add count of active and total components to the launched line so you can
see at a glance if your mirror/raid3 is complete...
now:
GEOM_MIRROR: Device mirror/sam launched (2/2).
Reviewed by: pjd
it was present only in the enable path, not the disable path, which one
presumes would be equally of interest. Either way, it was not needed,
as the sysctl framework already calls suser() if the operation is a
write operation, which configuration requests are.
Sponsored by: nCircle Network Security, Inc.
to it. Try to co-operate with the IPMI/ASF firmware accessing the PHY.
One we get link we don't mess with the PHY. If we do then over time
the NIC will go off line. It would be nice if we could tell if IPMI
was enabled on the chip but I can't figure out a reliable way to do
that. The scheme I tried worked on a Dell PE850 but not on an HP machine.
So we assume any NIC that has ASF capability needs to deal with it.
The code was inspired by the support in Linux from kernel.org and Broadcom.
Broadcom did give me some info. but it is rather limited and is mostly
just what is in the Linux driver. Thanks to the numerous people that
helped debug the many prior versions and that I didn't break other
bge(4) HW.
Reviewed by: several people
Tested by: even more
it possible to e.g. distribute kernels with config names larger
than eight symbols, without the clash. Previousy, LALALALA
and LALALALA-SMP would be the same tarball. (I think this
comes from the old days where tarballs were put on the MS-DOS
formatted diskettes.)
MFC after: 3 days
given as dso handle, but also in the implicit dependencies of that dso.
Also, const-ify the read-only parameter objlist of symlook_list.
Reported by: "Simon 'corecode' Schubert" <corecode at fs ei tum de>
Approved by: kan (mentor)
X-MFC-After: 6.2
Ever since rev 1.68 re(4) checks the validity of link in re_start.
But rlphy(4) got a garbled data due to a different bit layout used on
8139C+ and it couldn't report correct link state. To fix it, ignore
BMCR_LOOP and BMCR_ISO bits which have different meanings on 8139C+.
I think this also make dhclient(8) work on 8139C+.
Reported by: Gerrit Kuehn <gerrit AT pmp DOT uni-hannover DOT de>
Tested by: Gerrit Kuehn <gerrit AT pmp DOT uni-hannover DOT de>
is to able to be called after *all* attach and enable events are done.
We establish a SYSINIT hook to call this handler. The current usage for it
is to add scsi target resources *after* all enables are done. There seems
to be some dependencies between different halves of a dual-port with respect
to target mode.
Put in more meaningful event messages for some events- in particular
QUEUE FULL events so we can see what the queue depth was when the
IOC sent us this message.
MFC after: 1 week
- Add support for Intel 965 Express chipsets.
- Add support for R200 vertex programs, along with minor bugfixes.
- Add support for vblank synchronization to pipe B of Intel hardware
(laptop screens).
