Adrian Chadd 6322256b83 Part #2 of the TX chainmask changes: ... * Remove ar5416UpdateChainmasks(); * Remove the TX chainmask override code from the ar5416 TX descriptor setup routines; * Write a driver method to calculate the current chainmask based on the operating mode and update the driver state; * Call the HAL chainmask method before calling ath_hal_reset(); * Use the currently configured chainmask in the TX descriptors rather than the hardware TX chainmasks. Tested: * AR5416, STA/AP mode - legacy and 11n modes		2013-02-25 22:45:02 +00:00
..
ar2133.c	Implement the quarter rate fractional channel programming for the	2012-10-04 15:42:45 +00:00
ar5416_ani.c	Track the last ANI TX/RX sample correctly.	2012-09-27 06:05:54 +00:00
ar5416_attach.c	Begin adding support to explicitly set the current chainmask.	2013-02-25 22:42:43 +00:00
ar5416_beacon.c	The AR5212 setup path (also used by the AR5416 code) configures a	2011-09-28 03:03:23 +00:00
ar5416_btcoex.c	Methodise the BT diversity configuration function; so the AR9285	2012-12-04 00:02:46 +00:00
ar5416_btcoex.h	Remove duplicate entries.	2012-06-27 03:00:29 +00:00
ar5416_cal_adcdc.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_cal_adcgain.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_cal_iq.c	Fix the calibration logic to correctly clamp the calculated coefficient.	2010-08-14 15:28:15 +00:00
ar5416_cal.c	Bump this up to where it used to be.	2011-11-09 23:28:47 +00:00
ar5416_cal.h	Introduce methods for the initial calibration and the new PA calibration	2011-03-11 11:35:36 +00:00
ar5416_eeprom.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_gpio.c	Bring over the initial 802.11n bluetooth coexistence support code.	2012-06-26 22:16:53 +00:00
ar5416_interrupts.c	If any of the TX queues have underrun reporting enabled, enable	2013-02-20 11:24:11 +00:00
ar5416_keycache.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_misc.c	Begin adding support to explicitly set the current chainmask.	2013-02-25 22:42:43 +00:00
ar5416_phy.c	Modify the AR5416 11na rate table to use 24mb OFDM 11a for control traffic,	2011-02-21 05:10:34 +00:00
ar5416_power.c	Both linux ath9k and the reference driver initialises the PLL here	2012-04-14 04:40:11 +00:00
ar5416_radar.c	Implement an API to fetch the default DFS parameters for the given chip.	2012-08-24 01:29:46 +00:00
ar5416_recv.c	Fix a subtle corner case surrounding the handling of OFDM restart along	2012-06-27 05:23:33 +00:00
ar5416_reset.c	Part #2 of the TX chainmask changes:	2013-02-25 22:45:02 +00:00
ar5416_spectral.c	Fix the short repeat option code to not flip the option to 0 when	2013-01-02 03:56:20 +00:00
ar5416_xmit.c	Part #2 of the TX chainmask changes:	2013-02-25 22:45:02 +00:00
ar5416.h	Begin adding support to explicitly set the current chainmask.	2013-02-25 22:42:43 +00:00
ar5416.ini	Fix the addac serial load register write for AR5416.	2011-09-06 10:49:05 +00:00
ar5416desc.h	I'm not sure why ah_desc.h was required here, but it doesn't _need_	2012-11-16 20:04:45 +00:00
ar5416phy.h	Bring over the basic spectral scan framework code from Qualcomm Atheros.	2013-01-02 00:38:01 +00:00
ar5416reg.h	Bring over the basic spectral scan framework code from Qualcomm Atheros.	2013-01-02 00:38:01 +00:00