freebsd-skq/sys/mips/atheros/ar91xx_chip.c
adrian e44e1c10f7 Reshuffle all of the DDR flush operations into a single switch/mux,
and start teaching subsystems about it.

The Atheros MIPS platforms don't guarantee any kind of FIFO consistency
with interrupts in hardware.  So software needs to do a flush when it
receives an interrupt and before it calls the interrupt handler.

There are new ones for the QCA934x and QCA955x, so do a few things:

* Get rid of the individual ones (for ethernet and IP2);
* Create a mux and enum listing all the variations on DDR flushes;
* replace the uses of IP2 with the relevant one (which will typically
  be "PCI" here);
* call the USB DDR flush before calling the real USB interrupt handlers;
* call the ethernet one upon receiving an interrupt that's for us,
  rather than never calling it during operation.

Tested:

* QCA9558 (TP-Link archer c7 v2)
* AR9331 (Carambola 2)

TODO:

* PCI, USB, ethernet, etc need to do a double-check to see if the
  interrupt was truely for them before doing the DDR.  For now I
  prefer "correct" over "fast".
2015-07-04 03:05:57 +00:00

220 lines
5.3 KiB
C

/*-
* Copyright (c) 2010 Adrian Chadd
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
* ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
* IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
* FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*/
#include <sys/cdefs.h>
__FBSDID("$FreeBSD$");
#include "opt_ddb.h"
#include <sys/param.h>
#include <sys/conf.h>
#include <sys/kernel.h>
#include <sys/systm.h>
#include <sys/bus.h>
#include <sys/cons.h>
#include <sys/kdb.h>
#include <sys/reboot.h>
#include <vm/vm.h>
#include <vm/vm_page.h>
#include <net/ethernet.h>
#include <machine/clock.h>
#include <machine/cpu.h>
#include <machine/cpuregs.h>
#include <machine/hwfunc.h>
#include <machine/md_var.h>
#include <machine/trap.h>
#include <machine/vmparam.h>
#include <mips/atheros/ar71xxreg.h>
#include <mips/atheros/ar71xx_cpudef.h>
#include <mips/atheros/ar71xx_chip.h>
#include <mips/atheros/ar91xxreg.h>
#include <mips/atheros/ar91xx_chip.h>
#include <mips/sentry5/s5reg.h>
static void
ar91xx_chip_detect_mem_size(void)
{
}
static void
ar91xx_chip_detect_sys_frequency(void)
{
uint32_t pll;
uint32_t freq;
uint32_t div;
u_ar71xx_mdio_freq = u_ar71xx_refclk = AR91XX_BASE_FREQ;
pll = ATH_READ_REG(AR91XX_PLL_REG_CPU_CONFIG);
div = ((pll >> AR91XX_PLL_DIV_SHIFT) & AR91XX_PLL_DIV_MASK);
freq = div * AR91XX_BASE_FREQ;
u_ar71xx_cpu_freq = freq;
div = ((pll >> AR91XX_DDR_DIV_SHIFT) & AR91XX_DDR_DIV_MASK) + 1;
u_ar71xx_ddr_freq = freq / div;
div = (((pll >> AR91XX_AHB_DIV_SHIFT) & AR91XX_AHB_DIV_MASK) + 1) * 2;
u_ar71xx_ahb_freq = u_ar71xx_cpu_freq / div;
u_ar71xx_uart_freq = u_ar71xx_cpu_freq / div;
u_ar71xx_wdt_freq = u_ar71xx_cpu_freq / div;
}
static void
ar91xx_chip_device_stop(uint32_t mask)
{
uint32_t reg;
reg = ATH_READ_REG(AR91XX_RESET_REG_RESET_MODULE);
ATH_WRITE_REG(AR91XX_RESET_REG_RESET_MODULE, reg | mask);
}
static void
ar91xx_chip_device_start(uint32_t mask)
{
uint32_t reg;
reg = ATH_READ_REG(AR91XX_RESET_REG_RESET_MODULE);
ATH_WRITE_REG(AR91XX_RESET_REG_RESET_MODULE, reg & ~mask);
}
static int
ar91xx_chip_device_stopped(uint32_t mask)
{
uint32_t reg;
reg = ATH_READ_REG(AR91XX_RESET_REG_RESET_MODULE);
return ((reg & mask) == mask);
}
static void
ar91xx_chip_set_pll_ge(int unit, int speed, uint32_t pll)
{
switch (unit) {
case 0:
ar71xx_write_pll(AR91XX_PLL_REG_ETH_CONFIG,
AR91XX_PLL_REG_ETH0_INT_CLOCK, pll,
AR91XX_ETH0_PLL_SHIFT);
break;
case 1:
ar71xx_write_pll(AR91XX_PLL_REG_ETH_CONFIG,
AR91XX_PLL_REG_ETH1_INT_CLOCK, pll,
AR91XX_ETH1_PLL_SHIFT);
break;
default:
printf("%s: invalid PLL set for arge unit: %d\n",
__func__, unit);
return;
}
}
static void
ar91xx_chip_ddr_flush(ar71xx_flush_ddr_id_t id)
{
switch (id) {
case AR71XX_CPU_DDR_FLUSH_GE0:
ar71xx_ddr_flush(AR91XX_DDR_REG_FLUSH_GE0);
break;
case AR71XX_CPU_DDR_FLUSH_GE1:
ar71xx_ddr_flush(AR91XX_DDR_REG_FLUSH_GE1);
break;
case AR71XX_CPU_DDR_FLUSH_USB:
ar71xx_ddr_flush(AR91XX_DDR_REG_FLUSH_USB);
break;
case AR71XX_CPU_DDR_FLUSH_WMAC:
ar71xx_ddr_flush(AR91XX_DDR_REG_FLUSH_WMAC);
break;
default:
printf("%s: invalid DDR flush id (%d)\n", __func__, id);
break;
}
}
static uint32_t
ar91xx_chip_get_eth_pll(unsigned int mac, int speed)
{
uint32_t pll;
switch(speed) {
case 10:
pll = AR91XX_PLL_VAL_10;
break;
case 100:
pll = AR91XX_PLL_VAL_100;
break;
case 1000:
pll = AR91XX_PLL_VAL_1000;
break;
default:
printf("%s%d: invalid speed %d\n", __func__, mac, speed);
pll = 0;
}
return (pll);
}
static void
ar91xx_chip_init_usb_peripheral(void)
{
ar71xx_device_stop(AR91XX_RST_RESET_MODULE_USBSUS_OVERRIDE);
DELAY(100);
ar71xx_device_start(RST_RESET_USB_HOST);
DELAY(100);
ar71xx_device_start(RST_RESET_USB_PHY);
DELAY(100);
/* Wireless */
ar71xx_device_stop(AR91XX_RST_RESET_MODULE_AMBA2WMAC);
DELAY(1000);
ar71xx_device_start(AR91XX_RST_RESET_MODULE_AMBA2WMAC);
DELAY(1000);
}
struct ar71xx_cpu_def ar91xx_chip_def = {
&ar91xx_chip_detect_mem_size,
&ar91xx_chip_detect_sys_frequency,
&ar91xx_chip_device_stop,
&ar91xx_chip_device_start,
&ar91xx_chip_device_stopped,
&ar91xx_chip_set_pll_ge,
&ar71xx_chip_set_mii_speed,
&ar71xx_chip_set_mii_if,
&ar91xx_chip_get_eth_pll,
&ar91xx_chip_ddr_flush,
&ar91xx_chip_init_usb_peripheral,
};