The Portsnap buildbox now generates teh bits needed for portsnap to produce
INDEX-8; and it hasn't built INDEX-5 for a long time, although the bits are
still distributed for an INDEX-5 from when FreeBSD 5.x reached its EoL.
Approved by: re (kib)
MFC after: 3 days (INDEX-8 addition only)
- Allow loopback route to be installed for address assigned to
interface of IFF_POINTOPOINT type.
- Install loopback route for an IPv4 interface addreess when the
"useloopback" sysctl variable is enabled. Similarly, install
loopback route for an IPv6 interface address when the sysctl variable
"nd6_useloopback" is enabled. Deleting loopback routes for interface
addresses is unconditional in case these sysctl variables were
disabled after an interface address has been assigned.
Reviewed by: bz
Approved by: re
old ABI versions of the relevant control system call (e.g.
freebsd7_freebsd32_msgctl() instead of freebsd32_msgctl() for msgsys()).
Approved by: re (kib)
panic when in zfs_fuid_create_cred() when userid is negative. It is
converted to unsigned value which makes IS_EPHEMERAL() macro to
incorrectly report that this is ephemeral ID. The most reasonable
solution for now is to always report that the given ID is not ephemeral.
PR: kern/132337
Submitted by: Matthew West <freebsd@r.zeeb.org>
Tested by: Thomas Backman <serenity@exscape.org>, Michael Reifenberger <mike@reifenberger.com>
Approved by: re (kib)
MFC after: 2 weeks
* don't clobber proxy entries
* HWMP seq number processing, including discard of old frames
* flush routing table entries based on nexthop
* print route flags in ifconfig
* more debugging messages and comments
Proxy changes submitted by sam.
Approved by: re (kib)
requesting IDENTIFY from slave device first. This order is important
for proper cable type detection by master device.
PR: kern/136438
Approved by: re (kib)
things a bit:
- use dpcpu data to track the ifps with packets queued up,
- per-cpu locking and driver flags
- along with .nh_drainedcpu and NETISR_POLICY_CPU.
- Put the mbufs in flight reference count, preventing interfaces
from going away, under INVARIANTS as this is a general problem
of the stack and should be solved in if.c/netisr but still good
to verify the internal queuing logic.
- Permit changing the MTU to virtually everythinkg like we do for loopback.
Hook epair(4) up to the build.
Approved by: re (kib)
(ifconfig ifN (-)vnet <jname|jid>) work correctly.
Move vi_if_move to if.c and split it up into two functions(*),
one for each ioctl.
In the reclaim case, correctly set the vnet before calling if_vmove.
Instead of silently allowing a move of an interface from the current
vnet to the current vnet, return an error. (*)
There is some duplicate interface name checking before actually moving
the interface between network stacks without locking and thus race
prone. Ideally if_vmove will correctly and automagically handle these
in the future.
Suggested by: rwatson (*)
Approved by: re (kib)
- fix ifconfig to ignore the non-existent interface in the current
network stack in case of '-vnet'.
- in ifconfig: actually use the local variables defined for the
vnet functions rather than modifying the global.
Reviewed by: rwatson
Approved by: re (kib)
but returned them incorrectly, causing tar to actually
erase the resulting file while trying to restore the
link. This one-line fix corrects the hardlink descriptions
to avoid this problem.
Thanks to Jung-uk Kim for pointing this out.
Approved by: re (kib)
restrictions) were found to be inadequately described by a boolean.
Define a new parameter type with three values (disable, new, inherit)
to handle these and future cases.
Approved by: re (kib), bz (mentor)
Discussed with: rwatson
to 'Expert Mode', to make it less confusing to new users, to whom
a 'wizard' is a set of simple dialogs with the 'next >>>' button.
Approved by: re (kensmith)
ability to retrieve the group list of each process.
Modify procstat's -s option to query this mib when the kinfo_proc
reports that the field has been truncated. If the mib does not exist,
fall back to the truncated list.
Reviewed by: rwatson
Approved by: re (kib)
MFC after: 2 weeks
- When a vlan event occurs a check was not made that
the event was actually for the interface, thus resulting
in a panic. All three drivers have this vulnerability. Add
a check for this condition.
- Secondly, there was a duplicate buf_ring free in the em
driver resulting in a panic on unload. Remove.
