work:
- A new PCI quirk (PCI_QUIRK_DISABLE_MSI) is added to the quirk table.
- A new pci_msi_device_blacklisted() determines if a passed in device
matches an MSI quirk in the quirk table. This can be overridden (all
quirks ignored) by setting the hw.pci.honor_msi_blacklist to 0.
- A global blacklist check is performed in the MI PCI bus code by checking
to see if the device at 0:0:0 is blacklisted.
Tested by: jdp
1) s/mi/mfi/ in FreeBSD ioctl path
2) add in "\n" on various failure messages
3) cap the length of time to abort an AEN command
4) fix passing sense data back to user to make Dell's Linux firmware
upgrade tool happy.
5) bump the MFI_POLL_TIMEOUT_SECS from 10s to 50s since the
firmware flash command can take ~40s to return.
This is some clean-up and enables RAID firmware to updated via Dell's
tool. Note Dell's tool requires the updates to the Linux emulator
that has been done in -current with TLS etc.
I need to discuss with scottl how to better submit mfi commands to
the firmware via the ioctl path so we don't do it in polled mode.
2) Fix all "magic numbers" to be constants.
3) A collision case that would generate two associations to
the same peer due to a missing lock is fixed.
4) Added tracking of where timers are stopped.
Approved by: gnn
by vnode. Allow for md thread and the thread that owns lock on vnode
backing the md device to do the write even when runningbufspace is
exhausted.
Tested by: Peter Holm
Reviewed by: tegge
MFC after: 2 weeks
have been added erroneously, and it causes problems on some chips. A larger
change is needed to do this write at a more appropriate place, but that
change requires reworking the ASF logic. That will be worked on in the
future.
Submitted by: Bruce Evans
o no more ds_vdata in tx/rx descriptors
o split h/w tx/rx descriptor from s/w status
o as part of the descriptor split change the rate control module api
so the ath_buf is passed in to the module so it can fetch both
descriptor and status information as needed
o add some const poisoning
Also for sample rate control algorithm:
o split debug msgs (node, rate, any)
o uniformly bounds check rate indices (and in some cases correct checks)
o move array index ops to after bounds checking
o use final tsi from the status block instead of the h/w descriptor
o replace h/w descriptor struct's with proper mask+shift defs (this
doesn't belong here; everything is known by the driver and should
just be sent down so there's no h/w-specific knowledge)
MFC after: 1 month
o remove os-specific glue code; it's now the responsibility of
the driver
o add wackelf utility for patching the ELF magic number on arm
builds since noone can agree on how to mark a .o file as not
having any floating point instructions
o remove radar/dfs-related entry points; folks have finally
decided how to support dfs w/o polluting the hal
o properly recognize AR2424 chips (they were being rejected on
attach despite being fully supported)
o add HAL_CAP_RXORN_FATAL capability to control how RXORN errors
are handled; previously RXORN was always treated as fatal because
older chips required a reset; now we do not treat it as fatal
for "newer chips" (noone seems to know what the cutoff is so
this capability can be used to override the current guestimate)
o HAL_CAP_RXTSTAMP_PREC capability to export the number of bits
of precision for timestamp data returned in the rx descriptor
o remove public exposure of the compression buffer; it is chip
specific and never belonged in the public view
o change definition of HAL_INT_GLOBAL from an enum member to a
#define to workaround compilers that bitch about enum values
that appear overflow 31 bits
o add support for newer chips that can store the tkip mic key
together with the cipher key in a single key cache entry
o split tx/rx descriptor into a h/w section and a s/w portion;
this permits storing the s/w area in cached memory when the
h/w area is stored in uncached memory; this also shrinks
memory use since only one status block is needed while multiple
tx/rx descriptors may be required per frame
o add final transmit series index to the transmit descriptor status
so rate control algorithms don't need to grovel through h/w state
to find it
o remove ds_vdata field from the descriptor state as part of the
radar changes
o fix excessive stack usage for some 5212 rf backends
o correct rfkill handling when the pin polarity is 0 true
o correct handling of tsf wrap when reading 64-bit values
MFC after: 1 month
