off by default.
o Apparently the routine displaying the informational messages wasn't
checking its knob in rc.conf, so fix that as well.
Requested by: obrien
devfs(8) rules in rc(8). It is most useful for applying
rules to devfs(5) mount points in /dev or inside jails.
The following line of script is sufficient to
mount a relatively useful+secure devfs(5) in a jail:
devfs_mount_jail /some/jail/dev
Some new shell routines available to scripts that source
rc.subr(5):
o devfs_link - Makes it a little easier to create symlinks
o devfs_init_rulesets - Create devfs(8) rulesets from devfs.rules
o devfs_set_ruleset - Set a ruleset to a devfs(5) mount
o devfs_apply_ruleset - Apply a ruleset to a devfs(5) mount
o devfs_domount - Mount devfs(5) and apply some ruleset
o devfs_mount_jail - Mount devfs(5) and apply a ruleset
appropriate to jails.
Additional rulesets can be specified in /etc/devfs.rules.
If the devfs_system_ruleset variable is defined in rc.conf
and it contains the name of a ruleset defined in /etc/defaults/devfs.rules
or user supplied rulesets in /etc/devfs.rules then that ruleset will
be applied to /dev at startup by the /etc/rc.d/devfs script. It can
also be applied post-startup:
/etc/rc.d/devfs start
This is a more flexible mechanism than the previous method of using
/etc/devfs.conf. However, that method is still available.
Note: since devfs(8) doesn't provide any way for creating symlinks
as part of a ruleset, anyone wishing to create symlinks in a devfs(5)
as part of the bootup sequence will still have to rely on /etc/devfs.conf.
are all bogus, and the cards that don't decode things quite right
often have hundreds of them. This will fix starvation of small dmesg
buffers and allow better debugging to happen. I thought about adding
an override, but there is such a thing as too many knobs. :-)
ntp_update_second twice when we have a large step in case that step
goes across a scheduled leap second. The only way this could happen
would be if we didn't call tc_windup over the end of day on the day of
a leap second, which would only happen if timeouts were delayed for
seconds. While it is an edge case, it is an important one to get
right for my employer.
Sponsored by: Timing Solutions Corporation
ultimate trigger for the follow-up fixes in revisions 1.78, 1.80,
1.81 and 1.82 of trap.c. I was simply too pre-occupied with the
gateway page and how it blurs kernel space with user space and
vice versa that I couldn't see that it was all a load of bollocks.
It's not the IP address that matters, it's the privilege level that
counts. We never run in user space with lifted permissions and we
sure can not run in kernel space without it. Sure, the gateway page
is the exception, but not if you look at the privilege level. It's
user space if you run with user permissions and kernel space otherwise.
So, we're back to looking at the privilege level like it should be.
There's no other way.
Pointy hat: marcel
- Fix up TX speed changes.
- Make mpi-350 cards sort-of work with new firmware. It RXs okay but TXs
only work for about 14 packets then fails to get an interrupt. The
TX watchdog fires. It has been reported that my hack for now doesn't
break cards with the older firmware. It appears my card has lost
the ability to RX or TX at all but other peoples cards work. I assume
it got damaged in tansport.
MFC: 1 week.
gethostname()'s old and new signatures without requiring a library
bump. Note that programs which called gethostname() with a negative
argument were already broken, since the same type conversion was done
by the old implementation. Add a note in the Makefile so that whoever
next bumps the libc revision will delete the kluge at the same time
(as it will no longer be necessary). This is only operative on 64-bit
platforms.
Submitted by: marcel
count handling of station entries in hostap mode:
Input path:
o driver is now expected to find the node associated with the
sender of a received frame; use ic_bss if none is located
o driver passes the (referenced) node into ieee80211_input for
use within the wlan module and is responsible for cleaning up
on return
o the antenna state is no longer passed up with each frame; this
is now considered driver-private state and drivers are responsible
for keeping it in the driver-private part of a node
Output path:
Revamp output path for management frames to eliminate redundant
locking that causes problems and to correct reference counting
bogosity that occurs when stations are timed out due to inactivity
(in AP mode). On output the refcnt'd node is stashed in the pkthdr's
recvif field (yech) and retrieved by the driver. This eliminates
an unref/ref scenario and related node table unlock/lock due to the
driver looking up the node. This is particularly important when
stations are timed out as this causes a lock order reversal that
can result in a deadlock. As a byproduct we also reduce the overhead
for sending management frames (minimal). Additional fallout from
this is a change to ieee80211_encap to return a refcn't node for
tieing to the outbound frame. Node refcnts are not reclaimed until
after a frame is completely processed (e.g. in the tx interrupt
handler). This is especially important for timed out stations as
this deref will be the final one causing the node entry to be
reclaimed.
Additional semi-related changes:
o replace m_copym use with m_copypacket (optimization)
o add assert to verify ic_bss is never free'd during normal operation
o add comments explaining calling conventions by drivers for frames
going in each direction
o remove extraneous code that "cannot be executed" (e.g. because
pointers may never be null)
that caused a 3-4 times slow down in performance.
(the primary Sparc64 developers are all using OFW_NEWPCI already, so it is
the best code path for users)
quietly discard them; this just permits them to be collected with bpf)
o add a counter for the number of rate control frames discarded when not in
monitor mode
o move the rx "too short" statistic in the stat structure so non-error rx stats
are together (NB: ABI change to apps that collect stats via driver ioctl)
mistakes (this mistake was not an issue because the length is only used to
decide whether or not to allocate a cluster)
o while here, move a beacon length comment to the "right place"
when the buffer is not long enough to hold the current host name.
POSIX does not standardize error returns for gethostname(), so it
doesn't matter which one we use, but ENAMETOOLONG is at least a little
more intuitive, and mi suggests the existence of prior art. I've been
running with this change for a while on my home machine with no
effect. At the same time, I've updated the prototype for
gethostname() to use the correct standard type (size_t) for the
namelen argument.
All of the in-tree callers fall into one of the following categories:
1) Call perror() or equivalent when gethostname() fails.
2) Ignore gethostname()'s return value entirely, potentially resulting
in data corruption if the buffer is too small.
3) Fall back to a (possibly sensible) default value if gethostname()
fails.
Many of the callers I examined shows signs of confusion about the
correct sizing of the host name buffer. gethostname(3) now has more
information about this, as well as updated standards information.
PR: 48114
Submitted by: mi (in part)
_pmap_allocpte(): Guarantee that the page table page is zero filled before
adding it to the directory. Otherwise, a 2nd, 3rd, etc. thread could
access a nearby virtual address and use garbage for the address
translation.
Discussed with: peter, tegge
of bw_meter entries were processed up to one second ahead.
After an unappropriate rescheduling of some of the bw_meter
entries, the upcalls weren't delivered.
* pim_register_prepare() uses the appropriate sw_csum flag to
call ip_fragment() so the IP checksum is computed properly.
* Modify pim_register_prepare() to take care of IP packets that
don't need fragmentation.
* Add-back in_delayed_cksum() to encap_send(), because it seems it
should be there.
Submitted by: Pavlin Radoslavov <pavlin@icir.org>
also fixes pfs_access() since it relies on VOP_GETATTR() which will call
pfs_getattr(). This prevents jailed processes from discovering the
existence, start time and ownership of processes outside the jail.
PR: kern/48156
