98 lines
3.8 KiB
Groff
98 lines
3.8 KiB
Groff
.\" Copyright (c) 2010, Joerg Wunsch
|
|
.\" All rights reserved.
|
|
.\"
|
|
.\" Redistribution and use in source and binary forms, with or without
|
|
.\" modification, are permitted provided that the following conditions
|
|
.\" are met:
|
|
.\" 1. Redistributions of source code must retain the above copyright
|
|
.\" notice, this list of conditions and the following disclaimer.
|
|
.\" 2. Redistributions in binary form must reproduce the above copyright
|
|
.\" notice, this list of conditions and the following disclaimer in the
|
|
.\" documentation and/or other materials provided with the distribution.
|
|
.\"
|
|
.\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
|
|
.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
|
|
.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
|
|
.\" ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
|
|
.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
|
|
.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
|
|
.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
|
|
.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
|
|
.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
|
|
.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
|
|
.\" SUCH DAMAGE.
|
|
.\"
|
|
.\" $FreeBSD$
|
|
.\"
|
|
.Dd January 24, 2010
|
|
.Dt PCII 4
|
|
.Os
|
|
.Sh NAME
|
|
.Nm pcii
|
|
.Nd National Instruments PCIIA GPIB controller driver
|
|
.Sh SYNOPSIS
|
|
.Cd "device pcii"
|
|
.Pp
|
|
In
|
|
.Pa /boot/device.hints :
|
|
.Cd hint.pcii.0.at="isa"
|
|
.Cd hint.pcii.0.port="0x2e1"
|
|
.Cd hint.pcii.0.irq="7"
|
|
.Cd hint.pcii.0.drq="1"
|
|
.Sh DESCRIPTION
|
|
The
|
|
.Nm
|
|
driver provides support for driving an IEEE-488 bus, also called
|
|
IEC-625 (or just "IEC bus"), or HP-IB (Hewlett Packard Instrument
|
|
Bus), or GPIB (General Purpose Instrument Bus).
|
|
The driver supports National Instruments PCIIA cards (sometimes
|
|
also referred to as PC2A) and compatibles.
|
|
These cards use a NEC \(mcPD7210 controller IC as the main
|
|
interface between the host computer and the instrument bus.
|
|
.Ss IO memory space layout
|
|
The PCIIA cards use a very specific IO memory space allocation layout.
|
|
The address bits A0 through A9 (which have traditionally been the only
|
|
address bits evaluated on IBM PC XT extension cards) are hardwired to
|
|
address 0x2e1.
|
|
Bits A10 through A12 are used by the \(mcPD7210 register select lines.
|
|
This makes the individual 7210 registers being 0x400 bytes apart in the
|
|
ISA bus address space.
|
|
Address bits A13 and A14 are compared to a DIP switch setting on the
|
|
card, allowing for up to 4 different cards being installed (at base
|
|
addresses 0x2e1, 0x22e1, 0x42e1, and 0x62e1, respectively).
|
|
A15 has been used to select an optional on-board time-of-day clock
|
|
chip (MM58167A) on the original PCIIA rather than the \(mcPD7210
|
|
(which is not implemented on later boards and clones).
|
|
Finally, the IO addresses 0x2f0 ... 0x2f7 are used for a
|
|
.Em special interrupt handling feature
|
|
(re-enable interrupts so the IRQ can be shared), where actually only
|
|
address 0x2f0 plus the actual IRQ level is required for each card.
|
|
Some clones do not appear to require this special IRQ handling, and
|
|
are thus likely to not support the shared IRQ feature.
|
|
.Pp
|
|
Only the base address of the card needs to be specified in the ISA
|
|
device hints; the driver takes care to derive all other IO addresses
|
|
needed during the probe phase.
|
|
.Ss Supported cards
|
|
The following cards are known to be supported:
|
|
.Bl -bullet -offset indent
|
|
.It
|
|
B&C Microsystems PC488A-0
|
|
.It
|
|
National Instruments GPIB-PCII/PCIIA (in PCIIa mode)
|
|
.It
|
|
Axiom AX5488
|
|
.El
|
|
.Sh SEE ALSO
|
|
.Xr gpib 3 ,
|
|
.Xr gpib 4 ,
|
|
.Xr device.hints 5
|
|
.Sh HISTORY
|
|
The
|
|
.Nm
|
|
driver was written by Poul-Henning Kamp, and first appeared in
|
|
.Fx 5.4 .
|
|
.Sh AUTHORS
|
|
This manual page was written by
|
|
.An J\(:org Wunsch .
|