This patch add support for dumping MAC registers.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add support for EEPROM reading/writing.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
VLAN filters and VLAN offloads implementation.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add support for adding/removing MAC addresses.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add support for flow control feature.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add support for Receive Side Scaling feature.
RSS hash and reta table configuration.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add support for promiscuous/allmulticast modes configuration.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add support for Rx/Tx descriptors status information.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add support for device stats, xstats and queue stats
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Implement link interrupt, link info, link polling.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add RX/TX function prototypes for further datapath development.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Start, stop and reset are all done via hw_atl layer.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Makefile/meson build infrastructure, atl_ethdev minimal skeleton,
header with aquantia aQtion NIC device and vendor IDs.
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Add enetc usage document to compile and run the
DPDK application on enetc supported platform.
This document introduces the enetc driver, supported
platforms and supported features.
Signed-off-by: Gagandeep Singh <g.singh@nxp.com>
Acked-by: Shreyansh Jain <shreyansh.jain@nxp.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Add callback for updating information about link status/info.
Signed-off-by: Natalie Samsonov <nsamsono@marvell.com>
Signed-off-by: Zyta Szpak <zr@semihalf.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Add part of PMD for actual reception/transmission.
Signed-off-by: Yelena Krivosheev <yelena@marvell.com>
Signed-off-by: Dmitri Epshtein <dima@marvell.com>
Signed-off-by: Zyta Szpak <zr@semihalf.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
set_mc_addr_list method is not implemented by the driver yet.
Fixes: a46f8d584eb8 ("net/failsafe: add fail-safe PMD")
Cc: stable@dpdk.org
Signed-off-by: Evgeny Im <evgeny.im@oktetlabs.com>
Signed-off-by: Andrew Rybchenko <arybchenko@solarflare.com>
Acked-by: Gaetan Rivet <gaetan.rivet@6wind.com>
Add tx_done_cleanup ethdev hook to allow application to
control if/when it wants completions to be handled.
Signed-off-by: Stephen Hemminger <sthemmin@microsoft.com>
This reverts the patch that enabled mbuf fast free.
There are two main reasons.
First, enic_fast_free_wq_bufs is broken. When
DEV_TX_OFFLOAD_MBUF_FAST_FREE is enabled, the driver calls this
function to free transmitted mbufs. This function currently does not
reset next and nb_segs. This is simply wrong as the fast-free flag
does not imply anything about next and nb_segs.
We could fix enic_fast_free_wq_bufs by making it to call
rte_pktmbuf_prefree_seg to reset the required fields. But, it negates
most of cycle saving.
Second, there are customer applications that blindly enable all Tx
offloads supported by the device. Some of these applications do not
satisfy the requirements of mbuf fast free (i.e. a single pool per
queue and refcnt = 1), and end up crashing or behaving badly.
Fixes: bcaa54c1a148 ("net/enic: support mbuf fast free offload")
Signed-off-by: Hyong Youb Kim <hyonkim@cisco.com>
Reviewed-by: John Daley <johndale@cisco.com>
Make a few updates in preparation for 18.08.
- Use SPDX
- Add 1400 series VIC adapters to supported models
- Describe the VXLAN port number
- Expand the description for ig-vlan-rewrite
- Add inner RSS and checksum to the features
Signed-off-by: Hyong Youb Kim <hyonkim@cisco.com>
Reviewed-by: John Daley <johndale@cisco.com>
This patch adds support for building and running mlx5 PMD on
32bit systems such as i686.
The main issue to tackle was handling the 32bit access to the UAR
as quoted from the mlx5 PRM:
QP and CQ DoorBells require 64-bit writes. For best performance, it
is recommended to execute the QP/CQ DoorBell as a single 64-bit write
operation. For platforms that do not support 64 bit writes, it is
possible to issue the 64 bits DoorBells through two consecutive
writes,
each write 32 bits, as described below:
* The order of writing each of the Dwords is from lower to upper
addresses.
* No other DoorBell can be rung (or even start ringing) in the midst
of an on-going write of a DoorBell over a given UAR page.
The last rule implies that in a multi-threaded environment, the access
to a UAR page (which can be accessible by all threads in the process)
must be synchronized (for example, using a semaphore) unless an atomic
write of 64 bits in a single bus operation is guaranteed. Such a
synchronization is not required for when ringing DoorBells on different
UAR pages.
Signed-off-by: Moti Haimovsky <motih@mellanox.com>
Acked-by: Yongseok Koh <yskoh@mellanox.com>
rte_eth_rx_descritpr_status and rte_eth_tx_descriptor_status
are supported by fm10K.
Signed-off-by: Wei Zhao <wei.zhao1@intel.com>
Acked-by: Qi Zhang <qi.z.zhang@intel.com>
Introduce rte_flow skeleton and implement validate operation.
Parse and convert <item>, <action>, <attributes> into hardware
specification. Perform validation, including basic sanity tests
and underlying device's supported filter capability checks.
Currently add support for:
<item>: IPv4, IPv6, TCP, and UDP.
<action>: Drop, Queue, and Count.
Also add sanity checks to ensure filters are created at specified
index in LE-TCAM region. The index in LE-TCAM region indicates
the filter rule's priority with index 0 having the highest priority.
If no index is specified, filters are created at closest available
free index.
Signed-off-by: Shagun Agrawal <shaguna@chelsio.com>
Signed-off-by: Kumar Sanghvi <kumaras@chelsio.com>
Signed-off-by: Rahul Lakkireddy <rahul.lakkireddy@chelsio.com>
Add LINUX VFIO support to feature list.
Add GRE tunneling offload to supported feature list.
Update firmware references to use newer FW image 8.33.12.0. Update
management FW version as well to 8.34.x.x.
Signed-off-by: Rasesh Mody <rasesh.mody@cavium.com>
Add more descriptions regarding SR-IOV and RSS settings.
Remove 'Multicast MAC filter' and add 'Allmulticast mode' to the
features.
Cc: stable@dpdk.org
Signed-off-by: Hyong Youb Kim <hyonkim@cisco.com>
Reviewed-by: John Daley <johndale@cisco.com>
Reviewed-by: Aaron Conole <aconole@redhat.com>
Add new callbacks for eth_dev_ops of i40e to get the information
and data of plugin module eeprom.
Signed-off-by: Zijie Pan <zijie.pan@6wind.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Acked-by: Remy Horton <remy.horton@intel.com>
Add new callbacks for eth_dev_ops of e1000 to get the information and
data of plugin module EEPROM.
Signed-off-by: Zijie Pan <zijie.pan@6wind.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Acked-by: Remy Horton <remy.horton@intel.com>
Add new callbacks for eth_dev_ops of ixgbe to get the information
and data of plugin module eeprom.
Signed-off-by: Zijie Pan <zijie.pan@6wind.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Acked-by: Remy Horton <remy.horton@intel.com>
