Because using a NFP PMD requires specific BSP installed, the PMD
support was not the default option before. This was just for making
people aware of such dependency, since there is no need for such a
BSP for just compiling DPDK with NFP PMD support.
Signed-off-by: Alejandro Lucero <alejandro.lucero@netronome.com>
Update the doc and release note.
Signed-off-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
Acked-by: Helin Zhang <helin.zhang@intel.com>
Acked-by: Vincent Jardin <vincent.jardin@6wind.com>
The enic TSO implementation requires that the length of the Eth/IP/TCP
headers be passed to the NIC. Other than that, it's just a matter of
setting the mss and offload mode on a per packet basis.
In TSO mode, IP and TCP checksums are offloaded even if not requested
with mb->ol_flags.
Signed-off-by: John Daley <johndale@cisco.com>
Add PCI device ID for ConnectX-5 and enable multi-packet send for PF and VF
along with changing documentation and release note.
Signed-off-by: Yongseok Koh <yskoh@mellanox.com>
Acked-by: Adrien Mazarguil <adrien.mazarguil@6wind.com>
Add support for 8.14.x.x firmware.
The new firmware adds support for external PHY BCM8485x; configures
fixed link speed with transceiver/cable not supporting negotiation;
supports engine swap; supports overriding PCIe preset equalization
value; checks pause too long for ports and reads die temperature
every second for shutdown threshold.
It includes change in FLR flow when there is a SW initiated FLR.
Signed-off-by: Rasesh Mody <rasesh.mody@cavium.com>
This patch implements NFP PMD support for TSO but it also requires
a firmware advertising the capability.
Signed-off-by: Alejandro Lucero <alejandro.lucero@netronome.com>
NFP supports more speeds than just 40 and 100GB, which were
what was advertised before.
Signed-off-by: Alejandro Lucero <alejandro.lucero@netronome.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Mark Spender <mspender@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Extract RSS hash provided by the HW in the prefix and put it to mbuf.
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
IPv4 header and TCP/UDP checksums for both IPv4 and IPv6 are supported.
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Ivan Malov <ivan.malov@oktetlabs.ru>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Does not implement any deprecated statistics.
No per-queue statistics yet.
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Supported options are auto (based on NIC firmware variant and
installed licences), throughput, low-latency.
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andrew Lee <alee@solarflare.com>
Reviewed-by: Robert Stonehouse <rstonehouse@solarflare.com>
The PMD allows for DPDK and the host to communicate using a raw
device interface on the host and in the DPDK application. The device
created is a Tap device with a L2 packet header.
Signed-off-by: Keith Wiles <keith.wiles@intel.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Tested-by: Aws Ismail <aismail@ciena.com>
Tested-by: Vasily Philipov <vasilyf@mellanox.com>
Check that Rx mbuf pool, MTU and Rx scatter config are in sync.
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andy Moreton <amoreton@solarflare.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Resources required in accordance with configuration are
allocated only.
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andy Moreton <amoreton@solarflare.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Manual link speed/duplex configuration is not supported yet.
Loopback is not supported yet.
Flow Director is not supported.
Link status change notification using interrupt is not supported yet.
Receive data notification using interrupts is not supported yet.
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andy Moreton <amoreton@solarflare.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Enable the PMD by default on supported configurations.
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Andy Moreton <amoreton@solarflare.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
This patch adds a new function eth_igb_fw_version_get.
Signed-off-by: Qiming Yang <qiming.yang@intel.com>
Acked-by: Remy Horton <remy.horton@intel.com>
This patch adds a new API 'rte_eth_dev_fw_version_get' for
fetching firmware version by a given device.
Signed-off-by: Qiming Yang <qiming.yang@intel.com>
Acked-by: Remy Horton <remy.horton@intel.com>
This patch mainly allocates structure to store queue/irq mapping,
and configure queue/irq mapping down through PCI ops. It also creates
eventfds for each Rx queue and tell the kernel about the eventfd/intr
binding.
Note: So far, we hard-code 1:1 queue/irq mapping (each rx queue has
one exclusive interrupt), like this:
vec 0 -> config irq
vec 1 -> rxq0
vec 2 -> rxq1
...
which means, the "vectors" option of QEMU should be configured with
a value >= N+1 (N is the number of the queue pairs).
Signed-off-by: Jianfeng Tan <jianfeng.tan@intel.com>
Tested-by: Lei Yao <lei.a.yao@intel.com>
Acked-by: Yuanhan Liu <yuanhan.liu@linux.intel.com>
The introduce of virtio 1.0 support brings yet another set of ops, badly,
it's not handled correctly, that it breaks the multiple process support.
The issue is the data/function pointer may vary from different processes,
and the old used to do one time set (for primary process only). That
said, the function pointer the secondary process saw is actually from the
primary process space. Accessing it could likely result to a crash.
Kudos to the last patches, we now be able to maintain those info that may
vary among different process locally, meaning every process could have its
own copy for each of them, with the correct value set. And this is what
this patch does:
- remap the PCI (IO port for legacy device and memory map for modern
device)
- set vtpci_ops correctly
After that, multiple process would work like a charm. (At least, it
passed my fuzzy test)
Fixes: b8f04520ad71 ("virtio: use PCI ioport API")
Fixes: d5bbeefca826 ("virtio: introduce PCI implementation structure")
Fixes: 6ba1f63b5ab0 ("virtio: support specification 1.0")
Cc: stable@dpdk.org
Reported-by: Juho Snellman <jsnell@iki.fi>
Reported-by: Yaron Illouz <yaroni@radcom.com>
Signed-off-by: Yuanhan Liu <yuanhan.liu@linux.intel.com>
MACsec (or LinkSec, 802.1AE) is a MAC level encryption/authentication
scheme defined in IEEE 802.1AE that uses symmetric cryptography.
This commit adds the MACsec offload support for ixgbe.
Signed-off-by: Tiwei Bie <tiwei.bie@intel.com>
Acked-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
Rename tools/ into usertools/ to differentiate from buildtools/
and devtools/ while making clear these scripts are part of
DPDK runtime.
Signed-off-by: Thomas Monjalon <thomas.monjalon@6wind.com>
Tested-by: Ferruh Yigit <ferruh.yigit@intel.com>
- Fix to use bitmapped values in NVM configuration for speed capability
advertisement. This issue is specific to 25G NIC since it is capable
of 25G and 10G speeds.
- Update feature list.
Fixes: 64c239b7f8b7 ("net/qede: fix advertising link speed capability")
Signed-off-by: Harish Patil <harish.patil@qlogic.com>
