However, if the RTF_DELCLONE and RTF_WASCLONED condition passes, but the ref
count is > 1, we won't decrement the count at all. This could lead to
route entries never being deleted.
Here, we call rtfree() not only if the initial two conditions fail, but
also if the ref count is > 1 (and we therefore don't immediately delete
the route, but let rtfree() handle it).
This is an urgent MFC candidate. Thanks go to Mike Silbersack for the
fix, once again. :-)
Submitted by: Mike Silbersack <silby@silby.com>
is supposed to inform the user of all steps it would take.
The current code does not issue any messages regarding actions
that would be performed by delete_package (removing files and
executing @unexec commands), because when the Fake variable
is 1, delete_package (which itself respects Fake and prints
messages rather than taking action when it is 1) is not called
at all.
Fix this.
PR: bin/24971
Submitted by: Thomas Quinot <thomas@cuivre.fr.eu.org>
It is done by using the same ssh messages for v4 and v5 authentication
(since the ssh.com does not now anything about v4) and looking at the
contents after unpacking it to see if it is v4 or v5.
Based on code from Björn Grönvall <bg@sics.se>
PR: misc/20504
addressed to the interface on the other side of the box follow their
historical path.
Explicitly block packets sent to the loopback network sent from the outside,
which is consistent with the behavior of the forwarding path between
interfaces as implemented in in_canforward().
Always check the arrival interface when matching the packet destination
against the interface broadcast addresses. This bug allowed TCP
connections to be made to the broadcast address of an interface on the
far side of the system because the M_BCAST flag was not set because the
packet was unicast to the interface on the near side. This was broken
when the directed broadcast code was removed from revision 1.32. If
the directed broadcast code was stil present, the destination would not
have been recognized as local until the packet was forwarded to the output
interface and ether_output() looped a copy back to ip_input() with
M_BCAST set and the receive interface set to the output interface.
Optimize the order of the tests.
Reviewed by: jlemon
related code from aio_read() and aio_write(). This field was
intended, but never used, to allow a mythical user-level library to
make an aio_read() or aio_write() behave like an ordinary read() or
write(), i.e., a blocking I/O operation.
user space. It has already been copied in and mp->mnt_stat.f_mntonname has
already been initialised by the caller.
This fixes a panic on the alpha caused by the fact that the variable
'size' wasn't initialised because the call to copyinstr() bailed out with
an EFAULT error.
or comments, and some is as a result of simply documenting the
entropy harvester.
This still needs work: could a newbus guru pleazse follow up
and fix.extend my (no doubt) obvious mistakes!
bolted to a ne-2000 chip. This is necessary for the NetGear FA-410TX
and other cards.
This also requires you add mii to your kernel if you have an ed driver
configured.
This code will result in a couple of timeout messages for ed on the
impacted cards. Additional work will be needed, but this does work
right now, and many people need these cards.
Submitted by: Ian Dowse <iedowse@maths.tcd.ie>
`infrastructure' built with INVARIANT_SUPPORT for kern_mutex.c essentially
involves _mtx_assert(), which makes use of constants that were defined
under #ifdef INVARIANTS here.
