This fix booting on A64 boards when disabling the unused regulators at boot.
We did disable all the regulator handled by register 0x13 which of course contain
mandatory regulators for the board to be up.
Reported by: Mark Millard <marklmi@yahoo.com>
X-MFC-With: r340848
icu is a interrupt concentrator in the CP110 block and gicp
is a gic extension to allow interrupts in the CP block to be turned
into GIC SPI interrupts
Sponsored by: Rubicon Communications, LLC ("Netgate")
The cp110 clock controller controls the clocks and gate of the CP110
hardware block.
Every clock/gate are implemented except the NAND clock.
Sponsored by: Rubicon Communications, LLC ("Netgate")
The first two clocks are for the clusters and their frequencies can be
found reading a register. Then a fixed 1200Mhz clock is present and two
fixed clocks, 'mss' which is 1200 / 6 and 'sdio' which is 1200 / 3.
Sponsored by: Rubicon Communications, LLC ("Netgate")
On some architectures, the structures returned by PT_GET*REGS were not
fully populated and could contain uninitialized stack memory. The same
issue existed with the register files in procfs.
Reported by: Thomas Barabosch, Fraunhofer FKIE
Reviewed by: kib
MFC after: 3 days
Security: kernel stack memory disclosure
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D18421
Add generic implementation for bus_deactivate_resource method. Without
it bus_release_resource fails with "Failed to release active resource"
message
MFC after: 1 week
Fix reporting of SS_ONSTACK in nested signal delivery when sigaltstack()
is used on some architectures.
Add a unit test for this. I tested the test by introducing the bug
on amd64. I did not test it on other architectures.
Reviewed by: kib
MFC after: 2 weeks
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D18347
On arm64 and riscv platforms, sendsig() failed to zero the signal
frame before copying it out to userspace. Zero it.
On arm, I believe all the contents of the frame were initialized,
so there was no disclosure. However, explicitly zero the whole frame
because that fact could inadvertently change in the future,
it's more clear to the reader, and I could be wrong in the first place.
MFC after: 2 days
Security: similar to FreeBSD-EN-18:12.mem and CVE-2018-17155
Sponsored by: Dell EMC Isilon
Instead of routing the phy when enabling it, do the configuration
and routing in the phynode_usb_set_mode function.
While here, if we don't have a vbus detection method, enable the phy
if requested.
MFC after: 1 month
On arm64 (where INTRNG is enabled), the interrupts have to be mapped
with ACPI_BUS_MAP_INTR() before adding them as resources to devices.
The earlier code did the mapping before calling acpi_set_resource(),
which bypassed code that checked for PCI link interrupts.
To fix this, move the call to map interrupts into acpi_set_resource()
and that requires additional work to lookup interrupt properties.
The changes here are to:
* extend acpi_lookup_irq_handler() to lookup an irq in the ACPI
resources
* create a helper function acpi_map_intr() which uses the updated
acpi_lookup_irq_handler() to look up an irq, and then map it
with ACPI_BUS_MAP_INTR()
* use acpi_map_intr() in acpi_pcib_route_interrupt() to map
pci link interrupts.
With these changes, we can drop the ifdefs in acpi_resource.c, and
we can also drop the call for mapping interrupts in generic_timer.c
Reviewed by: andrew
Differential Revision: https://reviews.freebsd.org/D17790
recent changes in spibus and allow the use of different SPI modes on
the same bus.
Reported by: ian
Sponsored by: Rubicon Communications, LLC (Netgate)
r306041 changed ld invocations for converting binary files to kernel
ELF objects to pass -m, but missed bespoke ld invocations in a pair of
arm file configs (one of which has since been removed).
This is needed to support some external toolchains and lld.
Sponsored by: The FreeBSD Foundation
Replace a call to DELAY(1) with a new cpu_lock_delay() KPI. Currently
cpu_lock_delay() is defined to DELAY(1) on all platforms. However,
platforms with a DELAY() implementation that uses spin locks should
implement a custom cpu_lock_delay() doesn't use locks.
Reviewed by: kib
MFC after: 3 days
Existing base causes conflicts for direct execution of ld-elf.so.1
because default linking base for non-PIE binaries is 0x10000.
Reported and tested by: Mark Millard <marklmi26-fbsd@yahoo.com>
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Add a new 'debugger_on_trap' knob separate from 'debugger_on_panic'
and make the calls to kdb_trap() in MD fatal trap handlers prior to
calling panic() conditional on this new knob instead of
'debugger_on_panic'. Disable the new knob by default. Developers who
wish to recover from a fatal fault by adjusting saved register state
and retrying the faulting instruction can still do so by enabling the
new knob. However, for the more common case this makes the user
experience for panics due to a fatal fault match the user experience
for other panics, e.g. 'c' in DDB will generate a crash dump and
reboot the system rather than being stuck in an infinite loop of fatal
fault messages and DDB prompts.
