instead of a PCPU field for curthread. This averts a race on SMP systems
with a high interrupt rate where the thread looking up the value of
curthread could be preempted and migrated between obtaining the PCPU
pointer and reading the value of pc_curthread, resulting in curthread being
observed to be the current thread on the thread's original CPU. This played
merry havoc with the system, in particular with mutexes. Many thanks to
jhb for helping me work this one out.
Note that Book-E is in principle susceptible to the same problem, but has
not been modified yet due to lack of Book-E hardware.
MFC after: 2 weeks
that causes AP bringup to fail if some of the Cell HID-register code
is anywhere in the instruction stream. Pending a better solution, cache
performance on SMP Cell systems running without a hypervisor will be
suboptimal.
Kernel sources for 64-bit PowerPC, along with build-system changes to keep
32-bit kernels compiling (build system changes for 64-bit kernels are
coming later). Existing 32-bit PowerPC kernel configurations must be
updated after this change to specify their architecture.
at least on my Xserve, getting the decrementer and timebase on APs to tick
requires setting up a clock chip over I2C, which is not yet done.
While here, correct the 64-bit tlbie function to set the CPU to 64-bit
mode correctly.
Hardware donated by: grehan
new platform module. These are probed in early boot, and have the
responsibility of determining the layout of physical memory, determining
the CPU timebase frequency, and handling the zoo of SMP mechanisms
found on PowerPC.
Reviewed by: marcel, raj
Book-E parts by: raj
provided, for example, on the PowerPC 970 (G5), as well as on related CPUs
like the POWER3 and POWER4.
This also adds support for various built-in hardware found on Apple G5
hardware (e.g. the IBM CPC925 northbridge).
Reviewed by: grehan
caches if not yet enabed. This is required for coherency and
atomic operations to work, not to mention performance. We use the
L2 and L3 cache settings of the BSP to configure the APs caches.
Can't be bad.
Program NAP and not DOZE. DOZE is present only on earlier CPUs
and the bit is reserved on the MPC7441 & MPC7451. NAP will do
bus snooping to keep caches coherent.
Program the PIR with the cpuid. This may not be necessary...
common PowerPC code when all we want to achieve is to enable
external interrupts. We can set PSL_RI at any time before we
allow interrupts and/or exceptions, so move it to the AIM
specific initialization and do it when we also set PSL_ME
(machine check enable).
