7d450faa6f
These are some fun issues I've found with my upstairs wifi link at such a ridiculous low signal level (like, < 5dB.) * Add per-station tx/rx rssi statistics, in potential preparation to use that in the RX rate control. * Call the rate control on each received frame to let it potentially use it as a hint for what rates to potentially use. It's a no-op right now. * Do ANI calibration during scan as well. The ath_newstate() call was disabling the ANI timer and only re-enabling it during transitions to _RUN. This has the unfortunate side-effect that if ANI deafened the NIC because of interference and it disassociated, it wouldn't be reset and the scan would never hear beacons. The ANI configuration is stored at least globally on some HALs and per-channel on others. Because of this a NIC reset wouldn't help; the ANI parameters would simply be programmed back in. Now, I have a feeling I also need to do this during AUTH/ASSOC too and maybe, if I'm feeling clever, I need to reset the ANI parameters on a given channel during a transition through INIT or if the VAP is destroyed/re-created. However for now this gets me out of the immediate weeds with connectivity upstairs (and thus I /can/ commit); I'll keep chipping away at tidying this stuff up in subsequent commits. Tested: * AR9344 (Wasp), 2G STA mode
177 lines
6.5 KiB
C
177 lines
6.5 KiB
C
/*-
|
|
* SPDX-License-Identifier: BSD-2-Clause-FreeBSD
|
|
*
|
|
* Copyright (c) 2004-2008 Sam Leffler, Errno Consulting
|
|
* Copyright (c) 2004 Video54 Technologies, Inc.
|
|
* All rights reserved.
|
|
*
|
|
* Redistribution and use in source and binary forms, with or without
|
|
* modification, are permitted provided that the following conditions
|
|
* are met:
|
|
* 1. Redistributions of source code must retain the above copyright
|
|
* notice, this list of conditions and the following disclaimer,
|
|
* without modification.
|
|
* 2. Redistributions in binary form must reproduce at minimum a disclaimer
|
|
* similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
|
|
* redistribution must be conditioned upon including a substantially
|
|
* similar Disclaimer requirement for further binary redistribution.
|
|
*
|
|
* NO WARRANTY
|
|
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
|
|
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
|
|
* LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
|
|
* AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
|
|
* THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
|
|
* OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
|
|
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
|
|
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
|
|
* IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
|
|
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
|
|
* THE POSSIBILITY OF SUCH DAMAGES.
|
|
*
|
|
* $FreeBSD$
|
|
*/
|
|
#ifndef _ATH_RATECTRL_H_
|
|
#define _ATH_RATECTRL_H_
|
|
|
|
/*
|
|
* Interface definitions for transmit rate control modules for the
|
|
* Atheros driver.
|
|
*
|
|
* A rate control module is responsible for choosing the transmit rate
|
|
* for each data frame. Management+control frames are always sent at
|
|
* a fixed rate.
|
|
*
|
|
* Only one module may be present at a time; the driver references
|
|
* rate control interfaces by symbol name. If multiple modules are
|
|
* to be supported we'll need to switch to a registration-based scheme
|
|
* as is currently done, for example, for authentication modules.
|
|
*
|
|
* An instance of the rate control module is attached to each device
|
|
* at attach time and detached when the device is destroyed. The module
|
|
* may associate data with each device and each node (station). Both
|
|
* sets of storage are opaque except for the size of the per-node storage
|
|
* which must be provided when the module is attached.
|
|
*
|
|
* The rate control module is notified for each state transition and
|
|
* station association/reassociation. Otherwise it is queried for a
|
|
* rate for each outgoing frame and provided status from each transmitted
|
|
* frame. Any ancillary processing is the responsibility of the module
|
|
* (e.g. if periodic processing is required then the module should setup
|
|
* it's own timer).
|
|
*
|
|
* In addition to the transmit rate for each frame the module must also
|
|
* indicate the number of attempts to make at the specified rate. If this
|
|
* number is != ATH_TXMAXTRY then an additional callback is made to setup
|
|
* additional transmit state. The rate control code is assumed to write
|
|
* this additional data directly to the transmit descriptor.
|
|
*/
|
|
struct ath_softc;
|
|
struct ath_node;
|
|
struct ath_desc;
|
|
|
|
struct ath_ratectrl {
|
|
size_t arc_space; /* space required for per-node state */
|
|
};
|
|
/*
|
|
* Attach/detach a rate control module.
