message that was generated when doing experimental NFS client
mounts. I put that message in because the krpc would hang with
the default size for mounts that used large rsize/wsize values.
Since the bug that caused these hangs was fixed by r213756,
I think the message is no longer needed.
MFC after: 2 weeks
While it does not provide any functionality for IPv6, it provides
the sysctl nodes for net.inet.* that a lot of functionality shared
between IPv4 and IPv6 depends on. We cannot change these anymore
without breaking a lot of management and tuning.
In case of IPv6 only, we compile out everything but the sysctl node
declarations.
Reviewed by: gnn
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
MFC After: 5 days
hast_proto_recv_hdr() may be used. This also fixes the issue
(introduced by r220523) with hastctl, which crashed on assert in
hast_proto_recv_data().
Suggested and approved by: pjd (mentor)
passing the cached proxydl reference (sockaddr_dl initialized or not) to
nd6_na_output(). nd6_na_output() will thus assume a proxy NA. Revert to
conditionally passing either &proxydl or NULL if no proxy case desired.
Tested by: ipv6gw and ref9-i386
Reported by: Pete French (petefrench ingresso.co.uk on stable)
Reported by: bz, simon on Y! cluster
Reported by: kib
PR: kern/151908
MFC after: 3 days
If various checks are omitted, the CMSG_NXTHDR macro expands to
(struct cmsghdr *)((char *)(cmsg) + \
_ALIGN(((struct cmsghdr *)(cmsg))->cmsg_len))
Although there is no alignment problem (assuming cmsg is properly aligned
and _ALIGN is correct), this violates -Wcast-align on strict-alignment
architectures. Therefore an intermediate cast to void * is appropriate here.
There is no workaround other than not using -Wcast-align.
MFC after: 2 weeks
The code provides information on how the signal was generated.
Formerly, the code was only logged for traps, much like only signal handlers
for traps received a meaningful si_code before FreeBSD 7.0.
In rare cases, no information is available and 0 is still logged.
MFC after: 1 week
same as the regular NFS client for NFSv3. The main one is making
use of a reserved port# the default. Also, set the retry limit
for TCP the same and fix the code so that it doesn't disable
readdirplus for NFSv4.
MFC after: 2 weeks
It's also marked inactive by the initvals, and enabled after
the baseband/PLL has been configured, but before the RF
registers have been programmed.
The origin and reason for this particular change is currently unknown.
Obtained from: Linux ath9k
- 6000 series devices need enhanced sensitivity calibration.
- 6000 series devices need a different setting for the shadow reg.
- set the IWN_FLAG_HAS_11N bit if the EEPROM says the device has 11n
support.
Obtained from: OpenBSD
Antenna diversity on the >= AR5416 is implemented differently than the
AR5212 and previous chips. So for now, and not to confuse things, just
disable it for now.
- read RSSI only for the active chains
- cast RSSI/NF to int8_t before passing it up to radiotap
- remove the htole64() for the timestamp
Obtained from: OpenBSD
