These ones were unambiguous cases where the Foundation was the only
listed copyright holder (in the associated license block).
Sponsored by: The FreeBSD Foundation
This is needed on arm64 for the interface between iommu framework
and iommu controller drivers.
Reviewed by: kib
Sponsored by: Innovate DSbD
Differential Revision: https://reviews.freebsd.org/D27229
from Intel DMAR support, so it can be used on other IOMMU systems.
Reviewed by: kib
Sponsored by: DARPA/AFRL
Differential Revision: https://reviews.freebsd.org/D25743
so it can be used on other IOMMU systems.
Provide MI iommu_unit, iommu_domain and iommu_ctx structs in sys/iommu.h;
use them as a first member of MD dmar_unit, dmar_domain and dmar_ctx.
Change the namespace in DMAR backend: use iommu_ prefix instead of dmar_.
Move some macroses and function prototypes to sys/iommu.h.
Reviewed by: kib
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D25574
at the root of every subtree that changes in an insert or delete, and
only once, and ordered from the bottom of the tree to the top. For
intel_gas.c, the only user of RB_AUGMENT I can find, change the
augmenting routine so that it does not climb from entry to tree root
on every call, and remove a 'tree correcting' function that can be
supplanted by proper tree augmentation.
Reviewed by: kib
Tested by: pho
Differential Revision: https://reviews.freebsd.org/D23189
context should share page tables.
Practically it means that dma requests from any device on the bus are
translated according to the entries loaded for the bus:0:0 device.
KPI requires that the slot and function of the device be 0:0, and that
no tags for other devices on the bus were used.
The intended use are NTBs which pass TLPs from the downstream to the
host with slot:func of the downstream originator.
Reviewed and tested by: mav
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D22434
This allows replacing "sys/eventfilter.h" includes with "sys/_eventfilter.h"
in other header files (e.g., sys/{bus,conf,cpu}.h) and reduces header
pollution substantially.
EVENTHANDLER_DECLARE and EVENTHANDLER_LIST_DECLAREs were moved out of .c
files into appropriate headers (e.g., sys/proc.h, powernv/opal.h).
As a side effect of reduced header pollution, many .c files and headers no
longer contain needed definitions. The remainder of the patch addresses
adding appropriate includes to fix those files.
LOCK_DEBUG and LOCK_FILE_LINE_ARG are moved to sys/_lock.h, as required by
sys/mutex.h since r326106 (but silently protected by header pollution prior
to this change).
No functional change (intended). Of course, any out of tree modules that
relied on header pollution for sys/eventhandler.h, sys/lock.h, or
sys/mutex.h inclusion need to be fixed. __FreeBSD_version has been bumped.
On some machines, DMAR contexts must be created before all devices
under the scope of the corresponding DMAR unit are enumerated.
Current code has two problems with that:
- scope lookup returns NULL device_t, which causes to skip creating a
context with RMRR, which is fatal for the affected device.
- calculation of the final pci dbsf address fails if any bridge in the
scope is not yet enumerated, because code relies on pcib_get_bus().
Make creation of contexts work either with device_t, or with DMAR PCI
scope paths. Scope provides enough information to infer context
address, and it is directly matched against DMAR tables scopes.
When calculating bus addresses for the scope or device, use direct
pci_cfgregread(PCIR_SECBUS_1) to get the secondary bus number, instead
of pcib_get_bus().
The issue was observed on HP Gen servers, where iLO PCI devices are
located behind south bridge switch. Turning on translation without
satisfying RMRR requests caused iLO to mostly hang, up to the level of
being unusable to control the server.
While there, remove hw.dmar.dmar_match_verbose tunable, and make the
normal logging under bootverbose useful and sufficient to diagnose
DRHD and RMRR parsing and matching.
Sponsored by: Mellanox Technologies
MFC after: 1 week
Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error
prone - task.
The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.
remapping.
VT-d specification requires use of PCI rid as source id for IOAPICs
enumerated by PCI bus. The values from the DMAR ACPI table should be
only used when IOAPIC is not on PCI.
Reviewed by: jhb
Sponsored by: The FreeBSD Foundation
Hardware provided by: Intel
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D12205
Implement timeouts for register-based DMAR commands. Tunable/sysctl
hw.dmar.timeout specifies the timeout in nanoseconds, set it to zero
to allow infinite wait. Default is 1ms.
Runtime modification of the sysctl is not safe, it is allowed for
debugging.
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
acpi_GetInteger() execution. Intel DMAR interrupt remapping code
needs to know UID of the HPET to properly route the FSB interrupts
from the HPET, even when interrupt remapping is disabled, and the code
is executed under some non-sleepable mutexes.
Cache HPET UIDs in the device softc at the attach time and provide
lock-less method to get UID, use the method from the dmar hpet
handling code instead of calling GetInteger().
Reported and tested by: Larry Rosenman <ler@lerctr.org>
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
and related data structures. Contexts attach requests initiators to
domains. There is still 1:1 correspondence between contexts and
domains on the running system, since only busdma currently allocates
them, using dmar_get_ctx_for_dev().
Large part of the change is formal rename of the ctx to domain, but
patch also reworks the context allocation and free to allow for
independent domain creation.
The helper dmar_move_ctx_to_domain() is introduced for future use, to
reassign request initiator from one domain to another. The hard issue
which is not yet resolved with the context move is proper handling (or
reserving) RMRR entries in the destination domain as required by ACPI
DMAR table for moved context.
