where a sysctl within 20 seconds of a cache_drain could yield negative "USED"
counts.
Also, grab the uma_mtx while in the sysctl handler. This hadn't caused
problems yet because Giant is held all the time.
Reported by: kkenn
not removing tabs before "__P((", and not outdenting continuation lines
to preserve non-KNF lining up of code with parentheses. Switch to KNF
formatting and/or rewrap the whole prototype in some cases.
not removing tabs before "__P((", and not outdenting continuation lines
to preserve non-KNF lining up of code with parentheses. Switch to KNF
formatting and/or rewrap the whole prototype in some cases.
- change the IOMMU support code so that it supports overcommittting the
available DVMA memory, while still allocating as lazily as possible.
This is achieved by limiting the preallocation, and deferring the
allocation to map load time when it fails. In the latter case, the
DVMA memory reserved for unloaded maps can be stolen to free up enough
memory for loading a map.
- allow NULL settings in the method tables, and search the parent tags
until an appropriate implementation is found. This allows to remove some
kluges in the old implementation.
the bus-dependent code and to be able to support more systems. The core
of the new code is mostly obtained from NetBSD.
Kluge the interrupt routing methods of the psycho and apb drivers so
that an intline of 0 can be handled for now; real routing is still not
possible (all intline registers are preinitialized instead); this will
require a sparc64-specific adaption of the driver for generic PCI-PCI
bridges with a custom routing method to work right.
by the hardware are still marked as owned. Handle this by installing a
timeout handler to collect this descriptor to avoid having received
packets remain unhandled until the next one arrives.
- remove some useless code from the status change handler that was intended
to enable the the MII drivers for external phys; this is already done
during interface initialization, and the deleted code made some
assumptions about phy addresses that do not seem to hold true on newer
cards. This should get at least one of the two hmes of newer Netra t1
machines working.
- correct the interrupt resource allocation
- bump the number of RX descriptors, lower values cause promblems on some
machines
