trap_fatal() to make restarting from panic's slightly easier. Before if
one did 'w 0 0' in ddb, the longjmp in ddb inside of trap_fatal() would
result in Giant being held (or recursed one level deeper) which led to
problems later on. You can now drop to teh debugger, do 'w 0 0', and
continue w/o a problem.
and such was just a bad idea and one that users should be forced to
enable if they want it. This patch introduces a hw.pci.enable_pcibios
tunable for those people. This does not impact the pcibios interrupt
routing at all.
Approved by: peter, msmith
some bios vendors took it apon themselves to "censor" the
host->pci bridges from PCIBIOS callers, even when the caller
explicitly asks for them. This includes certain Compaq machines
(eg: DL360) and some laptops.
If we detect this, shut down pcibios and revert to using IO
port bashing.
Under -current, apcica does a better job anyway.
information. The default limits only effect machines with > 1GB of ram
and can be overriden with two new kernel conf variables VM_SWZONE_SIZE_MAX
and VM_BCACHE_SIZE_MAX, or with loader variables kern.maxswzone and
kern.maxbcache. This has the effect of leaving more KVM available for
sizing NMBCLUSTERS and 'maxusers' and should avoid tripups where a sysad
adds memory to a machine and then sees the kernel panic on boot due to
running out of KVM.
Also change the default swap-meta auto-sizing calculation to allocate half
of what it was previously allocating. The prior defaults were way too high.
Note that we cannot afford to run out of swap-meta structures so we still
stay somewhat conservative here.
but it's better than the buggy behavior we have now. If we contigmalloc()
buffers in bus_dmamem_alloc(), then we must configfree() them in
bus_dmamem_free(). Trying to free() them is wrong, and will cause
a panic (at least, it does on the alpha.)
I tripped over this when trying to kldunload my busdma-ified if_rl
driver.
traps, so that ddb can keep control (almost) no matter how it is
entered. This breaks time-critical interrupts while the system is
stopped in ddb, but I haven't noticed any significant problems except
that applications become confused about the time. Lost time will be
adjusted for later. Anyway, the half-baked disabling of interrupts in
Debugger() gives the same problems for the usual way of entering ddb.
bug for bug compatibility to ddb trap handlers after fixing the debugger
trap gates to be interrupt gates, but the fix was never committed. Now
I want the fix to apply to ddb.
- fix segment limit mis-calculation for GCODE_SEL, GDATA_SEL, GPRIV_SEL,
LUCODE_SEL and LUDATA_SEL.
- move `loader(8) metadata' related printf() after cninit().
- use atop macro (address to pages) for segment limit calculation
instead of i386_btop macro (bytes to pages).
- fix style bugs for the declarations of ints.
Reviewed by: bde, msmith (and arch & audit ML)
flags with interrupts disabled to see if we should call ast() during
doreti. This was mostly submitted by Bruce, but his original patch did
the looping in ast() in assembly rather than in the ast() function itself.
Once we've actually called into the ast() function, it's cheaper to just
loop inside the function rather than returning from the function,
performing the check, and then calling the function again. However, we
can optimize the first check to avoid calling the function at all.
Other architectures may choose to implement this optimization if they
wish but it is not required for correct operation.
Submitted by: bde
the process of exiting the kernel. The ast() function now loops as long
as the PS_ASTPENDING or PS_NEEDRESCHED flags are set. It returns with
preemption disabled so that any further AST's that arrive via an
interrupt will be delayed until the low-level MD code returns to user
mode.
- Use u_int's to store the tick counts for profiling purposes so that we
do not need sched_lock just to read p_sticks. This also closes a
problem where the call to addupc_task() could screw up the arithmetic
due to non-atomic reads of p_sticks.
- Axe need_proftick(), aston(), astoff(), astpending(), need_resched(),
clear_resched(), and resched_wanted() in favor of direct bit operations
on p_sflag.
- Fix up locking with sched_lock some. In addupc_intr(), use sched_lock
to ensure pr_addr and pr_ticks are updated atomically with setting
PS_OWEUPC. In ast() we clear pr_ticks atomically with clearing
PS_OWEUPC. We also do not grab the lock just to test a flag.
- Simplify the handling of Giant in ast() slightly.
Reviewed by: bde (mostly)
are a really nasty interface that should have been killed long ago
when 'ptrace(PT_[SG]ETREGS' etc came along. The entity that they
operate on (struct user) will not be around much longer since it
is part-per-process and part-per-thread in a post-KSE world.
gdb does not actually use this except for the obscure 'info udot'
command which does a hexdump of as much of the child's 'struct user'
as it can get. It carries its own #defines so it doesn't break
compiles.
dynamic symbol table buckets and chains. The sparc64 toolchain uses 32
bit .hash entries, unlike other 64 bits architectures (alpha), which use
64 bit entries.
Discussed with: dfr, jdp
were indices in a dense array. The cpuids are a sparse set and treat
them as such, setting up containers only for CPUs activated during
mb_init().
- Fix netstat(1) and systat(1) to treat the per-CPU stats area as a sparse
map, in accordance with the above.
This allows us to properly boot with certain CPUs disactivated. However, if
we later decide to re-activate said CPUs, we will barf until we decide to
implement CPU spinon/spinoff callback hooks to allow for said CPUs' per-CPU
containers to get configured on their activation.
