Adrian Chadd 6af850068c After thinking about this a bit more, let's not keep statistics per-channel ... in the HAL. That's very memory hungry (32k just for channel statistics) which would be better served by keeping a summary in the ANI state. Or, later, keep a survey history in net80211. So: * Migrate the ah_chansurvey array to be a single entry, for the current channel. * Change the ioctl interface and ANI code to just reference that. * Clear the ah_chansurvey array during channel reset, both in the AR5212 and AR5416 reset path.		2012-04-28 22:03:19 +00:00
..
ar2133.c	Add the 11n chipset RF frontends to the linker set, even though they're not	2011-12-15 00:59:11 +00:00
ar5416_ani.c	After thinking about this a bit more, let's not keep statistics per-channel	2012-04-28 22:03:19 +00:00
ar5416_attach.c	Add an AR5416 PCU DMA stop method, as a check for the AR9130 is needed.	2012-04-28 03:07:36 +00:00
ar5416_beacon.c	The AR5212 setup path (also used by the AR5416 code) configures a	2011-09-28 03:03:23 +00:00
ar5416_cal_adcdc.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_cal_adcgain.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_cal_iq.c	Fix the calibration logic to correctly clamp the calculated coefficient.	2010-08-14 15:28:15 +00:00
ar5416_cal.c	Bump this up to where it used to be.	2011-11-09 23:28:47 +00:00
ar5416_cal.h	Introduce methods for the initial calibration and the new PA calibration	2011-03-11 11:35:36 +00:00
ar5416_eeprom.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_gpio.c	Port over some more GPIO fixes from the atheros reference HAL.	2011-12-23 08:53:22 +00:00
ar5416_interrupts.c	Squirrel away the SYNC interrupt in case we're doing interrupt debugging.	2012-04-10 07:11:33 +00:00
ar5416_keycache.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_misc.c	Extend the ANI code to implement basic channel survey support.	2012-04-28 08:29:46 +00:00
ar5416_phy.c	Modify the AR5416 11na rate table to use 24mb OFDM 11a for control traffic,	2011-02-21 05:10:34 +00:00
ar5416_power.c	Both linux ath9k and the reference driver initialises the PLL here	2012-04-14 04:40:11 +00:00
ar5416_radar.c	Break out the radar code into a separate source file.	2012-02-20 03:07:07 +00:00
ar5416_recv.c	Add an AR5416 PCU DMA stop method, as a check for the AR9130 is needed.	2012-04-28 03:07:36 +00:00
ar5416_reset.c	After thinking about this a bit more, let's not keep statistics per-channel	2012-04-28 22:03:19 +00:00
ar5416_xmit.c	Correctly handle AR_MoreAggr when assembling multi-descriptor final frames.	2012-04-04 21:49:49 +00:00
ar5416.h	Extend the ANI code to implement basic channel survey support.	2012-04-28 08:29:46 +00:00
ar5416.ini	Fix the addac serial load register write for AR5416.	2011-09-06 10:49:05 +00:00
ar5416desc.h	Add some 11n bits from the if_ath_tx 11n branch:	2011-10-25 23:09:07 +00:00
ar5416phy.h	Add the BT register definitions for AR9285/AR9287 BT coexistence.	2012-04-26 02:03:16 +00:00
ar5416reg.h	Add the BT register definitions for AR9285/AR9287 BT coexistence.	2012-04-26 02:03:16 +00:00