619aca846f
connectivity interact with the net80211 stack. Historical background: originally wireless devices created an interface, just like Ethernet devices do. Name of an interface matched the name of the driver that created. Later, wlan(4) layer was introduced, and the wlanX interfaces become the actual interface, leaving original ones as "a parent interface" of wlanX. Kernelwise, the KPI between net80211 layer and a driver became a mix of methods that pass a pointer to struct ifnet as identifier and methods that pass pointer to struct ieee80211com. From user point of view, the parent interface just hangs on in the ifconfig list, and user can't do anything useful with it. Now, the struct ifnet goes away. The struct ieee80211com is the only KPI between a device driver and net80211. Details: - The struct ieee80211com is embedded into drivers softc. - Packets are sent via new ic_transmit method, which is very much like the previous if_transmit. - Bringing parent up/down is done via new ic_parent method, which notifies driver about any changes: number of wlan(4) interfaces, number of them in promisc or allmulti state. - Device specific ioctls (if any) are received on new ic_ioctl method. - Packets/errors accounting are done by the stack. In certain cases, when driver experiences errors and can not attribute them to any specific interface, driver updates ic_oerrors or ic_ierrors counters. Details on interface configuration with new world order: - A sequence of commands needed to bring up wireless DOESN"T change. - /etc/rc.conf parameters DON'T change. - List of devices that can be used to create wlan(4) interfaces is now provided by net.wlan.devices sysctl. Most drivers in this change were converted by me, except of wpi(4), that was done by Andriy Voskoboinyk. Big thanks to Kevin Lo for testing changes to at least 8 drivers. Thanks to pluknet@, Oliver Hartmann, Olivier Cochard, gjb@, mmoll@, op@ and lev@, who also participated in testing. Reviewed by: adrian Sponsored by: Netflix Sponsored by: Nginx, Inc.
123 lines
4.9 KiB
C
123 lines
4.9 KiB
C
/*-
|
|
* Copyright (c) 2002-2009 Sam Leffler, Errno Consulting
|
|
* All rights reserved.
|
|
*
|
|
* Redistribution and use in source and binary forms, with or without
|
|
* modification, are permitted provided that the following conditions
|
|
* are met:
|
|
* 1. Redistributions of source code must retain the above copyright
|
|
* notice, this list of conditions and the following disclaimer,
|
|
* without modification.
|
|
* 2. Redistributions in binary form must reproduce at minimum a disclaimer
|
|
* similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
|
|
* redistribution must be conditioned upon including a substantially
|
|
* similar Disclaimer requirement for further binary redistribution.
|
|
*
|
|
* NO WARRANTY
|
|
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
|
|
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
|
|
* LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
|
|
* AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
|
|
* THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
|
|
* OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
|
|
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
|
|
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
|
|
* IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
|
|
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
|
|
* THE POSSIBILITY OF SUCH DAMAGES.
|
|
*
|
|
* $FreeBSD$
|
|
*/
|
|
#ifndef __IF_ATH_DEBUG_H__
|
|
#define __IF_ATH_DEBUG_H__
|
|
|
|
#ifdef ATH_DEBUG
|
|
|
|
enum {
|
|
ATH_DEBUG_XMIT = 0x000000001ULL, /* basic xmit operation */
