ethdev: add access to specific device info

add new apis:
- rte_eth_dev_get_reg_length
- rte_eth_dev_get_reg_info
- rte_eth_dev_get_eeprom_length
- rte_eth_dev_get_eeprom
- rte_eth_dev_set_eeprom

to enable reading device parameters (register and
eeprom) based upon ethtool alike data parameter specification.

Signed-off-by: Liang-Min Larry Wang <liang-min.wang@intel.com>
Acked-by: Andrew Harvey <agh@cisco.com>
Acked-by: David Harton <dharton@cisco.com>
Acked-by: Konstantin Ananyev <konstantin.ananyev@intel.com>

lib/librte_ether/Makefile

@@ -51,6 +51,7 @@ SRCS-y += rte_ethdev.c
 SYMLINK-y-include += rte_ether.h
 SYMLINK-y-include += rte_ethdev.h
 SYMLINK-y-include += rte_eth_ctrl.h
+SYMLINK-y-include += rte_dev_info.h
 
 # this lib depends upon:
 DEPDIRS-y += lib/librte_eal lib/librte_mempool lib/librte_ring lib/librte_mbuf

lib/librte_ether/rte_dev_info.h

@@ -0,0 +1,57 @@
+/*-
+ *   BSD LICENSE
+ *
+ *   Copyright(c) 2015 Intel Corporation. All rights reserved.
+ *   All rights reserved.
+ *
+ *   Redistribution and use in source and binary forms, with or without
+ *   modification, are permitted provided that the following conditions
+ *   are met:
+ *
+ *     * Redistributions of source code must retain the above copyright
+ *       notice, this list of conditions and the following disclaimer.
+ *     * Redistributions in binary form must reproduce the above copyright
+ *       notice, this list of conditions and the following disclaimer in
+ *       the documentation and/or other materials provided with the
+ *       distribution.
+ *     * Neither the name of Intel Corporation nor the names of its
+ *       contributors may be used to endorse or promote products derived
+ *       from this software without specific prior written permission.
+ *
+ *   THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
+ *   "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
+ *   LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
+ *   A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
+ *   OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
+ *   SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
+ *   LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
+ *   DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
+ *   THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
+ *   (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
+ *   OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+ */
+
+#ifndef _RTE_DEV_INFO_H_
+#define _RTE_DEV_INFO_H_
+
+/*
+ * Placeholder for accessing device registers
+ */
+struct rte_dev_reg_info {
+	void *data; /**< Buffer for return registers */
+	uint32_t offset; /**< Start register table location for access */
+	uint32_t length; /**< Number of registers to fetch */
+	uint32_t version; /**< Device version */
+};
+
+/*
+ * Placeholder for accessing device eeprom
+ */
+struct rte_dev_eeprom_info {
+	void *data; /**< Buffer for return eeprom */
+	uint32_t offset; /**< Start eeprom address for access*/
+	uint32_t length; /**< Length of eeprom region to access */
+	uint32_t magic; /**< Device-specific key, such as device-id */
+};
+
+#endif /* _RTE_DEV_INFO_H_ */

