Note, we return the PCI pnp info, but in fact that's wrong to do
since that data is not defined for CardBus cards. CardBus says that
these registers are undefined and one should use the CIS to do
device matching. To date, all CardBus cards have had these
registered defined, no doubt because they are using common silicon
to produce both the PCI cards and the CardBus cards. However, it isn't
any worse than the rest of the system, so just note it in passing and
move on.
o Also sort prototypes while I'm here.
Conditionalize the "XX bytes left" checks reference on UFS1/UFS12.
Conditionally build the necessary 64bit math for boot2 if UFS12.
Sponsored by: DARPA & NAI Labs.
when using '-p' with reboot, and the power down action failds, reboot
the system normally. The behaviour of 'halt -p' and of shutdown(8) is
unchanged.
Approved by: roberto
revision 1.218. This bug caused a "struct file" reference to be
leaked if VOP_ADVLOCK(), vn_start_write(), or mac_check_vnode_write()
failed during the open operation.
PR: kern/43739
Reported by: Arne Woerner <woerner@mediabase-gmbh.de>
currently disabled):
o Don't use constants for the output parameter, use the iparam count as a
pointer to the first result location.
o Fix bits vs bytes counting problems.
o Split out the hardware and software normalization versions of modexp.
o Enable hardware normalization for chips that support it.
o On reset, disable hardware normalization for 582x and make sure the
chip is in little endian mode.
o Since sw normalization is now the only option, simplify normalization
handling.
Also fix RNG harvesting: disabling PK support (for the moment) had disabled
the MCR2 interrupt; consider both KEY support and RNG support when deciding
whether or not to enable it.
Obtained from: openbsd
It seems that the existence of a "depend" target in src/sys/boot is not
to be taken as an indication that it actually does what one would expect,
at least it clearly threw my testing off.
Apologies to: jhb
for processing callbacks. This closes race conditions caused by locking
too many things with a single mutex.
o reclaim crypto requests under certain (impossible) failure conditions
Load 4 sectors more than we used to. This is harmless overhead for
the UFS1_ONLY case, but sufficient for boot2(UFS1+2).
Sponsored by: DARPA & NAI Labs
Don't use snprintf where strlcpy() will do the job.
Also, a NUL is '\0' not 0 in our style (C doesn't care), so spell it like.
Remove useless {} and () in the general area of this change.
and therefore we need a way for ioctl handlers to run in that thread
in GEOM. Rather than invent a complicated registration system to
recognize which ioctl handler to use for a given ioctl, we still
schedule all ioctls down the tree as bio transactions but add a
special return code that means "call me directly" and have the
geom_dev layer do that.
Use this for all ioctls that make it as far as a diskdriver to
avoid any backwards compatibility problems.
Requested by: scottl
Sponsored by: DARPA & NAI Labs
OpenBSD who got the code (or the idea) from the NetBSD tlp driver.
This gets some cardbus dc cards working (either completely or nearly
so). It also appears to get additional pci cards working, without
breaking working ones.
# Maybe some additional work is needed here. Also, the cardbus attachment
# might need to match on the CIS rather than on the vendor/device so we have
# a finer level of detail as to what the card is. Technically, the
# vendor/device fields are undefined for CardBus (even though most cards are
# using common silicon with pci models).
there are some strange machines that seem to need this.
o delete bogus comment.
o don't use the the bios for read/writing config space. They interact badly
with SMP and being called from ISR. This brings -current in line with
-stable.
# make the latter #ifdef on USE_PCI_BIOS_FOR_READ_WRITE in case we
# need to go back in a hurry.
