The function name expandstr() and the general idea of doing this kind of
expansion by treating the text as a here document without end marker is from
dash.
All variants of parameter expansion and arithmetic expansion also work (the
latter is not required by POSIX but it does not take extra code and many
other shells also allow it).
Command substitution is prevented because I think it causes too much code to
be re-entered (for example creating an unbounded recursion of trace lines).
Unfortunately, our LINENO is somewhat crude, otherwise PS4='$LINENO+ ' would
be quite useful.
did not free memory (1) or close the file descriptor (2) in error cases.
Reported by: Mark Johnston (1)
Reported by: attilio (2)
Reviewed by: jhb
Sponsored by: Sandvine Incorporated
MFC after: 1 week
but has only 2 SATA ports instead of 4. The worst part is that SStatus and
SError registers for missing ports are not implemented and return wrong
values (0xffffffff), that caused infinite reset loop.
Just ignore that SError value while I found no better way to identify them.
- Re-add accidentally removed atomic op. for sysctl(9) handler.
- Remove a period(`.') at the end of a debugging message.
- Consistently spell "low" for "TSC-low" timecounter throughout.
Pointed out by: bde
increase robustness (no more calls to panic(9)) and simplify
code.
- Allocate RX/TX data structures as a single buffer rather than
an array of 4KB pages to simplify code.
- Fixed LRO (aka TPA) code. Removed kernel module parameter and
support enabling disabling LRO through ifconfig(8) command line.
LRO is still disabled by default but should be enabled for best
performance on an endpoint device.
- Fixed statistcs code and removed kernel module parameter (stats
should just work).
- Added many software counters to help identify the cause of some
performance issues.
- Streamlined adapter internal init/stop code paths.
- Fiddled with debug code (adding some here, removing some there).
- Continued style(9) adjustments.
invariant. For SMP case (TSC-low), it also has to pass SMP synchronization
test and the CPU vendor/model has to be white-listed explicitly. Currently,
all Intel CPUs and single-socket AMD Family 15h processors are listed here.
Discussed with: hackers
TSC timecounter if TSC frequency is higher than ~4.29 MHz (or 2^32-1 Hz) or
multiple CPUs are present. The "TSC-low" frequency is always lower than a
preset maximum value and derived from TSC frequency (by being halved until
it becomes lower than the maximum). Note the maximum value for SMP case is
significantly lower than UP case because we want to reduce (rare but known)
"temporal anomalies" caused by non-serialized RDTSC instruction. Normally,
it is still higher than "ACPI-fast" timecounter frequency (which was default
timecounter hardware for long time until r222222) to be useful.
interleaving.
Signal dumping to happen only for the first panic which should be the
most important.
Sponsored by: Sandvine Incorporated
Submitted by: Nima Misaghian (nmisaghian AT sandvine DOT com)
MFC after: 2 weeks
RFC 4861 6.3.4 clearly defines handling multiple RAs in this way.
- RDNSS/DNSSL options from multiple RAs on a single link will be
gathered and sent to resolvconf(8).
- Call "resolvconf -d" only after at least one RDNSS or DNSSL option is
received and then all of them are expired.
- The rtsold.dump output now supports displaying a list of the RA options.
- Use more human-readable expression for logging values of struct timeval.
Discussed with: ume
- Add retry loops in the i2c read/write functions.
- Combied the ADC channel selection and readout of the value into
one iicbus_transfer to avoid possible races.
Reviewed by: nwhitehorn
whether decapsulated IPsec packets will be passed to pfil again depending
on the setting of the net.ip6.ipsec6.filtertunnel sysctl.
PR: kern/157670
Submitted by: Manuel Kasper (mk neon1.net)
MFC after: 2 weeks
The code has definitely been broken for SCHED_ULE, which is a default
scheduler. It may have been broken for SCHED_4BSD in more subtle ways,
e.g. with manually configured CPU affinities and for interrupt devilery
purposes.
We still provide a way to disable individual CPUs or all hyperthreading
"twin" CPUs before SMP startup. See the UPDATING entry for details.
Interaction between building CPU topology and disabling CPUs still
remains fuzzy: topology is first built using all availble CPUs and then
the disabled CPUs should be "subtracted" from it. That doesn't work
well if the resulting topology becomes non-uniform.
This work is done in cooperation with Attilio Rao who in addition to
reviewing also provided parts of code.
PR: kern/145385
Discussed with: gcooper, ambrisko, mdf, sbruno
Reviewed by: attilio
Tested by: pho, pluknet
X-MFC after: never
This also replaces the local fix in r219209 that made .Ac emit
ASCII angle quotes with an official fix. In the official fix,
ASCII quotes are output when using the .Aq, .Ao and .Ac calls,
but only when nested into the .An macro.
