Several files use the internal name of `struct device` instead of
`device_t` which is part of the public API. This patch changes all
`struct device *` to `device_t`.
The remaining occurrences of `struct device` are those referring to the
Linux or OpenBSD version of the structure, or the code is not built on
FreeBSD and it's unclear what to do.
Submitted by: Matthew Macy <mmacy@nextbsd.org> (previous version)
Approved by: emaste, jhibbits, sbruno
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D7447
And factor out tcp_lro_rx_done, which deduplicates the same logic with
netinet/tcp_lro.c
Reviewed by: gallatin (1st version), hps, zbb, np, Dexuan Cui <decui microsoft com>
Sponsored by: Microsoft OSTC
Differential Revision: https://reviews.freebsd.org/D5725
Prevent ixgbe outputting "Invalid advertised speed" warning on boot with
no customisations by moving test from sysctl handler to set handler.
PR: 208022
MFC after: 3 days
Sponsored by: Multiplay
also for 82598, which doesn't support it.
The legacy code has a check for it, which was missed when the code for dealing with
CSUM_IP6_* was added. Add the same check for FreeBSD 10 and higher.
Differential Revision: https://reviews.freebsd.org/D5192
Fix ixgbe reporting of flow control autoneg when running under DBG 1
Reviewed by: erj
MFC after: 2 days
Sponsored by: Multiplay
Differential Revision: https://reviews.freebsd.org/D5089
Setup phy and gbic power as per Linux 4.3.13 driver.
This fixes link not detected on X540-AT2 after booting to Linux which turns
the phy power off on detach.
Reviewed by: sbruno
MFC after: 2 days
Sponsored by: Multiplay
Differential Revision: https://reviews.freebsd.org/D5107
Added hw.ix.flow_control which enables the default flow_control of all ix
interfaces to be set in loader.conf.
Added hw.ix.advertise_speed which enables the default advertised_speed of
all ix interfaces to be set in loader.conf.
Made enable_aim device independent based on hw.ix.enable_aim default.
Reviewed by: erj
MFC after: 1 week
Sponsored by: Multiplay
Differential Revision: https://reviews.freebsd.org/D5060
When ifconfig sets media then the values displayed by the advertise_speed
value are invalidated.
Fix this by setting the bits correctly including setting advertise to 0 for
media = auto.
Reviewed by: sbruno
MFC after: 1 week
Sponsored by: Multiplay
Differential Revision: https://reviews.freebsd.org/D5034
- Add optimizing LRO wrapper which pre-sorts all incoming packets
according to the hash type and flowid. This prevents exhaustion of
the LRO entries due to too many connections at the same time.
Testing using a larger number of higher bandwidth TCP connections
showed that the incoming ACK packet aggregation rate increased from
~1.3:1 to almost 3:1. Another test showed that for a number of TCP
connections greater than 16 per hardware receive ring, where 8 TCP
connections was the LRO active entry limit, there was a significant
improvement in throughput due to being able to fully aggregate more
than 8 TCP stream. For very few very high bandwidth TCP streams, the
optimizing LRO wrapper will add CPU usage instead of reducing CPU
usage. This is expected. Network drivers which want to use the
optimizing LRO wrapper needs to call "tcp_lro_queue_mbuf()" instead
of "tcp_lro_rx()" and "tcp_lro_flush_all()" instead of
"tcp_lro_flush()". Further the LRO control structure must be
initialized using "tcp_lro_init_args()" passing a non-zero number
into the "lro_mbufs" argument.
- Make LRO statistics 64-bit. Previously 32-bit integers were used for
statistics which can be prone to wrap-around. Fix this while at it
and update all SYSCTL's which expose LRO statistics.
- Ensure all data is freed when destroying a LRO control structures,
especially leftover LRO entries.
- Reduce number of memory allocations needed when setting up a LRO
control structure by precomputing the total amount of memory needed.
- Add own memory allocation counter for LRO.
- Bump the FreeBSD version to force recompilation of all KLDs due to
change of the LRO control structure size.
Sponsored by: Mellanox Technologies
Reviewed by: gallatin, sbruno, rrs, gnn, transport
Tested by: Netflix
Differential Revision: https://reviews.freebsd.org/D4914
This helps immensily with our ability to operate in the Amazon Cloud.
Discussed on Intel Networking Community call this morning.
Submitted by: Jarrod Petz(petz@nisshoko.net)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D4788
the system is booted and running.
Add PHY detection logic to ixgbe_handle_mod() and add locking to
ixgbe_handle_msf() as well.
PR: 150251
Submitted by: aboyer@averesystems.com
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D3188
Add support for two new devices: X552 SFP+ 10 GbE, and the single port
version of X550T.
Submitted by: erj
Reviewed by: gnn
Sponsored by: Intel Corporation
Differential Revision: https://reviews.freebsd.org/D4186
an if_ixv instance can now set at creation time, and the receive ring
tail pointer is correctly initialized (previously, things still worked
because the receive ring tail pointer was being fixed up as a side
effect of other activity).
