This patch add the support for new Management Complex
Firmware version to 10.1x.x. One of the main changes in
the APIs ordered queue.
The fslmc bus lib ABI will need to be bumped to reflect
the MC FW API and structure changes.
This will also result in bumping of ABI verion of all dependent
libs as they internally use the MC FW APIs and structures.
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
Enable the VLAN filters only when requested in rx offload.
Fixes: 0ebce6129bc6 ("net/dpaa2: support new ethdev offload APIs")
Cc: stable@dpdk.org
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
The code was incorrectly using the Virtual mode, whent
the IOVA mode was set as Physical.
Fixes: 5ae1edff6895 ("dpaa2: prepare for 32-bit build")
Cc: stable@dpdk.org
Signed-off-by: Nipun Gupta <nipun.gupta@nxp.com>
With this patch, fslmc bus and ethernet devices on this bus
would start using the physical-virtual library interfaces.
This patch impacts mempool/dpaa2, event/dpaa2, net/dpaa2,
raw/dpaa2_cmdif and raw/dpaa2_qdma as they are dependent
on the bus/fslmc and thus impact linkage of libraries.
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
With this patch, dpaa bus and ethernet devices on this bus
would start using the physical-virtual library interfaces.
This patch impacts mempool/dpaa, event/dpaa and net/dpaa as
they are dependent on the bus/dpaa and thus impact linkage of
libraries.
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
A common library, valid for dpaaX drivers, which is used to maintain
a local copy of PA->VA translations.
In case of physical addressing mode (one of the option for FSLMC, and
only option for DPAA bus), the addresses of descriptors Rx'd are
physical. These need to be converted into equivalent VA for rte_mbuf
and other similar calls.
Using the rte_mem_virt2iova or rte_mem_virt2phy is expensive. This
library is an attempt to reduce the overall cost associated with
this translation.
A small table is maintained, containing continuous entries
representing a continguous physical range. Each of these entries
stores the equivalent VA, which is fed during mempool creation, or
memory allocation/deallocation callbacks.
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
Prior to this patch, bus and common compiled parallel. But, post this
dependency is created.
This is especially important for the DPAA/FSLMC buses which are going
to use the common/dpaax library.
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
In case RTE_LIBRTE_DPAA2_USE_PHYS_IOVA is enabled, only supported
class is RTE_IOVA_PA.
Fixes: f7768afac101 ("bus/fslmc: support dynamic IOVA")
Cc: stable@dpdk.org
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
Since the older kernel version do not implement the device request
interface for vfio, so when build on the kernel < v4.0.0, which is
the version begin to add the device request interface, it will
throw the error to show “VFIO_PCI_REQ_IRQ_INDEX” is undeclared.
This patch aim to fix this compile issue by add the macro
“HAVE_VFIO_DEV_REQ_INTERFACE” after checking the kernel version.
Fixes: 0eb8a1c4c786 ("vfio: add request notifier interrupt")
Fixes: c115fd000c32 ("vfio: handle hotplug request notifier")
Signed-off-by: Jeff Guo <jia.guo@intel.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
When device is be hot-unplugged, the vfio kernel module will sent req
notifier to request user space to release the allocated resources at
first. After that, vfio kernel module will detect the device disappear,
and then delete the device in kernel.
This patch aim to add req notifier processing to enable hotplug for vfio.
By enable the req notifier monitoring and register the notifier callback,
when device be hot-unplugged, the hot-unplug handler will be called to
process hotplug for vfio.
Signed-off-by: Jeff Guo <jia.guo@intel.com>
Acked-by: Anatoly Burakov <anatoly.burakov@intel.com>
There are some extended interrupt types in vfio pci device except from the
existing interrupts, such as err and req notifier, they could be useful for
device error monitoring. And these corresponding interrupt handler is
different from the other interrupt handler that register in PMDs, so a new
interrupt handler should be added. This patch will add specific req handler
in generic pci device.
Signed-off-by: Jeff Guo <jia.guo@intel.com>
Acked-by: Anatoly Burakov <anatoly.burakov@intel.com>
This patch implements the ops for the PCI bus sigbus handler. It finds the
PCI device that is being hot-unplugged and calls the relevant ops of the
hot-unplug handler to handle the hot-unplug failure of the device.
Signed-off-by: Jeff Guo <jia.guo@intel.com>
Acked-by: Shaopeng He <shaopeng.he@intel.com>
Acked-by: Konstantin Ananyev <konstantin.ananyev@intel.com>
This patch implements the ops to handle hot-unplug on the PCI bus.
