Add optional ability to fragment packet bigger then mtu,
and reassemble fragmented packet.
To minimize possible performance effect, reassembly is
implemented as RX callback.
To support these features ipsec-secgw relies on librte_ipsec ability
to handle multi-segment packets.
Also when reassemble/fragmentation support is enabled, attached
crypto devices have to support 'In Place SGL' offload capability.
To enable/disable this functionality, two new optional command-line
options are introduced:
--reassemble <val> - number of entries in reassemble table
--mtu <val> - MTU value for all attached ports
As separate '--mtu' option is introduced, '-j <val>' option is now used
to specify mbuf data buffer size only.
Signed-off-by: Konstantin Ananyev <konstantin.ananyev@intel.com>
Acked-by: Akhil Goyal <akhil.goyal@nxp.com>
In some cases it is useful to allow user to specify destination
ether address for outgoing packets.
This patch adds such ability by introducing new 'neigh' config
file option.
Signed-off-by: Konstantin Ananyev <konstantin.ananyev@intel.com>
Acked-by: Radu Nicolau <radu.nicolau@intel.com>
Acked-by: Akhil Goyal <akhil.goyal@nxp.com>
Right now ipsec-secgw always enables TX offloads
(DEV_TX_OFFLOAD_MULTI_SEGS, DEV_TX_OFFLOAD_SECURITY),
even when they are not requested by the config.
That causes many PMD to choose full-featured TX function,
which in many cases is much slower then one without offloads.
That patch adds ability for the user to disable unneeded HW offloads.
If DEV_TX_OFFLOAD_IPV4_CKSUM is disabled by user, then
SW version of ip cksum calculation is used.
That allows to use vector TX function, when inline-ipsec is not
requested.
Signed-off-by: Remy Horton <remy.horton@intel.com>
Signed-off-by: Konstantin Ananyev <konstantin.ananyev@intel.com>
Acked-by: Radu Nicolau <radu.nicolau@intel.com>
Acked-by: Akhil Goyal <akhil.goyal@nxp.com>
Adding support for AES 256 algorithm in ipsec-secgw application
Signed-off-by: Anoob Joseph <anoob.joseph@caviumnetworks.com>
Acked-by: Radu Nicolau <radu.nicolau@intel.com>
When security offload is enabled, the packet should be forwarded on the
port configured in the SA. Security session will be configured on that
port only, and sending the packet on other ports could result in
unencrypted packets being sent out.
This would have performance improvements too, as the per packet LPM
lookup would be avoided for IPsec packets, in inline mode.
Fixes: ec17993a145a ("examples/ipsec-secgw: support security offload")
Signed-off-by: Anoob Joseph <anoob.joseph@caviumnetworks.com>
Acked-by: Akhil Goyal <akhil.goyal@nxp.com>
Acked-by: Radu Nicolau <radu.nicolau@intel.com>
Moved duplicated, and occasionally outdated, doc sections from each
of the sample app guides chapters to a common chapter at the start.
This reduces the duplication in the docs and provides a single
point of reference for compiling the sample apps.
Signed-off-by: Herakliusz Lipiec <herakliusz.lipiec@intel.com>
Signed-off-by: Marko Kovacevic <marko.kovacevic@intel.com>
Ipsec-secgw application is modified so that it can support
following type of actions for crypto operations
1. full protocol offload using crypto devices.
2. inline ipsec using ethernet devices to perform crypto operations
3. full protocol offload using ethernet devices.
4. non protocol offload
Signed-off-by: Akhil Goyal <akhil.goyal@nxp.com>
Signed-off-by: Radu Nicolau <radu.nicolau@intel.com>
Signed-off-by: Boris Pismenny <borisp@mellanox.com>
Signed-off-by: Declan Doherty <declan.doherty@intel.com>
Signed-off-by: Aviad Yehezkel <aviadye@mellanox.com>
Crypto driver names were changed in 16.11,
but some guides were still using the old ones
(which are still valid, only kept for compatibility
reasons).
To keep consistency and avoid confusion, all guides
should be using the same driver names.
Signed-off-by: Pablo de Lara <pablo.de.lara.guarch@intel.com>
Now that all the structures/functions for AEAD algorithms
are in place, migrate the two supported algorithms
AES-GCM and AES-CCM to these, instead of using
cipher and authentication parameters.
Signed-off-by: Pablo de Lara <pablo.de.lara.guarch@intel.com>
Acked-by: Declan Doherty <declan.doherty@intel.com>
Acked-by: Akhil Goyal <akhil.goyal@nxp.com>
Acked-by: Fiona Trahe <fiona.trahe@intel.com>
Since there is a new operation type (AEAD), add parameters
for this in the application.
Signed-off-by: Pablo de Lara <pablo.de.lara.guarch@intel.com>
Acked-by: Declan Doherty <declan.doherty@intel.com>
Acked-by: Akhil Goyal <akhil.goyal@nxp.com>
Acked-by: Fiona Trahe <fiona.trahe@intel.com>
RFC3686: Using AES Counter (CTR) Mode With IPsec ESP.`
Signed-off-by: Sergio Gonzalez Monroy <sergio.gonzalez.monroy@intel.com>
Acked-by: Pablo de Lara <pablo.de.lara.guarch@intel.com>
Add support for AES-GCM (Galois-Counter Mode).
RFC4106: The Use of Galois-Counter Mode (GCM) in IPSec ESP.
Signed-off-by: Sergio Gonzalez Monroy <sergio.gonzalez.monroy@intel.com>
Acked-by: Pablo de Lara <pablo.de.lara.guarch@intel.com>
This patch adds the configuration file support to ipsec_secgw
sample application. Instead of hard-coded rules, the users can
specify their own SP, SA, and routing rules in the configuration
file. A command line option "-f" is added to pass the
configuration file location to the application.
Configuration item formats:
SP rule format:
sp <ip_ver> <dir> esp <action> <priority> <src_ip> <dst_ip> \
<proto> <sport> <dport>
SA rule format:
sa <dir> <spi> <cipher_algo> <cipher_key> <auth_algo> <auth_key> \
<mode> <src_ip> <dst_ip>
Routing rule format:
rt <ip_ver> <src_ip> <dst_ip> <port>
Signed-off-by: Fan Zhang <roy.fan.zhang@intel.com>
Acked-by: Sergio Gonzalez Monroy <sergio.gonzalez.monroy@intel.com>
Sample app implementing an IPsec Security Geteway.
The main goal of this app is to show the use of cryptodev framework
in a "real world" application.
Currently only supported static IPv4 ESP IPsec tunnels for the following
algorithms:
- Cipher: AES-CBC, NULL
- Authentication: HMAC-SHA1, NULL
Not supported:
- SA auto negotiation (No IKE implementation)
- chained mbufs
Signed-off-by: Sergio Gonzalez Monroy <sergio.gonzalez.monroy@intel.com>
Acked-by: Pablo de Lara <pablo.de.lara.guarch@intel.com>
