in elf_cpu_load_file(). The only time when the sync is needed is after
kernel module is loaded and the relocation info is processed. And it's
done in elf_cpu_load_file().
This allows, for example, UEFI pass a memory map with some ram in this
region, but for us to ignore it. This is the case when running under the
qemu virt machine type.
Sponsored by: ABT Systems Ltd
Allows for using hardware watchpoints for 1, 2, 4, 8 byte long addresses.
The default configuration of watchpoint is RW but code allows to select
RO or WO and X.
Since debugging registers are per-CPU (CP14) the watchpoint is set on
the CPU that was lucky (or not) to enter DDB.
HW breakpoints are used to perform single step in KDB.
When HW breakpoint is enabled all watchpoints are temporary disabled
to avoid recursive abort on both watchpoint and breakpoint.
In case of branch, the breakpoint is set to both - next instruction
and possible branch address. This requires at least 2 breakpoints
supported in the CPU however this is a must for ARMv6/v7 CPUs.
Reviewed by: imp
Submitted by: Zbigniew Bodek <zbb@semihalf.com>
Obtained from: Semihalf
Sponsored by: Juniper Networks Inc.
Differential Revision: https://reviews.freebsd.org/D4037
Even if data cache maintenance was done by IO code, the relocation
fixup process creates dirty cache entries that we must write back
before doing icache sync.
Reported by: Thiagarajan Venkatasubramanian <tvenkata at juniper.net>
Reviewed by: ian
pmap implementations on ARM. This way minidump code can be used without
any platform specific modification.
Also, this is the last piece missing for ARM_NEW_PMAP.
Differential Revision: https://reviews.freebsd.org/D5023
* Use the ARM PLATFORM framework
* Use ARM_INTRNG on teh A20 as it has a GICv2
* Add a method to find which Allwinner SoC we are running on
Differential Revision: https://reviews.freebsd.org/D5059
This is a stub for PMSU driver. Note that it cannot be used to set the
secondary core boot address during attach because drivers are attached
later than SI_SUB_CPU sysinit where cores are started.
Setting the boot address should be done manually in platform_mp_start_ap().
SMP is working fine with this commit and was enabled in Armada38x kernel
configuration file.
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Michal Stanek <mst@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4427
- Add file sys/arm/mv/armada38x/armada38x_mp.c
- Set mp_maxid and mp_ncpus based on FDT unless SCU register indicates
only one core
- Boot CPU1 in platform_mp_start_ap()
- IPI range defined
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Michal Stanek <mst@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4426
CPU1 is halted in bootROM code while it is waiting to be released.
Memory window to bootROM must be opened before booting the core.
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Michal Stanek <mst@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4425
With this commit, watchdog is supported only in case of having
"mrvl,has-wdt" property or dedicated for watchdog compatibility field
("marvell,armada-380-wdt"). There is no need to modify dts files,
as "has-wdt" property already exists.
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4424
A38X watchdog support was implemented in sys/arm/mv/timer.c driver.
It required following modifications:
- add "marvell,armada-380-wdt" compatibility, which supports only watchdog
- correct and enhance definitions related to timer control register
- unmask reset capability in RSTOUTn_MASK register
- use dedicated watchdog timer on A38X instead of second timer
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4423
New driver registers RTC as system clock. New RTC resolution is 1 sec.
Settime and gettime functions were implemented.
Reviewed by: andrew, ian
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Jan Dabros <jsd@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4421
Invalid (in FreeBSD) definition of PCI controller was
replaced with another one, working in FreeBSD environment.
PCI controller's entry had to move from its parent node
so as to be recognized properly by FBSD.
PCI was enabled in kernel configuration file.
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4379
mv_pci driver omitted slot 0, which can be valid device on Armada38x.
New mechanism detects if device is root link, basing on vendor's
and device's IDs.
It is restricted to Armada38x; on other machines, behaviour remains
the same.
Reviewed by: andrew
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4377
Add conditions corresponding to Armada38x-based SoCs,
enhancing their remap capabilities.
This is required for PCIe to work properly.
Reviewed by: andrew
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4376
With this commit, USB 2.0 works fine on Armada38x platforms.
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4375
Add gic_decode_fdt function to fdt_pic_table, allowing to recognize GIC
interrupts on Armada38x. SOC_MV_ARMADA38X ifdef is required because A38X
is the only Marvell's platform in FreeBSD using GIC; lack of ifdef would
lead to linking errors on other platforms.
Reviewed by: andrew, ian, imp
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Michal Stanek <mst@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4214
Strict compatibility requirement is a root of problems when simplebus'
node has two compatibility strings (i.e. on Armada38x). Removing this
requirement should not interfere with other platforms.
fdt_is_compatible_strict() and fdt_find_compatible() calls were changed
in fdt_common.c and mv_common.c.
Reviewed by: ian, imp
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4602
This commit introduces initial support for Marvell Armada38x platform.
Changes:
- Add common DTS files for Armada38x SoCs and DTS file for A388-GP
- Add ARMADA38X kernel configuration
- Add option SOC_MV_ARMADA38X and set MV_PCI_PORTS
- Add list of files to compile
- Implement get_tclk(), get_sar_value(), cpu_reset() functions
- Add CPU ID and SoC numbers
- Correct ifdefs in arm/mv/timer.c
Reviewed by: ian, imp
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Michal Stanek <mst@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4210
Including arm/mv/gpio.c now depends on 'gpio' device. 'device gpio' was
added to all kernconf files of Marvell boards, except ARMADAXP (dummy
mv_gpio_res definition was removed) and ARMADA38X (not supported yet).
This commit allows to use generic files.mv on A38X.
Reviewed by: andrew
Obtained from: Semihalf
Sponsored by: Stormshield
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D4372
underflow when we have small blocks of memory at the start and end of the
32-bit address range.
While here, only insert mappings pointing at a non-zero amount of memory.
Sponsored by: ABT Systems Ltd
problem affects revision 1xx hardware as well as later versions. Also, the
recommended workaround is to set the PDC count register for a 12-byte
transfer when the actual size is less than that, but there is no need to
extend or zero-out the data buffer, because the blklen register contains
the real transfer size and only that many bytes will be transferred.
Also add a sysctl to turn debugging printfs on or off on the fly.
problem that led to this temporary workaround (and also so I can properly
cite the PR in the commit this time).
In general this is intended to be a temporary workaround until we can figure
out why including any ram from the last megabyte of the physical address
space leads to a NULL pointer deref. Debugging that is made trickier by the
fact that I couldn't even get a backtrace in ddb.
PR: 201614