lib/librte_ether/rte_ethdev.c

@@ -3398,3 +3398,63 @@ rte_eth_timesync_read_tx_timestamp(uint8_t port_id, struct timespec *timestamp)
 	FUNC_PTR_OR_ERR_RET(*dev->dev_ops->timesync_read_tx_timestamp, -ENOTSUP);
 	return (*dev->dev_ops->timesync_read_tx_timestamp)(dev, timestamp);
 }
+
+int
+rte_eth_dev_get_reg_length(uint8_t port_id)
+{
+	struct rte_eth_dev *dev;
+
+	VALID_PORTID_OR_ERR_RET(port_id, -ENODEV);
+
+	dev = &rte_eth_devices[port_id];
+	FUNC_PTR_OR_ERR_RET(*dev->dev_ops->get_reg_length, -ENOTSUP);
+	return (*dev->dev_ops->get_reg_length)(dev);
+}
+
+int
+rte_eth_dev_get_reg_info(uint8_t port_id, struct rte_dev_reg_info *info)
+{
+	struct rte_eth_dev *dev;
+
+	VALID_PORTID_OR_ERR_RET(port_id, -ENODEV);
+
+	dev = &rte_eth_devices[port_id];
+	FUNC_PTR_OR_ERR_RET(*dev->dev_ops->get_reg, -ENOTSUP);
+	return (*dev->dev_ops->get_reg)(dev, info);
+}
+
+int
+rte_eth_dev_get_eeprom_length(uint8_t port_id)
+{
+	struct rte_eth_dev *dev;
+
+	VALID_PORTID_OR_ERR_RET(port_id, -ENODEV);
+
+	dev = &rte_eth_devices[port_id];
+	FUNC_PTR_OR_ERR_RET(*dev->dev_ops->get_eeprom_length, -ENOTSUP);
+	return (*dev->dev_ops->get_eeprom_length)(dev);
+}
+
+int
+rte_eth_dev_get_eeprom(uint8_t port_id, struct rte_dev_eeprom_info *info)
+{
+	struct rte_eth_dev *dev;
+
+	VALID_PORTID_OR_ERR_RET(port_id, -ENODEV);
+
+	dev = &rte_eth_devices[port_id];
+	FUNC_PTR_OR_ERR_RET(*dev->dev_ops->get_eeprom, -ENOTSUP);
+	return (*dev->dev_ops->get_eeprom)(dev, info);
+}
+
+int
+rte_eth_dev_set_eeprom(uint8_t port_id, struct rte_dev_eeprom_info *info)
+{
+	struct rte_eth_dev *dev;
+
+	VALID_PORTID_OR_ERR_RET(port_id, -ENODEV);
+
+	dev = &rte_eth_devices[port_id];
+	FUNC_PTR_OR_ERR_RET(*dev->dev_ops->set_eeprom, -ENOTSUP);
+	return (*dev->dev_ops->set_eeprom)(dev, info);
+}

lib/librte_ether/rte_ethdev.h

@@ -182,6 +182,7 @@ extern "C" {
 #include <rte_devargs.h>
 #include "rte_ether.h"
 #include "rte_eth_ctrl.h"
+#include "rte_dev_info.h"
 
 struct rte_mbuf;
 
@@ -1255,6 +1256,24 @@ typedef int (*eth_timesync_read_tx_timestamp_t)(struct rte_eth_dev *dev,
 						struct timespec *timestamp);
 /**< @internal Function used to read a TX IEEE1588/802.1AS timestamp. */
 
+typedef int (*eth_get_reg_length_t)(struct rte_eth_dev *dev);
+/**< @internal Retrieve device register count  */
+
+typedef int (*eth_get_reg_t)(struct rte_eth_dev *dev,
+				struct rte_dev_reg_info *info);
+/**< @internal Retrieve registers  */
+
+typedef int (*eth_get_eeprom_length_t)(struct rte_eth_dev *dev);
+/**< @internal Retrieve eeprom size  */
+
+typedef int (*eth_get_eeprom_t)(struct rte_eth_dev *dev,
+				struct rte_dev_eeprom_info *info);
+/**< @internal Retrieve eeprom data  */
+
+typedef int (*eth_set_eeprom_t)(struct rte_eth_dev *dev,
+				struct rte_dev_eeprom_info *info);
+/**< @internal Program eeprom data  */
+
 #ifdef RTE_NIC_BYPASS
 