Differential Revision: https://reviews.freebsd.org/D2922
Reviewed by: erj, gnn
Approved by: jmallett (mentor)
Sponsored by: Norse Corp, Inc.
not. When doing multiqueue, we are all setup to have full 32bit RSS hash from
the card. We do not need to hide that under "ifdef RSS" and should expose that
by default so others like lagg(4) can use that and avoid hashing the traffic by
themselves.
While here, delete the FreeBSD version check and use of deprecated M_FLOWID.
Reviewed by: adrian, erj
MFC after: 1 week
Sponsored by: Limelight Networks
This commit contains large contributions from Giuseppe Lettieri and
Stefano Garzarella, is partly supported by grants from Verisign and Cisco,
and brings in the following:
- fix zerocopy monitor ports and introduce copying monitor ports
(the latter are lower performance but give access to all traffic
in parallel with the application)
- exclusive open mode, useful to implement solutions that recover
from crashes of the main netmap client (suggested by Patrick Kelsey)
- revised memory allocator in preparation for the 'passthrough mode'
(ptnetmap) recently presented at bsdcan. ptnetmap is described in
S. Garzarella, G. Lettieri, L. Rizzo;
Virtual device passthrough for high speed VM networking,
ACM/IEEE ANCS 2015, Oakland (CA) May 2015
http://info.iet.unipi.it/~luigi/research.html
- fix rx CRC handing on ixl
- add module dependencies for netmap when building drivers as modules
- minor simplifications to device-specific routines (*txsync, *rxsync)
- general code cleanup (remove unused variables, introduce macros
to access rings and remove duplicate code,
Applications do not need to be recompiled, unless of course
they want to use the new features (monitors and exclusive open).
Those willing to try this code on stable/10 can just update the
sys/dev/netmap/*, sys/net/netmap* with the version in HEAD
and apply the small patches to individual device drivers.
MFC after: 1 month
Sponsored by: (partly) Verisign, Cisco
NOTE: This is a technology preview, while it has undergone
development testing, Intel has not yet completed full
validation of the feature. It is being integrated for
early access and customer testing.
NOTE: This is a technology preview, while it has undergone development
tests, Intel has not yet completed full validation of the feature.
It is being integrated for early access and customer testing.
These include standalone X550 adapters, X552 10GbE backplane, and
X552/X557-AT 10GBASE-T; with the latter two being integrated into Xeon D SoCs.
As well, this bumps the ixgbe version number to 2.8.3, and includes updates
to shared code for support for the new devices.
Differential Revision: D2414
Reviewed by: gnn, adrian
Approved by: jfv (mentor), gnn (mentor)
- Use hardware counters for ifnet stats in igb(4) when possible. This
ensures these stats include packets that bypass the regular stack via
netmap.
- Don't derefence values off the end of the igb(4) VF stats structure.
Instead, add a dedicated if_get_counter method for igb(4) VF interfaces.
- Report missed packets on igb(4) as input queue drops rather than an
input error.
- Report bug_ring drop counts as output queue drops for igb(4) and ixgbe(4).
- Export the buf_ring drop stats for individual rings via sysctl on
ixgbe(4).
- Fix a typo that in ixl(4) that caused output queue drops to be reported
as input queue drops and input queue drops to be unreported.
Differential Revision: https://reviews.freebsd.org/D2402
Reviewed by: jfv, rstone (6)
Sponsored by: Norse Corp, Inc.
- bus_dmamap_create() does not take the BUS_DMA_NOWAIT flag
- properly unload maps
- do not assign NULL to dma map pointers
Submitted by: Konstantin Belousov <kostikbel@gmail.com>
Approved by: jfv (mentor)
MFC after: 1 week
* Fix the multiple same-named devclasses; the duplicate name
trips up the linker.
* Re-do the taskqueue stuff to use the new cpuset API, not the old
pinned API.
* Add includes for the new location of the RSS configuration routines.
This allows ixgbe to compile as a module /and/ linked into the kernel,
along with RSS working.
Sponsored by: Norse Corp, Inc.
- Split the driver into independent pf and vf loadables. This is
in preparation for SRIOV support which will be following shortly.
This also allows us to keep a seperate revision control over the
two parts, making for easier sustaining.
- Make the TX/RX code a shared/seperated file, in the old code base
the ixv code would miss fixes that went into ixgbe, this model
will eliminate that problem.
- The driver loadables will now match the device names, something that
has been requested for some time.
- Rather than a modules/ixgbe there is now modules/ix and modules/ixv
- It will also be possible to make your static kernel with only one
or the other for streamlined installs, or both.
Enjoy!
Submitted by: jfv and erj
The optimization made in r239940 is valid for struct mbuf's current structure
and size in FreeBSD, but hardcodes assumptions about sizes of struct mbuf,
which are unfortunately broken if additional data is added to the beginning of
struct mbuf
X-MFC note (discussed with rwatson):
This change requires the MPKTHSIZE definition, which is only available after
head@r277203 and will not be MFCed as it breaks mbuf(9) KPI.
A direct commit to stable/10 and merges to other branches to add the necessary
definitions to work with the code as-is will be done to facilitate this MFC
PR: 194314
MFC after: 2 weeks
Approved/Reviewed by: erj, jfv
Sponsored by: EMC / Isilon Storage Division