|
|
*/
|
|
struct ath_ratectrl *ath_rate_attach(struct ath_softc *);
|
|
void ath_rate_detach(struct ath_ratectrl *);
|
|
|
|
#define ATH_RC_NUM 4
|
|
|
|
#define ATH_RC_DS_FLAG 0x01 /* dual-stream rate */
|
|
#define ATH_RC_CW40_FLAG 0x02 /* use HT40 */
|
|
#define ATH_RC_SGI_FLAG 0x04 /* use short-GI */
|
|
#define ATH_RC_HT_FLAG 0x08 /* use HT */
|
|
#define ATH_RC_RTSCTS_FLAG 0x10 /* enable RTS/CTS protection */
|
|
#define ATH_RC_STBC_FLAG 0x20 /* enable STBC */
|
|
#define ATH_RC_TS_FLAG 0x40 /* triple-stream rate */
|
|
|
|
struct ath_rc_series {
|
|
uint8_t rix; /* ratetable index, not rate code */
|
|
uint8_t ratecode; /* hardware rate code */
|
|
uint8_t tries;
|
|
uint8_t tx_power_cap;
|
|
uint16_t flags;
|
|
uint16_t max4msframelen;
|
|
};
|
|
|
|
/*
|
|
* State storage handling.
|
|
*/
|
|
/*
|
|
* Initialize per-node state already allocated for the specified
|
|
* node; this space can be assumed initialized to zero.
|
|
*/
|
|
void ath_rate_node_init(struct ath_softc *, struct ath_node *);
|
|
/*
|
|
* Cleanup any per-node state prior to the node being reclaimed.
|
|
*/
|
|
void ath_rate_node_cleanup(struct ath_softc *, struct ath_node *);
|
|
/*
|
|
* Update rate control state on station associate/reassociate
|
|
* (when operating as an ap or for nodes discovered when operating
|
|
* in ibss mode).
|
|
*/
|
|
void ath_rate_newassoc(struct ath_softc *, struct ath_node *,
|
|
int isNewAssociation);
|
|
|
|
/*
|
|
* Transmit handling.
|
|
*/
|
|
/*
|
|
* Return the four TX rate index and try counts for the current data packet.
|
|
*/
|
|
void ath_rate_getxtxrates(struct ath_softc *sc, struct ath_node *an,
|
|
uint8_t rix0, struct ath_rc_series *rc);
|
|
|
|
/*
|
|
* Return the transmit info for a data packet. If multi-rate state
|
|
* is to be setup then try0 should contain a value other than ATH_TXMATRY
|
|
* and ath_rate_setupxtxdesc will be called after deciding if the frame
|
|
* can be transmitted with multi-rate retry.
|
|
*/
|
|
void ath_rate_findrate(struct ath_softc *, struct ath_node *,
|
|
int shortPreamble, size_t frameLen,
|
|
u_int8_t *rix, int *try0, u_int8_t *txrate);
|
|
/*
|
|
* Setup any extended (multi-rate) descriptor state for a data packet.
|
|
* The rate index returned by ath_rate_findrate is passed back in.
|
|
*/
|
|
void ath_rate_setupxtxdesc(struct ath_softc *, struct ath_node *,
|
|
struct ath_desc *, int shortPreamble, u_int8_t rix);
|
|
/*
|
|
* Update rate control state for a packet associated with the
|
|
* supplied transmit descriptor. The routine is invoked both
|
|
* for packets that were successfully sent and for those that
|
|
* failed (consult the descriptor for details).
|
|
*
|
|
* For A-MPDU frames, nframes and nbad indicate how many frames
|
|
* were in the aggregate, and how many failed.
|
|
*/
|
|
struct ath_buf;
|
|
void ath_rate_tx_complete(struct ath_softc *, struct ath_node *,
|
|
const struct ath_rc_series *, const struct ath_tx_status *,
|
|
int pktlen, int nframes, int nbad);
|
|
|
|
/*
|
|
* Update rate control with a per-packet receive RSSI value.
|
|
*/
|
|
void ath_rate_update_rx_rssi(struct ath_softc *, struct ath_node *,
|
|
int rssi);
|
|
|
|
/*
|
|
* Fetch the global rate control statistics.
|
|
*/
|
|
int ath_rate_fetch_stats(struct ath_softc *sc, struct ath_rateioctl *rs);
|
|
|
|
/*
|
|
* Fetch the per-node statistics.
|
|
*/
|
|
int ath_rate_fetch_node_stats(struct ath_softc *sc, struct ath_node *an,
|
|
struct ath_rateioctl *rs);
|
|
|
|
#endif /* _ATH_RATECTRL_H_ */
|