For UIO PCI, it could avoids BARs read/write errors by creating a
new dummy memory to remap the memory where the failure is. For VFIO
or other kernel driver, it could specific implement function to handle
hot-unplug case by case.
Signed-off-by: Jeff Guo <jia.guo@intel.com>
Acked-by: Shaopeng He <shaopeng.he@intel.com>
Acked-by: Konstantin Ananyev <konstantin.ananyev@intel.com>
Add rte flow flush api for flushing
all the flows of the port.
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Acked-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Added support for parsing raw flow item.
flow_item_raw_preprocess() is added for the same.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
pmd_flow_destroy() API is added to destroy the
created flow.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
pmd_flow_create API is added to support
rte flow create.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Added validation and mapping of flow rule action
with table action profile.
Added flow_rule_action_get() to do the same.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Support for validating and mapping flow rule with HASH
table match is added.
As part of this, below helper functions are added.
flow_rule_match_hash_get()
hash_key_mask_is_same()
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Support for validating and mapping rte flow rule with
ACL table match is added.
As part of this support below utility functions
been added
flow_rule_match_get()
flow_rule_match_acl_get()
flow_item_skip_disabled_protos()
flow_item_proto_preprocess()
flow_item_is_proto()
flow_item_raw_preprocess()
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Start adding flow api operations.
Started with flow validate api support by adding
below basic infrastructure.
flow_pipeline_table_get()
pmd_flow_validate()
Additional flow validate changes will be
added in next patches.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Add utility function to get the rte_eth_dev from
a given softnic.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Added utility function to freeup the
pipeline tables.
Added utility functions to find the pipeline
output port.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Change dev_name, action_profile_name and key_mask
from char* type to arary type of structures
softnic_port_in_params, softnic_port_out_params
and softnic_table_hash_params.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Added new cli by which user can specify to softnic
which rte flow group and direction has to mapped to
which pipeline and table.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Added mapping support from rte_flow attributes
to softnic pipeline and table.
So added flow attribute map set and get functions
definition to new file rte_eth_sofnic_flow.c.
Added pmd flow internals with ingress and egress
flow attribute maps.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
This commit modifies SoftNIC to make use of the new header files in
librte_table.
As we are now using the new header files in librte_table in SoftNIC, we no
longer need the old header files so they can be removed.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Kevin Laatz <kevin.laatz@intel.com>
Acked-by: Gavin Hu <gavin.hu@arm.com>
Acked-by: Jerin Jacob <jerin.jacob@caviumnetworks.com>
If global RSS is not enabled in the multiqueue mode setting,
it will not be possible to change RSS configuration. However,
querying default RSS settings should be possible in any case since
it may be needed by RTE flow API users to find out what RSS settings
will be used by default for a flow rule with RSS action if custom
RSS key and hash function choice are not specified.
Fixes: 63ab5e0c8fda ("net/sfc: use zero RSS channels as disabled RSS indicator")
Cc: stable@dpdk.org
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Isolated mode prevents global RSS from being enabled and configured.
However, an application may need to query default RSS key and hash
functions when a flow rule with RSS action is added which does not
contain custom RSS key or hash function choice. In this case
global RSS key and hash functions will be used to handle the rule,
and there should be some way for the application to query these
global default settings to clarify expectations on the traffic
distribution.
Fixes: 84a9b48128c1 ("net/sfc: support flow API isolated mode")
Cc: stable@dpdk.org
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Earlier a patch was made to support change of Rx queue
number. That patch added goto label in wrong place
because reconfiguration with the same number of queues
results in skipping not only queue init but also RSS
settings. If a user configures device with RSS multiqueue
mode and then wants to stop it and reconfigure without RSS,
this change will be ignored and RSS will continue working.
Move the label in the right place and rename it to describe it.
Fixes: 55a539003f1a ("net/sfc: support changing the number of receive queues")
Cc: stable@dpdk.org
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
As ifcvf_init_hw is independent with ifcvf_vfio_setup, it's better to
invoke it directly in probe func.
Signed-off-by: Xiaolong Ye <xiaolong.ye@intel.com>
Acked-by: Xiao Wang <xiao.w.wang@intel.com>
The address translation from user virtual address to guest physical
address should not be named as qva_to_gpa.
Fixes: a3f8150eac6d ("net/ifcvf: add ifcvf vDPA driver")
Cc: stable@dpdk.org
Signed-off-by: Xiao Wang <xiao.w.wang@intel.com>
Acked-by: Xiaolong Ye <xiaolong.ye@intel.com>
