NetBSD split newfs_msdos in two so that they can reuse the file system
creation part in makefs. This change is a step on the path of bringing
that support to FreeBSD.
Reviewed by: kib, pfg
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3905
Reviewed by: George Wilson <george.wilson@delphix.com>
Reviewed by: Paul Dagnelie <pcd@delphix.com>
Reviewed by: Richard Elling <Richard.Elling@RichardElling.com>
Reviewed by: Xin Li <delphij@freebsd.org>
Reviewed by: Arne Jansen <sensille@gmx.net>
Approved by: Dan McDonald <danmcd@omniti.com>
Author: Matthew Ahrens <mahrens@delphix.com>
illumos/illumos-gate@9c3fd1216f
For more info, see:
- slides http://www.slideshare.net/MatthewAhrens/openzfs-send-and-receive
- video https://www.youtube.com/watch?v=iY44jPMvxog
- manpage changes (for zfs resume -s and zfs send -t)
- upcoming talk at the OpenZFS Developer Summit
The TL;DR is:
Use "zfs receive -s" to save the partially received state on failure.
On failure, get the receive token with "zfs get receive_resume_token <fs>"
Resume the send with "zfs send -t <token_value>"
Relnotes: yes
This was causing files to be removed from the objdir when -n was used.
_worldtmp makes no sub-make calls.
A more comprehensive solution is coming involving fine-grained '+' where
appropriate.
Sponsored by: EMC / Isilon Storage Division
MFC after: 1 week
This patch adds support for the BCM57765[2] card reader function included in
Broadcom's BCM57766 ethernet/sd3.0 controller. This controller is commonly
found in laptops and Apple hardware (MBP, iMac, etc).
The BCM57765 chipset is almost fully compatible with the SD3.0 spec, but
does not support deriving a frequency below 781KHz from its default base
clock via the standard SD3.0-configured 10-bit clock divisor.
If such a divisor is set, card identification (which requires a 400KHz
clock frequency) will time out[1].
As a work-around, I've made use of an undocumented device-specific clock
control register to switch the controller to a 63MHz clock source when
targeting clock speeds below 781KHz; the clock source is likewise switched
back to the 200MHz clock when targeting speeds greater than 781KHz.
Additionally, this patch fixes a small sdhci_pci bug; the
sdhci_pci_softc->quirks flag was not copied to the sdhci_slot, resulting in
`quirk` behavior not being applied by sdhci.c.
[1] A number of Linux/FreeBSD users have noted that bringing up the chipsets'
associated ethernet interface will allow SD cards to enumerate (slowly).
This is a controller implementation side-effect triggered by the ethernet
driver's reading of the hardware statistics registers.
[2] This may also fix card detection when using the BCM57785 chipset, but I
don't have access to the BCM57785 chipset and can't verify.
I actually snagged some BCM57785 hardware recently (2012 Retina MacBook Pro)
and can confirm that this also fixes card enumeration with the BCM57785
chipset; with the patch, I can boot off of the internal sdcard reader.
PR: kern/203385
Submitted by: Landon Fuller <landon@landonf.org>
HWPMC depends on pmu.c even if device pmu is not specified.
Would be great if we could just automatically enabled "device pmu"
if we try to compile in HWPMC.
Also several old kernel cnfigurations seem to have HWPMC enabled but are
pre-FDT and thus fail. So make pmu.c depend on fdt in case of hwpmc as
well.
MFC after: 2 weeks
Sponsored by: DARPA/AFRL
Differential Revision: https://reviews.freebsd.org/D3877
Pull out read of PPD and platform detection logic to new functions,
ntb_detect_xeon(), ntb_detect_soc(). No functional change -- mostly
this is just shuffling the code to more closely match the Linux driver.
Linux commit log:
To simplify some of the platform detection code. Move the platform
detection to a function to be called earlier.
Authored by: Dave Jiang
Obtained from: Linux (Dual BSD/GPL driver)
Sponsored by: EMC / Isilon Storage Division
The doorbell registers (and associated mask) are 16-bit on Xeon but
64-bit on SoC. Abstract IO access to doorbell registers with
'db_ioread' and 'db_iowrite' (names and idea borrowed from the dual
BSD/GPL Linux driver).
Sponsored by: EMC / Isilon Storage Division
Original Linux commit log:
The NTB translate register must have the value to be BAR size aligned.
