without Open Firmware directly instead of using OF_getetheraddr(). This is
a bit painful though, as the MAC address is contained in the NA field of
the VPD of the EBus bridge, which is is another function of the same chip.
To make it worse, the VPD of the EBus bridge can't be accessed via the PCI
capability pointer but has to be digged out from the Boot PROM and has a
non-standard format.
The PCI VPD struct and macros used here should be part of the FreeBSD PCI
code nevertheless.
Approved by: tmm
Based on: NetBSD
Tested with: Sun X1032A (hme(4)-isp(4)-combo card) on alpha and i386
network layer (ether).
- Don't abuse module names to facilitate ifconfig module loading;
such abuse isn't really needed. (And if we do need type information
associated with a module then we should make it explicit and not
use hacks.)
- remove some useless code from the status change handler that was intended
to enable the the MII drivers for external phys; this is already done
during interface initialization, and the deleted code made some
assumptions about phy addresses that do not seem to hold true on newer
cards. This should get at least one of the two hmes of newer Netra t1
machines working.
- correct the interrupt resource allocation
- bump the number of RX descriptors, lower values cause promblems on some
machines
in most machines of the Sun Ultra series. This is a port of the NetBSD
driver which I enhanced to make use of the gather functionality and the
configurable RX buffer offset to avoid copying all received/sent packet
(instead, packets will be directly DMAd from mbuf chains and into mbuf
clusters now).