It has never been a part of upstream's struct pmu_event. The jevents
utility will not fill this field, so remove it.
Reviewed by: gnn
MFC after: 2 weeks
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D30530
There is a single consumer, the pmc utility, that clearly has knowledge
of which counters it is expecting. Remove this function and have it
use common counter aliases instead.
Reviewed by: gnn
MFC after: 2 weeks
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D30528
Check if the pmu utils are supported rather than carrying a
machine-dependent #ifdef.
Reviewed by: gnn, ray, emaste
MFC after: 2 weeks
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D30526
The typo prevents the counter from being allocated.
This fixes e.g. pmcstat -s instructions sleep 5
Reviewed by: mizhka, gnn, ray, emaste
MFC after: 5 days
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D30527
Commit message of the identical change in Linux driver says:
"When an I2C HID device is powered off during system sleep, as a result
of removing its power resources (by the ACPI core) the interrupt line
might go low as well. This results inadvertent interrupts."
This change fixes suspend/resume on Asus S510UQ laptops.
While here add a couple of typo fixes as well as a slight change to the
iichid_attach() code to have the power_on flag set properly.
Submitted by: J.R. Oldroyd <jr_AT_opal_DOT_com>
Reviewed by: wulf
MFC after: 1 week
- Allow firmware downloading for hw_variant #8;
- Enter manufacturer mode for setting of event mask;
- Handle multi-event response on HCI commands for 7260;
This allows to remove kludge with skipping of 0xfc2f opcode.
- Disable patch and exit manufacturer mode on downloading failure;
- Use default firmware if correct firmware file is not found;
Reviewed by: Philippe Michaud-Boudreault <pitwuu_AT_gmail_DOT_com>
MFC after: 1 week
Tested by: arrowd
Differential revision: https://reviews.freebsd.org/D30543
Currently passing PDROP to the quisce_cpus() function does not make sense.
Add special meaning for it, by not waiting for the idle thread to schedule.
Also avoid allocating u_int[MAXCPU] on the stack.
Reviewed by: hselasky, markj
Sponsored by: Mellanox Technologies/NVidia Networking
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D30468
kld_sx is dropped e.g. for executing sysinits, which allows user
to initiate kldunload while module is not yet fully initialized.
Reviewed by: markj
Differential revision: https://reviews.freebsd.org/D30456
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Add _opt() variants for the uint* functions. These functions set the
provided default value if the nvlist doesn't contain the relevant value.
This is helpful for optional values (e.g. when the API is extended to
add new fields).
While here simplify the header by also using macros to create the
prototypes for the macro-generated function implementations.
Reviewed by: scottl
MFC after: 2 weeks
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D30510
When we create an nvlist and insert it into another nvlist we must
remember to destroy it. The nvlist_add_nvlist() function makes a copy,
just like nvlist_add_string() makes a copy of the string.
See also 4483fb4773
Reviewed by: scottl
MFC after: 3 days
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D30492
Even if the clock is flagged with AW_CLK_SET_PARENT the current parent
freq might be enough to get a correct divisor.
So test first if we can get the expected freq before changing the parent
freq.
The functionality to detect a newly created link after processing a
single packet is decoupled from the packet processing. Every new
packet is processed asynchronously and will reset the indicator, hence
the function is unusable. I made a Google search for third party code,
which uses the function, and failed to find one.
That's why the function should be removed: It unusable and unused.
A much simplified API/ABI will remain in anything below 14.
Discussed with: kp
Reviewed by: manpages (bcr)
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D30275
Approved by: mw
Obtained from: Semihalf
Sponsored by: Stormshield
Differential Revision: https://reviews.freebsd.org/D30354
Changes:
1. add spinlock to bw_meter
If two contexts read and modify bw_meter values
it might happen that these are corrupted.
Guard only code fragments which do read-and-modify.
Context which only do "reads" are not done inside
spinlock block. The only sideffect that can happen is
an 1-p;acket outdated value reported back to userspace.
2. replace all locks with a single RWLOCK
Multiple locks caused a performance issue in routing
hot path, when two of them had to be taken. All locks
were replaced with single RWLOCK which makes the hot
path able to take only shared access to lock most of
the times.
All configuration routines have to take exclusive lock
(as it was done before) but these operation are very rare
compared to packet routing.
3. redesign MFC expire and UPCALL expire
Use generic kthread and cv_wait/cv_signal for deferring
work. Previously, upcalls could be sent from two contexts
which complicated the design. All upcall sending is now
done in a kthread which allows hot path to work more
efficient in some rare cases.
4. replace mutex-guarded linked list with lock free buf_ring
All message and data is now passed over lockless buf_ring.
This allowed to remove some heavy locking when linked
lists were used.
The Linux client is now attempting to use the Secinfo_no_name
operation for NFSv4.1/4.2 mounts. Although it does not seem to
mind the NFSERR_NOTSUPP reply, adding support for it seems
reasonable.
I also noticed that "savflag" needed to be 64bits in
nfsrvd_secinfo() since nd_flag in now 64bits, so I changed
the declaration of it there. I also added code to set "vp" NULL
after performing Secinfo/Secinfo_no_name, since these
operations consume the current FH, which is represented
by "vp" in nfsrvd_compound().
Fixing when the server replies NFSERR_WRONGSEC so that
it conforms to RFC5661 Sec. 2.6 still needs to be done
in a future commit.
MFC after: 2 weeks
Summary:
Convert MAINTAINERS into a Github CODEOWNERS file. This will
automatically assign reviewers to some GH pull requests. The conversion
is not 1:1; some committers don't have Github accounts (e.g. adrian),
some functional areas don't neatly correspond to a set of files (e.g.
kqueue), and mailing lists can't be assigned as a reviewer (e.g.
secteam@). But it's a start.
MFC after: 2 weeks
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D30559
Return EBUSY instead and let caller to handle the issue.
For vgone()/vnode reclamation, caller first does vinvalbuf(V_SAVE),
which return EBUSY in case dirty buffers where not flushed. Then caller
calls vinvalbuf(0) due to non-zero return, which gets rid of all dirty
buffers without dependencies.
PR: 238565
Reviewed by: asomers, mckusick
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D30555
Instead of requiring all implementations of vfs_quotactl to unbusy
the mount for Q_QUOTAON and Q_QUOTAOFF, add an "mp_busy" in/out param
to VFS_QUOTACTL(9). The implementation may then indicate to the caller
whether it needed to unbusy the mount.
Also, add stbool.h to libprocstat modules which #define _KERNEL
before including sys/mount.h. Otherwise they'll pull in sys/types.h
before defining _KERNEL and therefore won't have the bool definition
they need for mp_busy.
Reviewed By: kib, markj
Differential Revision: https://reviews.freebsd.org/D30556
The commit 189f8eea contains a refactorisation of a constant. During
later review D30283 the naming of the constant was improved and the
initialization became explicit. Put this into the tree, in order to
MFC the correct naming.
'Intel Centrino Wireless-N 6250' is listed twice in the description
section of the manual page.
PR: 256257
Reported by: Daniel Cervus <danielthedeer at outlook dot com>
MFC after: 3 days
Parts of libprocstat like to pretend they're kernel components for the
sake of including mount.h, and including sys/types.h in the _KERNEL
case doesn't fix the build for some reason. Revert both the
VFS_QUOTACTL() change and the follow-up "fix" for now.
