Neel Natu 6303b65d35 Fix issue with restarting an "insb/insw/insl" instruction because of a page ... fault on the destination buffer. Prior to this change a page fault would be detected in vm_copyout(). This was done after the I/O port access was done. If the I/O port access had side-effects (e.g. reading the uart FIFO) then restarting the instruction would result in incorrect behavior. Fix this by validating the guest linear address before doing the I/O port emulation. If the validation results in a page fault exception being injected into the guest then the instruction can now be restarted without any side-effects.		2014-05-26 18:21:08 +00:00
..
acpi.c	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
acpi.h	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
ahci.h
atkbdc.c	Provide a very basic stub for the 8042 PS/2 keyboard controller.	2014-04-25 13:38:18 +00:00
bhyve.8	Don't include the guest memory segments in the bhyve(8) process core dump.	2014-05-13 16:40:27 +00:00
bhyverun.c	Add emulation of the "outsb" instruction. NetBSD guests use this to write to	2014-05-23 05:15:17 +00:00
bhyverun.h	Use 'cpuset_t' to represent the vcpus active in a virtual machine.	2014-03-20 18:15:37 +00:00
block_if.c	Use calloc() in favor of malloc + memset.	2014-04-22 18:55:21 +00:00
block_if.h
consport.c	Handle single-byte reads from the bvmcons port (0x220) by returning	2014-04-08 21:02:03 +00:00
dbgport.c
dbgport.h
inout.c	Fix issue with restarting an "insb/insw/insl" instruction because of a page	2014-05-26 18:21:08 +00:00
inout.h	Add emulation of the "outsb" instruction. NetBSD guests use this to write to	2014-05-23 05:15:17 +00:00
ioapic.c
ioapic.h
Makefile	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
mem.c	Consolidate all the information needed by the guest page table walker into	2014-05-24 20:26:57 +00:00
mem.h
mevent_test.c
mevent.c	Re-adding an event to a kqueue modifies the parameters of the original event.	2014-05-05 16:30:03 +00:00
mevent.h
mptbl.c	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
mptbl.h
pci_ahci.c	Implement legacy interrupts for the AHCI device emulation	2014-04-28 18:41:25 +00:00
pci_emul.c	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
pci_emul.h	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
pci_hostbridge.c
pci_irq.c	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
pci_irq.h	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
pci_lpc.c	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
pci_lpc.h	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
pci_passthru.c	Use calloc() in favor of malloc + memset.	2014-04-22 18:55:21 +00:00
pci_uart.c
pci_virtio_block.c	Use calloc() in favor of malloc + memset.	2014-04-22 18:55:21 +00:00
pci_virtio_net.c	Use calloc() in favor of malloc + memset.	2014-04-22 18:55:21 +00:00
pci_virtio_rnd.c	Use calloc() in favor of malloc + memset.	2014-04-22 18:55:21 +00:00
pm.c	Implement a PCI interrupt router to route PCI legacy INTx interrupts to	2014-05-15 14:16:55 +00:00
pmtmr.c
post.c
rtc.c
rtc.h
smbiostbl.c	Add SMBIOS support.	2014-03-04 17:12:06 +00:00
smbiostbl.h	Add SMBIOS support.	2014-03-04 17:12:06 +00:00
spinup_ap.c	Use 'cpuset_t' to represent the vcpus active in a virtual machine.	2014-03-20 18:15:37 +00:00
spinup_ap.h
uart_emul.c	Disable the 'uart_drain()' callback when the emulated receive FIFO is full.	2014-05-05 23:54:13 +00:00
uart_emul.h
virtio.c
virtio.h	Add support for the virtio RNG entropy-source device.	2014-04-02 20:18:17 +00:00
xmsr.c	Ignore writes to microcode update MSR. This MSR is accessed by RHEL7 guest.	2014-04-30 02:08:27 +00:00
xmsr.h