PR: gnu/154822
RSF_FATAL we need to switch to alternate globals for KSTACK_CHECK just
like tl1_data_excptn(_trap) does. This is more or less cosmetic because
in case RSF_FATAL is called we're already heading south.
- Correct an END().
- Read the window state from the correct register for a CATR().
family detection in world, mostly noticed by ifconfig(8), when running with
an old kernel.
Reported by: Andrzej Tobola (ato iem.pw.edu.pl)
Reported by: gcooper
the system to proceed to boot without bailing out into single user mode,
even when the file system can not be successfully mounted.
This option is implemented in mount(8) and not passed into kernel.
MFC after: 1 month
more than three temporary register in several places CATR() is used so
this code trades instructions in for registers. Actually, this still isn't
sufficient and CATR() has the side-effect of clobbering %y. Luckily, with
the current uses of CATR() this either doesn't matter or we are able to
(save and) restore it.
Now that there's only one use of AND() and TEST() left inline these.
of just setting it to the first registered device, reevaluate it for each
device registered, trying to choose best candidate, unless one was forced.
For now use such preference order: play&rec, play, rec.
As side effect, this should workaround the situation when HDMI audio output
of the video card, usually not connected to anything, becomes default, that
requires manual user intervention to make sound working. If at some point
this won't be enough, we can try to fetch some additional priority flags
from the device driver.
- Fix a missing back pointer assignment in struct prefix to struct rainfo
when addr="" is specified. This caused SIGSEGV.
- Insert a prefix element to a tail queue after setting parameters.
When user wants have specific alignment - do what user wants.
Use stripesize as alignment value in case, when some of gpart's
arguments are ommitted for automatic calculation.
Suggested by: mav
For the AR5211/AR5212, this is apparently a one byte pulse duration
counter value. It is only coded up here for the AR5212 as I don't have
any AR5211-series hardware to test it on.
This information was extracted from the Madwifi DFS branch along with
some local additions.
Please note - all this does is extract out the radar event duration,
it in no way reflects the presence of a radar. Further code is needed
to take a set of radar events and filter them to extract out correct
radar pulse trains (and ignore other events.)
For further information, please see:
http://wiki.freebsd.org/dev/ath_hal%284%29/RadarDetection
This includes references to the relevant patents which describe what
is going on.
Obtained from: Madwifi
This is intended to fix the bug where cpu mask objects are
capped to 32. MAXCPU, then, can now arbitrarely bumped to whatever
value. Anyway, as long as several structures in the kernel are
statically allocated and sized as MAXCPU, it is suggested to keep it
as low as possible for the time being.
Technical notes on this commit itself:
- More functions to handle with cpuset_t objects are introduced.
The most notable are cpusetobj_ffs() (which calculates a ffs(3)
for a cpuset_t object), cpusetobj_strprint() (which prepares a string
representing a cpuset_t object) and cpusetobj_strscan() (which
creates a valid cpuset_t starting from a string representation).
- pc_cpumask and pc_other_cpus are target to be removed soon.
With the moving from cpumask_t to cpuset_t they are now inefficient
and not really useful. Anyway, for the time being, please note that
access to pcpu datas is protected by sched_pin() in order to avoid
migrating the CPU while reading more than one (possible) word
- Please note that size of cpuset_t objects may differ between kernel
and userland. While this is not directly related to the patch itself,
it is good to understand that concept and possibly use the patch
as a reference on how to deal with cpuset_t objects in userland, when
accessing kernland members.
- KTR_CPUMASK is changed and now is represented through a string, to be
set as the example reported in NOTES.
Please additively note that no MAXCPU is bumped in this patch, but
private testing has been done until to MAXCPU=128 on a real 8x8x2(htt)
machine (amd64).
Please note that the FreeBSD version is not yet bumped because of
the upcoming pcpu changes. However, note that this patch is not
targeted for MFC.
People to thank for the time spent on this patch:
- sbruno, pluknet and Nicholas Esborn (nick AT desert DOT net) tested
several revision of the patches and really helped in improving
stability of this work.
- marius fixed several bugs in the sparc64 implementation and reviewed
patches related to ktr.
- jeff and jhb discussed the basic approach followed.
- kib and marcel made targeted review on some specific part of the
patch.
- marius, art, nwhitehorn and andreast reviewed MD specific part of
the patch.
- marius, andreast, gonzo, nwhitehorn and jceel tested MD specific
implementations of the patch.
- Other people have made contributions on other patches that have been
already committed and have been listed separately.
Companies that should be mentioned for having participated at several
degrees:
- Yahoo! for having offered the machines used for testing on big
count of CPUs.
- The FreeBSD Foundation for having sponsored my devsummit attendance,
which has been instrumental.
- Sandvine for having offered offices and infrastructure during
development.
(I really hope I didn't forget anyone, if it happened I apologize in
advance).
