d/freebsd-skq
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
a750782f5b
freebsd-skq/sys/mips/cavium/octe/mv88e61xxphyreg.h
jmallett f77a32bd18 o) Make it possible to attach a PHY directly to an octe device rather than 
using miibus, since for some devices that use multiple addresses on the bus,
   going through miibus may be unclear, and for devices that are not standard
   MII PHYs, miibus may throw a fit, necessitating complicated interfaces to
   fake the interface that it expects during probe/attach.
o) Make the mv88e61xx SMI interface in octe attach a PHY directly and fix some
   mistakes in the code that resulted from trying too hard to present a nice
   interface to miibus.
o) Add a PHY driver for the mv88e61xx.  If attached (it is optional in kernel
   compiles so the default behavior of having a dumb switch is preserved) it
   will place the switch in a VLAN-tagging mode such that each physical port
   has a VLAN associated with it and interfaces for the VLANs can be created to
   address or bridge between them.
   XXX It would be nice for this to be part of a single module including the
       SMI interface, and for it to fit into a generic switch configuration
       framework and for it to use DSA rather than VLANs, but this is a start
       and gives some sense of the parameters of such frameworks that are not
       currently present in FreeBSD.  In lieu of a switch configuration
       interface, per-port media status and VLAN settings are in a sysctl tree.
   XXX There may be some minor nits remaining in the handling of broadcast,
       multicast and unknown destination traffic.  It would also be nice to go
       through and replace the few remaining magic numbers with macros at some
       point in the future.
   XXX This has only been tested with the MV88E6161, but it should work with
       minimal or no modification on related switches, so support for probing
       them was included.

Thanks to Pat Saavedra of TELoIP and Rafal Jaworowski of Semihalf for their
assistance in understanding the switch chipset.
2010-10-13 09:17:44 +00:00

