwahe@gmail.com>
MFC after: 1 week
Reviewed by: jhb@
This supports e500v1, e500v2, and e500mc. Tested only on e500v2, but the
performance counters are identical across all, with e500mc having some
additional events.
Relnotes: Yes
and export them to userland.
- Define __HAVE_REG32 on platforms that define a reg32 structure and check
for this in <sys/procfs.h> to control when to export prstatus32, etc.
- Add prstatus32_t and prpsinfo32_t typedefs for the 32-bit structures.
libbfd looks for these types, and having them fixes 'gcore' in gdb of a
32-bit process on a 64-bit platform.
- Use the structure definitions from <sys/procfs.h> in gcore's elf32 core
dump code instead of duplicating the definitions.
Differential Revision: https://reviews.freebsd.org/D2142
Reviewed by: kib, nathanw (powerpc bits)
MFC after: 1 week
Summary:
Book-E and AIM trap.c are almost identical, except for a few bits. This is step
1 in unifying them.
This also renumbers EXC_DEBUG, to not conflict with AIM vector numbers. Since
this is the only one thus far that is used in the switch statement in trap(),
it's the only one renumbered. If others get added to the switch, which conflict
with AIM numbers, they should also be renumbered.
Reviewers: #powerpc, marcel, nwhitehorn
Reviewed By: marcel
Subscribers: imp
Differential Revision: https://reviews.freebsd.org/D2215
A couple of internal functions used by malloc(9) and uma truncated
a size_t down to an int. This could cause any number of issues
(e.g. indefinite sleeps, memory corruption) if any kernel
subsystem tried to allocate 2GB or more through malloc. zfs would
attempt such an allocation when run on a system with 2TB or more
of RAM.
Note to self: When this is MFCed, sparc64 needs the same fix.
Differential revision: https://reviews.freebsd.org/D2106
Reviewed by: kib
Reported by: Michael Fuckner <michael@fuckner.net>
Tested by: Michael Fuckner <michael@fuckner.net>
MFC after: 2 weeks
writing approximately never (< 0.00000001% under heavy VM load, and it can
go for months without ever being acquired in normal operation). This
provides a 10% (2-minute) improvement in wall clock time for make -j32
buildworld on a 4-core 32-thread POWER8.
packets and does not schedule interrupts for any packets currently
enqueued. Close two races where enqueued packets may not ever trigger
interrupts. The first of these, at adapter initialization time, was
especially severe since a rush of enqueued packets could actually fill
the receive buffer completely, stalling the interface forever.
MFC after: 2 weeks
This is not complete yet: the gem(4) interface on my laptop seems to
disappear from the PCI bus as a result of quiescing Open Firmware in the
boot loader.
The vtophys() function is used to get the physical page address for
the virtually allocated frame buffers when a physically continuous
memory area is not available. This change also allows removing the
masking of the FB_FLAG_NOMMAP flag in the PS3 syscons driver.
The FB and VT drivers were tested using X.org/xf86-video-scfb and
syscons.
executables. The goal here, not yet accomplished, is to let the e500 kernel
run under QEMU by setting KERNBASE to something that fits in low memory and
then having the kernel relocate itself at runtime.
have the same meaning and occupy the same memory address in the trapframe
courtesy of union. Avoid some pointless #ifdef by spelling them both 'DAR'
in the trapframe.
Fix an extremely subtle concurrency bug triggered by running on 32-thread
POWER8 systems. During thread switch, there was a very small window when
the stack pointer was set to the stack pointer of the outgoing thread, but
after the lock on that thread had already been released.
If, during that window, the outgoing thread were rescheduled on another CPU
and begin execution and an exception were taken on the original CPU, the
trap handler and the outgoing thread would simultaneously execute on the same
stack, causing memory corruption. Fix this by making sure to release the
old thread only after cpu_switch() is done with its stack.
MFC after: 2 weeks
this change is to improve concurrency:
- Drop global state stored in the shadow overflow page table (and all other
global state)
- Remove all global locks
- Use per-PTE lock bits to allow parallel page insertion
- Reconstruct state when requested for evicted PTEs instead of buffering
it during overflow
This drops total wall time for make buildworld on a 32-thread POWER8 system
by a factor of two and system time by a factor of three, providing performance
20% better than similarly clocked Core i7 Xeons per-core. Performance on
smaller SMP systems, where PMAP lock contention was not as much of an issue,
is nearly unchanged.
Tested on: POWER8, POWER5+, G5 UP, G5 SMP (64-bit and 32-bit kernels)
Merged from: user/nwhitehorn/ppc64-pmap-rework
Looked over by: jhibbits, andreast
MFC after: 3 months
Relnotes: yes
Sponsored by: FreeBSD Foundation
and POWER8. This instruction set unifies the 32 64-bit scalar floating
point registers with the 32 128-bit vector registers into a single bank
of 64 128-bit registers. Kernel support mostly amounts to saving and
restoring the wider version of the floating point registers and making
sure that both scalar FP and vector registers are enabled once a VSX
instruction is executed. get_mcontext() and friends currently cannot
see the high bits, which will require a little more work.
As the system compiler (GCC 4.2) does not support VSX, making use of this
from userland requires either newer GCC or clang.
Relnotes: yes
Sponsored by: FreeBSD Foundation
Summary:
Currently, fan control is linear between the target temperature and max
temperature, which is far from ideal. This changes it to be proportional to the
distance between the current temperature and the two endpoints (target and max
temp). This also adds a hysteresis, so that fans keep going when the
temperature drops, for about 10 seconds, before slowing down.
Reviewers: nwhitehorn
Reviewed By: nwhitehorn
Differential Revision: https://reviews.freebsd.org/D1549
MFC after: 3 weeks
Some ATI-based PowerBooks use the string 'mnca' in the backlight controller
device tree entry, so account for this and don't use nVidia when it's not an
nVidia device.
MFC after: 3 weeks
This port failed to gain traction and probably only a couple Wii consoles
ran FreeBSD all the way to single user mode with an md(4). IPC
support was never implemented, so it was impossible to use any peripheral
Any further development, if any, will happen at https://github.com/rpaulo/wii.
Discussed with: nathanw (a long time ago), jhibbits
hypervisor. This prevents an infinite loop where processes with evicted
pages would page fault forever when PMAP decided the evicted pages on
which the process was faulting was actually present and did not need to
be restored.
Found while building LLVM with make -j32.
Sponsored by: FreeBSD Foundation
POWER8 systems. During thread switch, there was a very small window when
the stack pointer was set to the stack pointer of the outgoing thread, but
after the lock on that thread had already been released.
If, during that window, the outgoing thread were rescheduled on another CPU
and begin execution and an exception were taken on the original CPU, the
trap handler and the outgoing thread would simultaneously execute on the same
stack, causing memory corruption. Fix this by making sure to release the
old thread only after cpu_switch() is done with its stack.
MFC after: 2 weeks
Sponsored by: FreeBSD Foundation
every possible trap address by default. This also makes sure the kernel
notices (and panics at) traps from newer CPUs that the kernel was not
expecting rather than executing gibberish memory.
that we (a) get the correct large page size to provide to pmap and (b)
we can alert the user if running under incorrectly-configured PowerKVM
on POWER7 and POWER8 systems.
MFC after: 1 week
