the resource table to locate children. The 'at ppbus?' can go again.
Remove a few #if Nxxx > 0' type things, config arranges this for us.
Move the newbus method glue next to the DRIVER_MODULE() stuff so we
don't need extra prototypes.
Don't set device descriptions until after the possibility of the probe
returning an error.
Remove all cdevsw_add() calls, all the drivers that did this also use
make_dev() correctly, so it's not required.
A couple of other minor nits.
has been made obsolete by the block/char device merging.
Reflect this change in the manual page and fix the usage of a
backslash in ``e.g.''.
Reviewed by: bright, sheldonh, phk
the need to specify the unit number of unwired devices. ie: instead
of saying "device fxp0" we can say "device fxp" which is much closer
to what it actually means. The former (fxp0) implied something about
reserving the 0th unit, but it does not and never did - it was a
figment of config(8)'s imagination that we had to work around..
"device fxp0" simply means "compile in the fxp device driver", so we
may as well just write it as "device fxp" which is closer to what it
really means.
Doing this also saves us from filling up the ioconf.c tables with
meaningless entries.
isa_device->id_ri_flags and RI_FAST were not implemented and did nothing.
The two drivers that were mistakenly thinking this was working were
cy.c and loran.c - these should be converted to newbus.
GC (garbage collect) isa_device->id_alive
GC userconfig.c references to isa_device->id_scsiid (!).
that it does not reset the printer when opened. This fixes the problem
of printing a document almost till the end and then resetting the
printer when the next print job is started.
Submitted by: Christopher Masto <chris@netmonger.net>
Also, remove all but the ums0 device from the fixit target 'to save
precious i-nodes on the fixit floppy'.
Fix a long-standing bug where I used a 'break;' instead of a 'continue;';
you had to have multiple ISA boards in non-PnP mode with an 'unknown' board
with a lower MAC address to find this one. Since I have 4 3c5x9 boards
in my test box I was somewhat confused when this happened. :)
Make the messages printed by ep_isa_identify() a little more consistent;
we'll only see them in verbose boot mode but it makes me feel better if
they look nice.
Also, while I'm here, add a mechanism to catch unknown board IDs that
are likely to be 3c509s and allow them to be attached.
PR: kern/16304
Submitted by: Kelly Yancey <kbyanc@posi.net>