|
|
ATH_DEBUG_XMIT_DESC = 0x000000002ULL, /* xmit descriptors */
|
|
ATH_DEBUG_RECV = 0x000000004ULL, /* basic recv operation */
|
|
ATH_DEBUG_RECV_DESC = 0x000000008ULL, /* recv descriptors */
|
|
ATH_DEBUG_RATE = 0x000000010ULL, /* rate control */
|
|
ATH_DEBUG_RESET = 0x000000020ULL, /* reset processing */
|
|
ATH_DEBUG_MODE = 0x000000040ULL, /* mode init/setup */
|
|
ATH_DEBUG_BEACON = 0x000000080ULL, /* beacon handling */
|
|
ATH_DEBUG_WATCHDOG = 0x000000100ULL, /* watchdog timeout */
|
|
ATH_DEBUG_INTR = 0x000001000ULL, /* ISR */
|
|
ATH_DEBUG_TX_PROC = 0x000002000ULL, /* tx ISR proc */
|
|
ATH_DEBUG_RX_PROC = 0x000004000ULL, /* rx ISR proc */
|
|
ATH_DEBUG_BEACON_PROC = 0x000008000ULL, /* beacon ISR proc */
|
|
ATH_DEBUG_CALIBRATE = 0x000010000ULL, /* periodic calibration */
|
|
ATH_DEBUG_KEYCACHE = 0x000020000ULL, /* key cache management */
|
|
ATH_DEBUG_STATE = 0x000040000ULL, /* 802.11 state transitions */
|
|
ATH_DEBUG_NODE = 0x000080000ULL, /* node management */
|
|
ATH_DEBUG_LED = 0x000100000ULL, /* led management */
|
|
ATH_DEBUG_FF = 0x000200000ULL, /* fast frames */
|
|
ATH_DEBUG_DFS = 0x000400000ULL, /* DFS processing */
|
|
ATH_DEBUG_TDMA = 0x000800000ULL, /* TDMA processing */
|
|
ATH_DEBUG_TDMA_TIMER = 0x001000000ULL, /* TDMA timer processing */
|
|
ATH_DEBUG_REGDOMAIN = 0x002000000ULL, /* regulatory processing */
|
|
ATH_DEBUG_SW_TX = 0x004000000ULL, /* per-packet software TX */
|
|
ATH_DEBUG_SW_TX_BAW = 0x008000000ULL, /* BAW handling */
|
|
ATH_DEBUG_SW_TX_CTRL = 0x010000000ULL, /* queue control */
|
|
ATH_DEBUG_SW_TX_AGGR = 0x020000000ULL, /* aggregate TX */
|
|
ATH_DEBUG_SW_TX_RETRIES = 0x040000000ULL, /* software TX retries */
|
|
ATH_DEBUG_FATAL = 0x080000000ULL, /* fatal errors */
|
|
ATH_DEBUG_SW_TX_BAR = 0x100000000ULL, /* BAR TX */
|
|
ATH_DEBUG_EDMA_RX = 0x200000000ULL, /* RX EDMA state */
|
|
ATH_DEBUG_SW_TX_FILT = 0x400000000ULL, /* SW TX FF */
|
|
ATH_DEBUG_NODE_PWRSAVE = 0x800000000ULL, /* node powersave */
|
|
ATH_DEBUG_DIVERSITY = 0x1000000000ULL, /* Diversity logic */
|
|
ATH_DEBUG_PWRSAVE = 0x2000000000ULL,
|
|
|
|
ATH_DEBUG_ANY = 0xffffffffffffffffULL
|
|
};
|
|
|
|
enum {
|
|
ATH_KTR_RXPROC = 0x00000001,
|
|
ATH_KTR_TXPROC = 0x00000002,
|
|
ATH_KTR_TXCOMP = 0x00000004,
|
|
ATH_KTR_SWQ = 0x00000008,
|
|
ATH_KTR_INTERRUPTS = 0x00000010,
|
|
ATH_KTR_ERROR = 0x00000020,
|
|
ATH_KTR_NODE = 0x00000040,
|
|
ATH_KTR_TX = 0x00000080,
|
|
};
|
|
|
|
#define ATH_KTR(_sc, _km, _kf, ...) do { \
|
|
if (sc->sc_ktrdebug & (_km)) \
|
|
CTR##_kf(KTR_DEV, __VA_ARGS__); \
|
|
} while (0)
|
|
|
|
extern uint64_t ath_debug;
|
|
|
|
#define IFF_DUMPPKTS(sc, m) (sc->sc_debug & (m))
|
|
#define DPRINTF(sc, m, fmt, ...) do { \
|
|
if (sc->sc_debug & (m)) \
|
|
device_printf(sc->sc_dev, fmt, __VA_ARGS__); \
|
|
} while (0)
|
|
#define KEYPRINTF(sc, ix, hk, mac) do { \
|
|
if (sc->sc_debug & ATH_DEBUG_KEYCACHE) \
|
|
ath_keyprint(sc, __func__, ix, hk, mac); \
|
|
} while (0)
|
|
|
|
extern void ath_printrxbuf(struct ath_softc *, const struct ath_buf *bf,
|
|
u_int ix, int);
|
|
extern void ath_printtxbuf(struct ath_softc *, const struct ath_buf *bf,
|
|
u_int qnum, u_int ix, int done);
|
|
extern void ath_printtxstatbuf(struct ath_softc *sc, const struct ath_buf *bf,
|
|
const uint32_t *ds, u_int qnum, u_int ix, int done);
|
|
#else /* ATH_DEBUG */
|
|
#define ATH_KTR(_sc, _km, _kf, ...) do { } while (0)
|
|
|
|
#define IFF_DUMPPKTS(sc, m) (0)
|
|
#define DPRINTF(sc, m, fmt, ...) do { \
|
|
(void) sc; \
|
|
} while (0)
|
|
#define KEYPRINTF(sc, k, ix, mac) do { \
|
|
(void) sc; \
|
|
} while (0)
|
|
#endif /* ATH_DEBUG */
|
|
|
|
#endif
|