Reviewed by: kib, avg
MFC after: 2 months
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D17768
The loader tunable 'debug.verbose_sysinit' may be used to toggle verbosity.
This is added to the debugging section of these kernconfs to be turned off
in stable branches for clarity of intent.
MFC after: never
All platforms except powerpc use the same values and powerpc shares a
majority of them.
Go ahead and declare AT_NOTELF, AT_UID, and AT_EUID in favor of the
unused AT_DCACHEBSIZE, AT_ICACHEBSIZE, and AT_UCACHEBSIZE for powerpc.
Reviewed by: jhb, imp
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D17397
In the FDT based probe, check for "arm,armv8-timer" before "arm,armv7-timer".
This gets the description right when the timer node has both entries in
compatible list.
(e.g. RocketChip, lowRISC and derivatives).
RISC-V page table entries support A (accessed) and D (dirty) bits. The
spec makes hardware support for these bits optional. Implementations that
do not manage these bits in hardware raise page faults for accesses to a
valid page without A set and writes to a writable page without D set.
Check for these types of faults when handling a page fault and fixup the
PTE without calling vm_fault if they occur.
Reviewed by: jhb, markj
Approved by: re (gjb)
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D17424
We ought to be consistent across our Tier-1 and nearly-Tier-1
architectures, so enable Capsicum for 32-bit armv6/armv7 by default.
PR: 204008
Reviewed by: ian, oshogbo
Approved by: re (gjb)
Relnotes: Yes
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D17023
These limits are hit on the ThunderX. Also make
arm_physmem_exclude_region() panic rather than fail silently if the
limit on excluded regions is reached.
PR: 231064
Reviewed by: andrew
Approved by: re (kib)
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D17073
To support INTRNG with ACPI we need to set a non-zero cross reference value
for the interrupt controller. The GICv3 driver already had this value set,
however it was missed in the GICv2 driver. Fix this by setting xref to the
correct value.
Approved by: re (gjb)
Same as r333305, with Linux 4.17 dts the compatible for the prcm added
'simplebus', it mean that the simplebus driver will attach to it
at the BUS_PASS_BUS pass.
Change the pass for the prcm driver to be at BUS_PASS_BUS so we will win
the attach.
This introduce a problem as this driver needs the omap_scm one to be already
attached. omap_scm also attach at BUS_PASS_BUS but after the prcm one as it is
after in the dtb and the simplebus driver simpy walk the tree to attach it's
children.
Use the bus_new_pass method to defer the frequencies read at BUS_PASS_TIMER.
This fixes booting on pandaboard
Approved by: re (rgrimes)
Fix the build of the GENERIC-MMCCAM kernel config after the sdhci_xenon
driver was commited.
While here correct sdhci_fdt and tegra_sdhci, even with MMCCAM they do
need to depend on sdhci(4)
Reported by: Reshetnikov Dmitriy <genserg@hotmail.com>
Approved by: re (kib)
Sponsored by: Rubicon Communications, LLC ("NetGate")
Exposing max_offset and min_offset defines in public headers is
causing clashes with variable names, for example when building QEMU.
Based on the submission by: royger
Reviewed by: alc, markj (previous version)
Sponsored by: The FreeBSD Foundation (kib)
MFC after: 1 week
Approved by: re (marius)
Differential revision: https://reviews.freebsd.org/D16881
Previously we have been lucky where the state was already in r0, however
this is not guaranteed. Use the passed in register as the location to
store the upper half of the arm VFP registers rather than relying on it
being r0.
Approved by: re (kib)
given in random(4).
This includes updating of the relevant man pages, and no-longer-used
harvesting parameters.
Ensure that the pseudo-unit-test still does something useful, now also
with the "other" algorithm instead of Yarrow.
PR: 230870
Reviewed by: cem
Approved by: so(delphij,gtetlow)
Approved by: re(marius)
Differential Revision: https://reviews.freebsd.org/D16898
error in the function hypercall_memfree(), where the wrong arena was being
passed to kmem_free().
Introduce a per-page flag, VPO_KMEM_EXEC, to mark physical pages that are
mapped in kmem with execute permissions. Use this flag to determine which
arena the kmem virtual addresses are returned to.
Eliminate UMA_SLAB_KRWX. The introduction of VPO_KMEM_EXEC makes it
redundant.
Update the nearby comment for UMA_SLAB_KERNEL.
Reviewed by: kib, markj
Discussed with: jeff
Approved by: re (marius)
Differential Revision: https://reviews.freebsd.org/D16845