 enum {
@@ -1394,6 +1413,17 @@ struct eth_dev_ops {
 	reta_update_t reta_update;
 	/** Query redirection table. */
 	reta_query_t reta_query;
+
+	eth_get_reg_length_t get_reg_length;
+	/**< Get # of registers */
+	eth_get_reg_t get_reg;
+	/**< Get registers */
+	eth_get_eeprom_length_t get_eeprom_length;
+	/**< Get eeprom length */
+	eth_get_eeprom_t get_eeprom;
+	/**< Get eeprom data */
+	eth_set_eeprom_t set_eeprom;
+	/**< Set eeprom */
   /* bypass control */
 #ifdef RTE_NIC_BYPASS
   bypass_init_t bypass_init;
@@ -3670,6 +3700,79 @@ int rte_eth_remove_rx_callback(uint8_t port_id, uint16_t queue_id,
 int rte_eth_remove_tx_callback(uint8_t port_id, uint16_t queue_id,
 		struct rte_eth_rxtx_callback *user_cb);
 
+/**
+ * Retrieve number of available registers for access
+ *
+ * @param port_id
+ *   The port identifier of the Ethernet device.
+ * @return
+ *   - (>=0) number of registers if successful.
+ *   - (-ENOTSUP) if hardware doesn't support.
+ *   - (-ENODEV) if *port_id* invalid.
+ *   - others depends on the specific operations implementation.
+ */
+int rte_eth_dev_get_reg_length(uint8_t port_id);
+
+/**
+ * Retrieve device registers and register attributes
+ *
+ * @param port_id
+ *   The port identifier of the Ethernet device.
+ * @param info
+ *   The template includes buffer for register data and attribute to be filled.
+ * @return
+ *   - (0) if successful.
+ *   - (-ENOTSUP) if hardware doesn't support.
+ *   - (-ENODEV) if *port_id* invalid.
+ *   - others depends on the specific operations implementation.
+ */
+int rte_eth_dev_get_reg_info(uint8_t port_id, struct rte_dev_reg_info *info);
+
+/**
+ * Retrieve size of device EEPROM
+ *
+ * @param port_id
+ *   The port identifier of the Ethernet device.
+ * @return
+ *   - (>=0) EEPROM size if successful.
+ *   - (-ENOTSUP) if hardware doesn't support.
+ *   - (-ENODEV) if *port_id* invalid.
+ *   - others depends on the specific operations implementation.
+ */
+int rte_eth_dev_get_eeprom_length(uint8_t port_id);
+
+/**
+ * Retrieve EEPROM and EEPROM attribute
+ *
+ * @param port_id
+ *   The port identifier of the Ethernet device.
+ * @param info
+ *   The template includes buffer for return EEPROM data and
+ *   EEPROM attributes to be filled.
+ * @return
+ *   - (0) if successful.
+ *   - (-ENOTSUP) if hardware doesn't support.
+ *   - (-ENODEV) if *port_id* invalid.
+ *   - others depends on the specific operations implementation.
+ */
+int rte_eth_dev_get_eeprom(uint8_t port_id, struct rte_dev_eeprom_info *info);
+
+/**
+ * Program EEPROM with provided data
+ *
+ * @param port_id
+ *   The port identifier of the Ethernet device.
+ * @param info
+ *   The template includes EEPROM data for programming and
+ *   EEPROM attributes to be filled
+ * @return
+ *   - (0) if successful.
+ *   - (-ENOTSUP) if hardware doesn't support.
+ *   - (-ENODEV) if *port_id* invalid.
+ *   - others depends on the specific operations implementation.
+ */
+int rte_eth_dev_set_eeprom(uint8_t port_id, struct rte_dev_eeprom_info *info);
+
 #ifdef __cplusplus
 }
 #endif

lib/librte_ether/rte_ether_version.map

@@ -110,6 +110,11 @@ DPDK_2.1 {
 	global:
 
 	rte_eth_dev_default_mac_addr_set;
+	rte_eth_dev_get_eeprom;
+	rte_eth_dev_get_eeprom_length;
+	rte_eth_dev_get_reg_info;
+	rte_eth_dev_get_reg_length;
+	rte_eth_dev_set_eeprom;
 	rte_eth_dev_set_mc_addr_list;
 	rte_eth_timesync_disable;
 	rte_eth_timesync_enable;