150 lines
5.6 KiB
C
Raw Blame History

/*-
* Copyright (c) 2010 Juli Mallett <jmallett@FreeBSD.org>
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
* ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
* IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
* FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*
* $FreeBSD$
*/
/*
* Register definitions for Marvell MV88E61XX
*
* Note that names and definitions were gleaned from Linux and U-Boot patches
* released by Marvell, often by looking at contextual use of the registers
* involved, and may not be representative of the full functionality of those
* registers and are certainly not an exhaustive enumeration of registers.
*
* For an exhaustive enumeration of registers, check out the QD-DSDT package
* included in the Marvell ARM Feroceon Board Support Package for Linux.
*/
#ifndef _MIPS_CAVIUM_OCTE_MV88E61XXPHYREG_H_
#define _MIPS_CAVIUM_OCTE_MV88E61XXPHYREG_H_
/*
* Port addresses & per-port registers.
*/
#define MV88E61XX_PORT(x) (0x10 + (x))
#define MV88E61XX_HOST_PORT (5)
#define MV88E61XX_PORTS (6)
#define MV88E61XX_PORT_STATUS (0x00)
#define MV88E61XX_PORT_FORCE_MAC (0x01)
#define MV88E61XX_PORT_PAUSE_CONTROL (0x02)
#define MV88E61XX_PORT_REVISION (0x03)
#define MV88E61XX_PORT_CONTROL (0x04)
#define MV88E61XX_PORT_CONTROL2 (0x05)
#define MV88E61XX_PORT_VLAN_MAP (0x06)
#define MV88E61XX_PORT_VLAN (0x07)
#define MV88E61XX_PORT_FILTER (0x08)
#define MV88E61XX_PORT_EGRESS_CONTROL (0x09)
#define MV88E61XX_PORT_EGRESS_CONTROL2 (0x0a)
#define MV88E61XX_PORT_PORT_LEARN (0x0b)
#define MV88E61XX_PORT_ATU_CONTROL (0x0c)
#define MV88E61XX_PORT_PRIORITY_CONTROL (0x0d)
#define MV88E61XX_PORT_ETHER_PROTO (0x0f)
#define MV88E61XX_PORT_PROVIDER_PROTO (0x1a)
#define MV88E61XX_PORT_PRIORITY_MAP (0x18)
#define MV88E61XX_PORT_PRIORITY_MAP2 (0x19)
/*
* Fields and values in each register.
*/
#define MV88E61XX_PORT_STATUS_MEDIA (0x0300)
#define MV88E61XX_PORT_STATUS_MEDIA_10M (0x0000)
#define MV88E61XX_PORT_STATUS_MEDIA_100M (0x0100)
#define MV88E61XX_PORT_STATUS_MEDIA_1G (0x0200)
#define MV88E61XX_PORT_STATUS_DUPLEX (0x0400)
#define MV88E61XX_PORT_STATUS_LINK (0x0800)
#define MV88E61XX_PORT_STATUS_FC (0x8000)
#define MV88E61XX_PORT_CONTROL_DOUBLE_TAG (0x0200)
#define MV88E61XX_PORT_FILTER_MAP_DEST (0x0080)
#define MV88E61XX_PORT_FILTER_DISCARD_UNTAGGED (0x0100)
#define MV88E61XX_PORT_FILTER_DISCARD_TAGGED (0x0200)
#define MV88E61XX_PORT_FILTER_8021Q_MODE (0x0c00)
#define MV88E61XX_PORT_FILTER_8021Q_DISABLED (0x0000)
#define MV88E61XX_PORT_FILTER_8021Q_FALLBACK (0x0400)
#define MV88E61XX_PORT_FILTER_8021Q_CHECK (0x0800)
#define MV88E61XX_PORT_FILTER_8021Q_SECURE (0x0c00)
/*
* Global address & global registers.
*/
#define MV88E61XX_GLOBAL (0x1b)
#define MV88E61XX_GLOBAL_STATUS (0x00)
#define MV88E61XX_GLOBAL_CONTROL (0x04)
#define MV88E61XX_GLOBAL_VTU_OP (0x05)
#define MV88E61XX_GLOBAL_VTU_VID (0x06)
#define MV88E61XX_GLOBAL_VTU_DATA_P0P3 (0x07)
#define MV88E61XX_GLOBAL_VTU_DATA_P4P5 (0x08)
#define MV88E61XX_GLOBAL_ATU_CONTROL (0x0a)
#define MV88E61XX_GLOBAL_PRIORITY_MAP (0x18)
#define MV88E61XX_GLOBAL_MONITOR (0x1a)
#define MV88E61XX_GLOBAL_REMOTE_MGMT (0x1c)
#define MV88E61XX_GLOBAL_STATS (0x1d)
/*
* Fields and values in each register.
*/
#define MV88E61XX_GLOBAL_VTU_OP_BUSY (0x8000)
#define MV88E61XX_GLOBAL_VTU_OP_OP (0x7000)
#define MV88E61XX_GLOBAL_VTU_OP_OP_FLUSH (0x1000)
#define MV88E61XX_GLOBAL_VTU_OP_OP_VTU_LOAD (0x3000)
#define MV88E61XX_GLOBAL_VTU_VID_VALID (0x1000)
/*
* Second global address & second global registers.
*/
#define MV88E61XX_GLOBAL2 (0x1c)
#define MV88E61XX_GLOBAL2_MANAGE_2X (0x02)
#define MV88E61XX_GLOBAL2_MANAGE_0X (0x03)
#define MV88E61XX_GLOBAL2_CONTROL2 (0x05)
#define MV88E61XX_GLOBAL2_TRUNK_MASK (0x07)
#define MV88E61XX_GLOBAL2_TRUNK_MAP (0x08)
#define MV88E61XX_GLOBAL2_RATELIMIT (0x09)
#define MV88E61XX_GLOBAL2_VLAN_CONTROL (0x0b)
#define MV88E61XX_GLOBAL2_MAC_ADDRESS (0x0d)
/*
* Fields and values in each register.
*/
#define MV88E61XX_GLOBAL2_CONTROL2_DOUBLE_USE (0x8000)
#define MV88E61XX_GLOBAL2_CONTROL2_LOOP_PREVENT (0x4000)
#define MV88E61XX_GLOBAL2_CONTROL2_FLOW_MESSAGE (0x2000)
#define MV88E61XX_GLOBAL2_CONTROL2_FLOOD_BC (0x1000)
#define MV88E61XX_GLOBAL2_CONTROL2_REMOVE_PTAG (0x0800)
#define MV88E61XX_GLOBAL2_CONTROL2_AGE_INT (0x0400)
#define MV88E61XX_GLOBAL2_CONTROL2_FLOW_TAG (0x0200)
#define MV88E61XX_GLOBAL2_CONTROL2_ALWAYS_VTU (0x0100)
#define MV88E61XX_GLOBAL2_CONTROL2_FORCE_FC_PRI (0x0080)
#define MV88E61XX_GLOBAL2_CONTROL2_FC_PRI (0x0070)
#define MV88E61XX_GLOBAL2_CONTROL2_MGMT_TO_HOST (0x0008)
#define MV88E61XX_GLOBAL2_CONTROL2_MGMT_PRI (0x0007)
#endif /* !_MIPS_CAVIUM_OCTE_MV88E61XXPHYREG_H_ */
Reference in New Issue View Git Blame Copy Permalink