network adapters. These are all PCMCIA devices (the ISA version is a
PCMCIA to ISA bridge with a PCMCIA card plugged into it). Also add a
wicontrol utility to read and write some of the card's parameters.
Note: I do not have access to a WavePOINT access point, so I have only
been able to test this driver in ad-hoc (point to point) mode. The
wicontrol utility allows programming the desired service set name (SSID)
and enabling BSS mode, but I can't tell for sure if it works (I know the
card switches modes, but I can't verify that it joins a service set
correctly).
This driver was written using information gleaned from the Lucent HCF Light
library, which is an API library designed to simplify driver development
for devices based on the Lucent Hermes chip. Unfortunately, the HCF Light
is missing certain features (like 802.11 frame encapsulation!) which are
available only in the proprietary complete HCF code, which is not available
to the public. This driver uses none of the HCF Light code: it's very ugly
and contaminated by the GPL. IP and ARP packets are encapsulated as 802.11
frames, everything else is encapsulated as 802.3.
(It would be easier to just get the Hermes programming manual, but that's
not publically available either. For those who are wondering, the Linux
WaveLAN/IEEE driver uses the proprietary HCF code, which is provided in
object code form only. So much for supporting open source sofware.)
Multicast filter support is implemented, however it appears that the
filter doesn't work: programming in one IP mutlicast group enables them
all.
handler. This fixes pnp interrupts and would have fixed pccard interrupts
but a workaround has been applied there.
This the sound driver problems which people have reported with new-bus.
uses the AUI port with an on-board AUI to 10baseFL transceiver, not the
10baseT port like I had earlier suspected. The 3c900B-FL should be properly
supported now.
routines. The descriptor contains parameters which could be used
within those routines (eg. ip_output() ).
On passing, add IPPROTO_PGM entry to netinet/in.h
abuses its argument, which is supposed to be an integer unit number, as
a pointer to the head of the 'struct slot' list. When this code was
hacked^Wupdated for newbus, a new mechanism for registering slot_irq_handler()
was put in place and the significance of the unit number was overlooked.
When registering an interrupt, we have both device_id and unit. The unit
number is passed as 'unit' but /sys/i386/usa/intr_machdep.c:register_intr()
drops unit on the floor and uses device_id instead. Since pccard_alloc_intr()
always sets device_id to 0, this means the unit number is always zero, and
slot_irq_handler() is always called with 0, which becomes a NULL pointer
which slot_irq_handler() tries to dereference and the kernel explodes.
Result: if you assign a PCMCIA driver in the kernel config file like this:
device wi0 at isa? port? irq?
Then the system will panic the moment a PCMCIA device is attached and
an interrupt is triggered.
The quick fix: make pccard_alloc_intr() pass the unit number as both
the device_id and unit arguments to register_pcic_intr(). The correct fix
would be to rewrite /sys/pccard to be less disgusting.
+ plug an mbuf leak when dummynet used with bridging
+ make prototype of dummynet_io consistent with usage
+ code cleanup so that now bandwidth regulation is precise to the
bit/s and not to (8*HZ) bit/s as before.