Tested by: pho
Sponsored by: The FreeBSD Foundation
translation. In particular, despite IO-APICs only take 8bit apic id,
IR translation structures accept 32bit APIC Id, which allows x2APIC
mode to function properly. Extend msi_cpu of struct msi_intrsrc and
io_cpu of ioapic_intsrc to full int from one byte.
KPI of IR is isolated into the x86/iommu/iommu_intrmap.h, to avoid
bringing all dmar headers into interrupt code. The non-PCI(e) devices
which generate message interrupts on FSB require special handling. The
HPET FSB interrupts are remapped, while DMAR interrupts are not.
For each msi and ioapic interrupt source, the iommu cookie is added,
which is in fact index of the IRE (interrupt remap entry) in the IR
table. Cookie is made at the source allocation time, and then used at
the map time to fill both IRE and device registers. The MSI
address/data registers and IO-APIC redirection registers are
programmed with the special values which are recognized by IR and used
to restore the IRE index, to find proper delivery mode and target.
Map all MSI interrupts in the block when msi_map() is called.
Since an interrupt source setup and dismantle code are done in the
non-sleepable context, flushing interrupt entries cache in the IR
hardware, which is done async and ideally waits for the interrupt,
requires busy-wait for queue to drain. The dmar_qi_wait_for_seq() is
modified to take a boolean argument requesting busy-wait for the
written sequence number instead of waiting for interrupt.
Some interrupts are configured before IR is initialized, e.g. ACPI
SCI. Add intr_reprogram() function to reprogram all already
configured interrupts, and call it immediately before an IR unit is
enabled. There is still a small window after the IO-APIC redirection
entry is reprogrammed with cookie but before the unit is enabled, but
to fix this properly, IR must be started much earlier.
Add workarounds for 5500 and X58 northbridges, some revisions of which
have severe flaws in handling IR. Use the same identification methods
as employed by Linux.
Review: https://reviews.freebsd.org/D1892
Reviewed by: neel
Discussed with: jhb
Tested by: glebius, pho (previous versions)
Sponsored by: The FreeBSD Foundation
MFC after: 3 weeks
VT-d specification. Also add definitions for the interrupt remapping
table and IEC.
Print new capabilities on boot. although there is no hardware which
support it.
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
This includes:
o All directories named *ia64*
o All files named *ia64*
o All ia64-specific code guarded by __ia64__
o All ia64-specific makefile logic
o Mention of ia64 in comments and documentation
This excludes:
o Everything under contrib/
o Everything under crypto/
o sys/xen/interface
o sys/sys/elf_common.h
Discussed at: BSDcan
Under the hood the VT-d spec is really implemented in terms of
PCI RIDs instead of bus/slot/function, even though the spec makes
pains to convert back to bus/slot/function in examples. However
working with bus/slot/function is not correct when PCI ARI is
in use, so convert to using RIDs in most cases. bus/slot/function
will only be used when reporting errors to a user.
Reviewed by: kib
MFC after: 2 months
Sponsored by: Sandvine Inc.
My PCI RID changes somehow got intermixed with my PCI ARI patch when I
committed it. I may have accidentally applied a patch to a non-clean
working tree. Revert everything while I figure out what went wrong.
Pointy hat to: rstone
Under the hood the VT-d spec is really implemented in terms of
PCI RIDs instead of bus/slot/function, even though the spec makes
pains to convert back to bus/slot/function in examples. However
working with bus/slot/function is not correct when PCI ARI is
in use, so convert to using RIDs in most cases. bus/slot/function
will only be used when reporting errors to a user.
Reviewed by: kib
Sponsored by: Sandvine Inc.
Right now, the semaphore write is scheduled after each batch, which is
not optimal and must be tuned.
Discussed with: alc
Tested by: pho
MFC after: 1 month
1.3 of Intelб╝ Virtualization Technology for Directed I/O Architecture
Specification. The Extended Context and PASIDs from the rev. 2.2 are
not supported, but I am not aware of any released hardware which
implements them. Code does not use queued invalidation, see comments
for the reason, and does not provide interrupt remapping services.
Code implements the management of the guest address space per domain
and allows to establish and tear down arbitrary mappings, but not
partial unmapping. The superpages are created as needed, but not
promoted. Faults are recorded, fault records could be obtained
programmatically, and printed on the console.
Implement the busdma(9) using DMARs. This busdma backend avoids
bouncing and provides security against misbehaving hardware and driver
bad programming, preventing leaks and corruption of the memory by wild
DMA accesses.
By default, the implementation is compiled into amd64 GENERIC kernel
but disabled; to enable, set hw.dmar.enable=1 loader tunable. Code is
written to work on i386, but testing there was low priority, and
driver is not enabled in GENERIC. Even with the DMAR turned on,
individual devices could be directed to use the bounce busdma with the
hw.busdma.pci<domain>:<bus>:<device>:<function>.bounce=1 tunable. If
DMARs are capable of the pass-through translations, it is used,
otherwise, an identity-mapping page table is constructed.
The driver was tested on Xeon 5400/5500 chipset legacy machine,
Haswell desktop and E5 SandyBridge dual-socket boxes, with ahci(4),
ata(4), bce(4), ehci(4), mfi(4), uhci(4), xhci(4) devices. It also
works with em(4) and igb(4), but there some fixes are needed for
drivers, which are not committed yet. Intel GPUs do not work with
DMAR (yet).
Many thanks to John Baldwin, who explained me the newbus integration;
Peter Holm, who did all testing and helped me to discover and
understand several incredible bugs; and to Jim Harris for the access
to the EDS and BWG and for listening when I have to explain my
findings to somebody.
Sponsored by: The FreeBSD Foundation
MFC after: 1 month