This alignment check make sure that the DMA memory allocated has the
proper alignment. Another requirement for NTB to function properly with
memory window BAR size greater or equal to 4M is to use the CMA feature
in 3.16 kernel with the appropriate CONFIG_CMA_ALIGNMENT and
CONFIG_CMA_SIZE_MBYTES set.
Authored by: Dave Jiang
Obtained from: Linux (Dual BSD/GPL driver)
Sponsored by: EMC / Isilon Storage Division
The detection of an uneven number of queues on the given memory windows
was not correct. The mw_num is zero based and the mod should be
division to spread them evenly over the mw's.
Authored by: Jon Mason
Obtained from: Linux (Dual BSD/GPL driver)
Sponsored by: EMC / Isilon Storage Division
Remap MSI-X messages over available slots rather than falling back to
legacy INTx when fewer MSI-X slots are available than were requested.
N.B. the Linux driver does *not* do this.
To aid in testing, a tunable 'hw.ntb.force_remap_mode' has been added.
It defaults to off (0). When the tunable is enabled and sufficient
slots were available, the driver restricts the number of slots by one
and remaps the MSI-X messages over the remaining slots.
In case this is actually not okay (as I don't yet have access to this
hardware to test), a tunable 'hw.ntb.prefer_intx_to_remap' has been
added. It defaults to off (0). When the tunable is enabled and fewer
slots are available than requested, fall back to legacy INTx mode rather
than attempting to remap MSI-X messages.
Suggested by: jhb
Reviewed by: jhb (earlier version)
Sponsored by: EMC / Isilon Storage Division
Consumers that registered on this bit would never see a callback and it
is likely a mistake.
This does not affect if_ntb, which limits itself to a single doorbell
callback.
The names don't line up 100% with Linux. Our routines are named
ntb_setup_interrupts, ntb_setup_xeon_msix, ntb_setup_soc_msix, and
ntb_setup_legacy_interrupt. Linux SNB = FreeBSD Xeon; Linux BWD =
FreeBSD SOC. Original Linux commit log:
This is an cleanup effort to make ntb_setup_msix() more readable - use
ntb_setup_bwd_msix() to init MSI-Xs on BWD hardware and
ntb_setup_snb_msix() - on SNB hardware.
Function ntb_setup_snb_msix() also initializes MSI-Xs the way it should
has been done - looping pci_enable_msix() until success or failure.
Authored by: Alexander Gordeev
Obtained from: Linux (Dual BSD/GPL driver)
Sponsored by: EMC / Isilon Storage Division
Provide a better event interface between the client and transport.
Authored by: Jon Mason
Obtained from: Linux (Dual BSD/GPL driver)
Sponsored by: EMC / Isilon Storage Division
This was discussed during the 10.2-RELEASE cycle, however
since we were nearing the end of the cycle, we decided to
defer this change until after 10.2-RELEASE.
Reminded by: so (delphij), jmg
MFC after: 5 days
Sponsored by: The FreeBSD Foundation
The ERL is a fairly cheap (~$100 USD) and readily available dual core
MIPS64 device so it makes a useful MIPS reference platform.
This is based in part on the kernel config generated by the mkerlimage
script from http://rtfm.net/FreeBSD/ERL/.
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3884
The 'config' target isn't really needed right now so just remove it to avoid
any clashes with config(8) building. It's also likely misspelled and should
be 'configs' if we decide to add it back. This was just a convenience
target recently added.
Sponsored by: EMC / Isilon Storage Division
Compare the fields that the AMD [1] and Intel [2] specs say will be
set once fnstenv returns.
Not all amd64 capable processors zero out the env.__x87.__other field
(example: AMD Opteron 6308). The AMD64/x64 specs aren't explicit on what the
env.__x87.__other field will contain after fnstenv is executed, so the values
in env.__x87.__other could be filled with arbitrary data depending on how the
CPU-specific implementation of fnstenv.
1. http://support.amd.com/TechDocs/26569_APM_v5.pdf
2. http://www.intel.com/Assets/en_US/PDF/manual/253666.pdf
Discussed with: kib, Anton Rang <anton.rang@isilon.com>
Reviewed by: Daniel O'Connor <darius@dons.net.au> (earlier patch; pre-generalization)
MFC after: 1 week
Sponsored by: EMC / Isilon Storage Division
Reported by: Bill Morchin <wmorchin@isilon.com>
To me that seems broken as certain interrupts will never be handled
properly. I'll re-open D3877 and we can seek a better solution and
try again. For now go back to that state and avoid compile time errors.
image.