Reported by: mjacob
Partially (sys/ diffs) Submitted by: mjacob
blown over by the Hurricane and had a house dropped on you by the Tornado.
Now it's time to have your parade rained on by... the Typhoon!
This commit adds driver support for 3Com 3cR990 10/100 ethernet
adapters based on the Typhoon I and Typhoon II chipsets. This is actually
a port of the OpenBSD driver with many hacks by me.
No Virginia, there isn't any support for the hardware crypto yet. However
there is support for TCP/IP checksum offload and VLANs.
Special thanks go to Jason Wright, Aaron Campbell and Theo de Raadt for
squeezing enough info out of 3Com to get this written, and for doing
most of the hard work.
Manual page is included. Compiled as a module and included in GENERIC.
right place. Reported by Jonathan Chen <jonc@pinnacle.co.nz> (someone with
the same name who's not me)
PR: i386/8414
Submitted by: Jonathan Chen <jonc@pinnacle.co.nz>
MFC after: 2 weeks
the non-reserved bits of dr7.
During context restore, load dr7 in such a way as to not
disturb reserved bits.
machdep.c: Don't explicitly disallow the setting of the reserved bits
in dr7 since we now keep from setting them when we load dr7
from the PCB.
This allows one to write back the dr7 value obtained from
the system without triggering an EINVAL (one of the
reserved bits always seems to be set after taking a trace
trap).
MFC after: 7 days
we are required to do if we let user processes use the extra 128 bit
registers etc.
This is the base part of the diff I got from:
http://www.issei.org/issei/FreeBSD/sse.html
I believe this is by: Mr. SUZUKI Issei <issei@issei.org>
SMP support apparently by: Takekazu KATO <kato@chino.it.okayama-u.ac.jp>
Test code by: NAKAMURA Kazushi <kaz@kobe1995.net>, see
http://kobe1995.net/~kaz/FreeBSD/SSE.en.html
I have fixed a couple of style(9) deviations. I have some followup
commits to fix a couple of non-style things.
'dwatch'. The new commands install hardware watchpoints if supported
by the architecture and if there are enough registers to cover the
desired memory area.
No objection by: audit@, hackers@
MFC after: 2 weeks
directories. When enabled via "options UFS_DIRHASH", in-core hash
arrays are maintained for large directories. These allow all
directory operations to take place quickly instead of requiring
long linear searches. For now anyway, dirhash is not enabled by
default.
The in-core hash arrays have a memory requirement that is approximately
half the size of the size of the on-disk directory file. A number
of new sysctl variables allow control over which directories get
hashed and over the maximum amount of memory that dirhash will use:
vfs.ufs.dirhash_minsize
The minimum on-disk directory size for which hashing should be
used. The default is 2560 (2.5k).
vfs.ufs.dirhash_maxmem
The system-wide maximum total memory to be used by dirhash data
structures. The default is 2097152 (2MB).
The current amount of memory being used by dirhash is visible
through the read-only sysctl variable vfs.ufs.dirhash_maxmem.
Finally, some extra sanity checks that are enabled by default, but
which may have an impact on performance, can be disabled by setting
vfs.ufs.dirhash_docheck to 0.
Discussed on: -fs, -hackers
Also removed some spl's and added some VM mutexes, but they are not actually
used yet, so this commit does not really make any operational changes
to the system.
vm_page.c relates to vm_page_t manipulation, including high level deactivation,
activation, etc... vm_pageq.c relates to finding free pages and aquiring
exclusive access to a page queue (exclusivity part not yet implemented).
And the world still builds... :-)
(this commit is just the first stage). Also add various GIANT_ macros to
formalize the removal of Giant, making it easy to test in a more piecemeal
fashion. These macros will allow us to test fine-grained locks to a degree
before removing Giant, and also after, and to remove Giant in a piecemeal
fashion via sysctl's on those subsystems which the authors believe can
operate without Giant.
1. Add SA_IO_TIMEOUT as an option (4 minutes default) to cover reads,
writes, wfm, test unit ready.
2. Add internal SCSIOP_TIMEOUT (e.g., for mode sense) at 1 minute. This
should not require an option, but is cleaner to parameterize.
MFC after: 1 week
removed and a minimal number of changes to make it compile in the new
location.
# I have a fully converted on a disk that may be crashed. If it is
# crashed, I'll redo the work.
.cvsignore file for [A-Za-z]* to keep these directories around rather
than waste a file on .keepme. This should also make people's built
trees place nice with CVS.
Idea for .cvsignore: peter (although I suggested the regexp)
Pointed out by: Makoto MATSUSHITA-san <matusita@jp.FreeBSD.org>
Llama's costuming by: Fernamdo Llamas
lock until after grabbing the sched_lock to avoid CURSIG racing with
psignal.
- Don't grab Giant for addupc_task() as it isn't needed.
Reported by: tegge (signal race), bde (addupc_task a while back)
startup routine more closely matches that of alpha and ia64. At some
point the common mutexes shared across all platforms probably should move
into sys/kern_mutex.c.
trace code that was brought over from NetBSD.)
- Check for "syscall_with_err_pushed" as the label prior to a syscall trap
frame rather than "Xlcall_syscall" and "Xint0x80_syscall". We don't
have a valid trapframe during the short range of code that those two
symbols now cover.
- Simplify db_next_frame() to avoid duplicating the code for the different
trap frame types.
- Don't try to trace a swapped-out process. (Brought over from NetBSD via
the new alpha trace code.)