Approved by: re
part that is made up of 8K banks rather than 4K, if these
systems are using bank 1 then the last change in this code
breaks the bank read, resulting in an invalid checksum of
the eeprom during driver load. This change fixes this.
Approved by: re
o do not force monitor mode; the wlanX ifnet must be an ahdemo mode vap
o move channel change work before marking ifnet up to avoid churning
the state machine
o change default ifnet name to "wlan0"
Approved by: re (kensmith)
frequency w/o regulatory issues, do this by hooking if_transmit and
if_output with routines that discard all transmits
Reviewed by: thompsa, cbzimmer (intent)
Approved by: re (kensmith)
in up to 16 (KI_NGROUPS) values and steal a bit from ki_cr_flags
(all bits currently unused) to indicate overflow with the new flag
KI_CRF_GRP_OVERFLOW.
This fixes procstat -s.
Approved by: re (kib)
a device pager (OBJT_DEVICE) object in that it uses fictitious pages to
provide aliases to other memory addresses. The primary difference is that
it uses an sglist(9) to determine the physical addresses for a given offset
into the object instead of invoking the d_mmap() method in a device driver.
Reviewed by: alc
Approved by: re (kensmith)
MFC after: 2 weeks
when using mmap() before invoking mmap(). This avoids a confusing error
message when locate is invoked against a zero-size database after the
recent change to make mmap() fail requests to map 0 bytes.
Submitted by: Jaakko Heinonen jh of saunalahti dot fi
Approved by: re (kensmith)
MFC after: 1 week
without VIMAGE virtualization in the kernel.
If we cannot resolve a symbol try to see if we can find it with
prefix of the virtualized subsystem, currently only "vnet_entry"
by identifying either the vnet of the current process for a
live system or the vnet of proc0 (or of dumptid if compiled
in a non-default way).
The way this is done currently allows us to only touch libkvm
but no single application. Once we are going to virtualize more
subsystems we will have to review this decision for better scaling.
Submitted by: rwatson (initial version of kvm_vnet.c, lots of ideas)
Reviewed by: rwatson
Approved by: re (kib)
network stacks, VNET_SYSINIT:
- Add VNET_SYSINIT and VNET_SYSUNINIT macros to declare events that will
occur each time a network stack is instantiated and destroyed. In the
!VIMAGE case, these are simply mapped into regular SYSINIT/SYSUNINIT.
For the VIMAGE case, we instead use SYSINIT's to track their order and
properties on registration, using them for each vnet when created/
destroyed, or immediately on module load for already-started vnets.
- Remove vnet_modinfo mechanism that existed to serve this purpose
previously, as well as its dependency scheme: we now just use the
SYSINIT ordering scheme.
- Implement VNET_DOMAIN_SET() to allow protocol domains to declare that
they want init functions to be called for each virtual network stack
rather than just once at boot, compiling down to DOMAIN_SET() in the
non-VIMAGE case.
- Walk all virtualized kernel subsystems and make use of these instead
of modinfo or DOMAIN_SET() for init/uninit events. In some cases,
convert modular components from using modevent to using sysinit (where
appropriate). In some cases, do minor rejuggling of SYSINIT ordering
to make room for or better manage events.
Portions submitted by: jhb (VNET_SYSINIT), bz (cleanup)
Discussed with: jhb, bz, julian, zec
Reviewed by: bz
Approved by: re (VIMAGE blanket)
if input-device is unavailable. The Xserve G5 defaults to using
screen/keyboard for output-device/input-device even if these are not
installed, and then falls back to serial ports at boot time.
Reviewed by: marcel
Hardware from: grehan
Approved by: re (kib)
other than the current system-wide size (32-bits) has been updated so
for now just cautiously turn the check off. While here fix the check
for IDs being too large which doesn't work due to type mis-matches.
Reviewed by: jhb (previous version)
Approved by: re (kib)
MFC after: 1 month (type mis-match fixes only)
experimental NFSv4 client might try and use it as an IPv6 address,
breaking callbacks. The fix simply initializes the isinet6 variable
for this case.
Approved by: re (kensmith), kib (mentor)
doesn't exist and user doesn't have write access to the file.
Without this fix, it returns bogus value instead of 0. For some
reason this didn't manifest on my kernel compiled with -O0.
PR: kern/136601
Submitted by: Jaakko Heinonen <jh at saunalahti dot fi>
Approved by: re (kib)
