particularly nice that IPSEC inserts a zero-length mbuf into the
chain, and that bug should be fixed too, but interfaces should be
robust to bad input.
Print the interface name when TUNDEBUG()ing about dropping an mbuf.
This is to be friendly with non-IPv6 peer (If the peer complains due to
lack of IPv6CP, drop IPv6CP). This basically implements "RXJ+" state
transition in the RFC.
Obtained from: NetBSD
effect, which would cause unnecessary route deletion:
* Unfortunately, this has the obnoxious
* property of also triggering for insertion /above/ a pre-existing network
* route and clones. Sigh. This may be fixed some day.
The effect has been even worse, because recent versions of route.c set
the parent rtentry for cloned routes from an interface-direct route.
For example, suppose that we have an interface "ne0" that has an IPv4
subnet "10.0.0.0/24". Then we may have a cloned route like 10.0.0.1
on the interface, whose parent route is 10.0.0.0/24 (to the interface
ne0). Now, when we add the default route (i.e. 0.0.0.0/0),
rt_fixchange() will remove the cloned route 10.0.0.1. The (bad) effect
also prevents rt_setgate from configuring rt_gwroute, which would not
be an intended behavior.
As suggested in the comments to rt_fixchange(), we need stricter check
in the function, to prevent unintentional route deletion.
This fix also solve the "IPV6 panic?" problem in nd6_timer().
Submitted by: JINMEI Tatuya <jinmei@isl.rdc.toshiba.co.jp>
MFC after: 4 days
vlan_unconfig()-ing an interface on which multicast groups have been
joined. Instead, keep the list of groups around (and, in fact, allow
changing of the membership list) and re-join them when the vlan interface
is reassociated with a lower level interface.
of tunclose() rather than the end, and tunopen() grabbed that unit
before tunclose() finished (one process is allocating it while another
is freeing it!).
It may be worth hanging some sort of rw mutex around all specinfo
calls where d_close and the detach handler get a write lock and all
other functions get a read lock. This would guarantee certain levels
of ``atomicity'' (is that a word?) that people may expect (I believe
Solaris does something like this).
requirements(RFC1573, interface MIB). This change for 4.4BSD was
first introduced in if_ethersubr.c:1.17->1.18.
BTW, iflastchange on all of IFs are inconsistent. e.g.
ether, tun: update
fddi, tokenring, ppp: not update
I'll make patch later.
Obtained from: KAME
MFC after: 2 weeks
This work was based on kame-20010528-freebsd43-snap.tgz and some
critical problem after the snap was out were fixed.
There are many many changes since last KAME merge.
TODO:
- The definitions of SADB_* in sys/net/pfkeyv2.h are still different
from RFC2407/IANA assignment because of binary compatibility
issue. It should be fixed under 5-CURRENT.
- ip6po_m member of struct ip6_pktopts is no longer used. But, it
is still there because of binary compatibility issue. It should
be removed under 5-CURRENT.
Reviewed by: itojun
Obtained from: KAME
MFC after: 3 weeks
around, use a common function for looking up and extracting the tunables
from the kernel environment. This saves duplicating the same function
over and over again. This way typically has an overhead of 8 bytes + the
path string, versus about 26 bytes + the path string.
route in ifa_ifwithroute(), as the last resort, look up the route to
the gateway, not destination (to derive the interface from).
PR: kern/27852
Submitted by: Iasen Kostoff <tbyte@tbyte.org>
MFC after: 2 weeks
if_up() must be called at splnet or higher.
Second, set the IFF_RUNNING flag on an interface after its
resources (i.e. tunnel source and destination addresses)
have been set. Note that we don't set IFF_UP because it is
if_up()'s job to do that.
PR: kern/27851
Submitted by: Horacio J. PeÓa <horape@compendium.com.ar>
Only tun0 -> tun32767 may now be opened as struct ifnet's if_unit
is a short.
It's now possible to open /dev/tun and get a handle back for an available
tun device (use devname to find out what you got).
The implementation uses rman by popular demand (and against my judgement)
to track opened devices and uses the new dev_depends() to ensure that
all make_dev()d devices go away before the module is unloaded.
Reviewed by: phk
despite the fact that most people want to set exactly the same settings
regardless of which card they have. It has been repeatidly suggested
that this configuration should be done via ifconfig. This patch
implements the required functionality in ifconfig and add support to the
wi and an drivers. It also provides partial, untested support for the
awi driver.
PR: 25577
Submitted by: Brooks Davis <brooks@one-eyed-alien.net>
- Allocate zeroed memory in ether_resolvemulti() to prevent equal() from
comparing garbage and determining that two otherwise-equal sockaddr_dls
are different.
- Fill in all required fields of the sockaddr_dl
- Actually copy the multicast address into the sockaddr_dl when calling
if_addmulti()
- Don't claim that we don't have a way to resolve layer 3 addresses into
layer 2 addresses; use the ethernet way.
other "system" header files.
Also help the deprecation of lockmgr.h by making it a sub-include of
sys/lock.h and removing sys/lockmgr.h form kernel .c files.
Sort sys/*.h includes where possible in affected files.
OK'ed by: bde (with reservations)
peer out from sppp_lcp_open() to sppp_lcp_up(). For one, this makes
things look more symmetrical to sppp_lcp_close(), and somehow it also
just occurred to me that an Up event following the open caused the
value of the authentication option to be clobbered.
* Set the CSRG SCCS ID to the revision this file is actually based on
(the file itself has been updated to Lite2 in rev. 1.4).
* Fix some typos in comments.
* Add a comment to the trailing #endif according to style(9)
failures in MOD_LOAD.
Dodge duplicate make_dev() calls by (ab)using dev->si_drv2 to
remember if we created the device node via a dev_clone callback
before the d_open call.
Without this, ifpromisc() always fails (after setting the IFF_PROMISC
bit in ifp->if_flags) and bpf never bothers to turn promiscuous mode off.
PR: 20188
* Initialize the "struct sockaddr_dl sdl" correctly in vlan_setmulti().
PR: kern/22181
* The driver used to call malloc(..., M_NOWAIT), but to not check the
return value. Change malloc(..., M_NOWAIT) to malloc(..., M_WAITOK)
because the corresponding part of code is called from the upper
half of the kernel only.
PR: kern/22181
* Make sure a parent interface is up and running before invoking
its if_start() routine in order to avoid system panic.
PR: kern/22179 kern/24741 i386/25478
* Do not copy all the flags from a parent mindlessly.
PR: kern/22179
* Do not call if_down() on a parent interface if it's already down.
Call if_down() at splimp because if_down() needs that.
PR: kern/22179
Reviewed by: wollman