The dynamic linker still requires that program headers of the
executable or dso are mapped by a PT_LOAD segment.
Reviewed by: emaste, jhb
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D3871
executable image. Keep one page (arbitrary) limit on the max allowed
size of the PT_NOTES.
The ELF image activators still require that program headers of the
executable are fully contained in the first page of the image file.
Reviewed by: emaste, jhb
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D3871
according to the Cortex-A8 TRM r3p2 section 3.2.49.
The A8 list differs from the "ARM-v7 common" list, given the A8
was an earlier model.
There is still more work to be done for other Cortex-Ax version as
andrew points out, but I am just trying to fix A8 for now for teaching.
MFC after: 2 weeks
Sponsored by: DARPA/AFRL
Obtained from: Cambridge/L41
Reviewed by: andrew
Differential Revision: https://reviews.freebsd.org/D3876
Would be great if we could just automatically enabled "device pmu"
if we try to compile in HWPMC.
MFC after: 2 weeks
Sponsored by: DARPA/AFRL
Reviewed by: andrew
Differential Revision: https://reviews.freebsd.org/D3877
In certain configurations (mostly but not exclusively as a VM on Xen) pf
produced packets with an invalid TCP checksum.
The problem was that pf could only handle packets with a full checksum. The
FreeBSD IP stack produces TCP packets with a pseudo-header checksum (only
addresses, length and protocol).
Certain network interfaces expect to see the pseudo-header checksum, so they
end up producing packets with invalid checksums.
To fix this stop calculating the full checksum and teach pf to only update TCP
checksums if TSO is disabled or the change affects the pseudo-header checksum.
PR: 154428, 193579, 198868
Reviewed by: sbruno
MFC after: 1 week
Relnotes: yes
Sponsored by: RootBSD
Differential Revision: https://reviews.freebsd.org/D3779
On each resolver query, use stat(2) to see if the modification time
of /etc/resolv.conf has changed. If so, reload the file and reinitialize
the resolver library. However, only call stat(2) if at least two seconds
have passed since the last call to stat(2), since calling it on every
query could kill performance.
This new behavior is enabled by default. Add a "reload-period" option
to disable it or change the period of the test.
Document this behavior and option in resolv.conf(5).
Polish the man page just enough to appease igor.
https://lists.freebsd.org/pipermail/freebsd-arch/2015-October/017342.html
Reviewed by: kp, wblock
Discussed with: jilles, imp, alfred
MFC after: 1 month
Relnotes: yes
Sponsored by: Dell Inc.
Differential Revision: https://reviews.freebsd.org/D3867
Reviewed by: George Wilson <george.wilson@delphix.com>
Reviewed by: Paul Dagnelie <pcd@delphix.com>
Reviewed by: Richard Elling <Richard.Elling@RichardElling.com>
Reviewed by: Xin Li <delphij@freebsd.org>
Reviewed by: Arne Jansen <sensille@gmx.net>
Approved by: Dan McDonald <danmcd@omniti.com>
Author: Matthew Ahrens <mahrens@delphix.com>
illumos/illumos-gate@9c3fd1216f
Reviewed by: Richard Yao <ryao@gentoo.org>
Reviewed by: Xin LI <delphij@freebsd.org>
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Approved by: Richard Lowe <richlowe@richlowe.net>
Author: Justin T. Gibbs <gibbs@FreeBSD.org>
illumos/illumos-gate@d2058105c6
Reviewed by: Richard Yao <ryao@gentoo.org>
Reviewed by: Xin LI <delphij@freebsd.org>
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Approved by: Richard Lowe <richlowe@richlowe.net>
Author: Justin T. Gibbs <gibbs@FreeBSD.org>
illumos/illumos-gate@d2058105c6
Reviewed by: George Wilson <george.wilson@delphix.com>
Reviewed by: Prakash Surya <prakash.surya@delphix.com>
Reviewed by: Richard Elling <Richard.Elling@RichardElling.com>
Approved by: Richard Lowe <richlowe@richlowe.net>
Author: Matthew Ahrens <mahrens@delphix.com>
illumos/illumos-gate@8fe00bfb87
