well worth the bloat.
- Change the formatting of 'show ktr' slightly to accommodate the
additional field. Remove a tab from the verbose output and place the
actual trace data after a : so it is more easy to understand which
part is the event and which is part of the record.
psm(4), ukbd(4), ums(4) and usb(4) on by default. Modulo some nits with
the most annoying one probably being USB keyboards no longer working at
the OFW boot prompt after halting FreeBSD these drivers work fine on
sparc64 including X and there's nothing left that I'd consider a show-
stopper. I.e. graphical consoles on sun4u machines should either work
out of the box or by plugging in a card that is supported by either
creator(4) or machfb(4). The exception obviously are SBus-only machines
without UPA slots like some Ultra 1 (but which also still lack support
in other areas) and certain Exx0 (but which probably are mainly used
with serial consoles anyway). I'll try to add a cgsix(4) for these later
as Sun CG6 cards are probably the most common SBus framebuffer cards in
sun4u machines. I however don't see much sense in adding drivers for the
dozen of SBus framebuffers that were destined for sparc v8 machines.
The rest of the USB drivers aren't enabled as I'm only aware of ukbd(4)
and ums(4) as well as ohci(4) working with the on-board ALI M5237 and
Sun PCIO-2 controllers. Aue(4) definitely doesn't work on sparc64, yet.
Thanks to:
- Jake for the initial work on syscons(4) on sparc64 and creator(4).
- Marcel for uart(4) and especially for its support for the SCCs which
are only used on sparc64 so far. In various regards it wouldn't have
been possible to enable syscons(4) by default on sparc64, yet, without
uart(4).
- All that tested patches.
Ok'ed by: scottl (RE hat), tmm
GENERIC comment in ttyN.
- Add the name of the device driver creating the device nodes above the
respectives blocks so it's easier for user to find the right entry to
shut up warnings from getty(8). Replace 'Requires device 'uart' be
enabled.' with just 'uart(4)' as the former referred to a sparc64
GENERIC back when uart(4) wasn't enabled by default, yet.
- Turn off the getty(8) on screen as screen is created by ofw_console(4)
which is no longer enabled in the sparc64 GENERIC (and also only is a
last resort) to shut up warnings from getty(8) with the current GENERIC.
files after they were repo-copied to sys/dev/atkbdc. The sources of
atkbdc(4) and its children were moved to the new location in preparation
for adding an EBus front-end to atkbdc(4) for use on sparc64; i.e. in
order to not further scatter them over the whole tree which would have
been the result of adding atkbdc_ebus.c in e.g. sys/sparc64/ebus. Another
reason for the repo-copies was that some of the sources were misfiled,
e.g. sys/isa/atkbd_isa.c wasn't ISA-specific at all but for hanging
atkbd(4) off of atkbdc(4) and was renamed to atkbd_atkbdc.c accordingly.
Most of sys/isa/psm.c, i.e. expect for its PSMC PNP part, also isn't
ISA-specific.
- Separate the parts of atkbdc_isa.c which aren't actually ISA-specific
but are shareable between different atkbdc(4) bus front-ends into
atkbdc_subr.c (repo-copied from atkbdc_isa.c). While here use
bus_generic_rl_alloc_resource() and bus_generic_rl_release_resource()
respectively in atkbdc_isa.c instead of rolling own versions.
- Add sparc64 MD bits to atkbdc(4) and atkbd(4) and an EBus front-end for
atkbdc(4). PS/2 controllers and input devices are used on a couple of
Sun OEM boards and occur on either the EBus or the ISA bus. Depending on
the board it's either the only on-board mean to connect a keyboard and
mouse or an alternative to either RS232 or USB devices.
- Wrap the PSMC PNP part of psm.c in #ifdef DEV_ISA so it can be compiled
without isa(4) (e.g. for EBus-only machines). This ISA-specific part
isn't separated into its own source file, yet, as it requires more work
than was feasible for 6.0 in order to do it in a clean way. Actually
philip@ is working on a rewrite of psm(4) so a more comprehensive
clean-up and separation of hardware dependent and independent parts is
expected to happen after 6.0.
Tested on: i386, sparc64 (AX1105, AXe and AXi boards)
Reviewed by: philip
method of executing commands remotely. There are no rexec clients in
the FreeBSD tree, and the client function rexec(3) is present only in
libcompat. It has been documented as "obsolete" since 4.3BSD, and its
use has been discouraged in the man page for over 10 years.
of just dropping the lock around the ip_output call. This used to cause
corrupted state tree walks for some call-paths.
In a second stage all callouts will be marked MPSAFE according to the
setting of mpsafenet.
Reported and tested by: Matthew Grooms <mgrooms at seton dot org>
MFC after: 3 days
X-MFC after: Marking callouts MPSAFE + 1 week
phys_start and phys_end.
Remove a stale documentation not about dis/uncontiguous memory.
Update manual page date while I am around these ends.
Reviewed by: alc
reflects the actual behavior of the API
for listing extended attributes.
PR: docs/79261
Submitted by: rodrigc
Reviewed by: rwatson, kan
Approved by: das (mentor)
struct ifnet or the layer 2 common structure it was embedded in have
been replaced with a struct ifnet pointer to be filled by a call to the
new function, if_alloc(). The layer 2 common structure is also allocated
via if_alloc() based on the interface type. It is hung off the new
struct ifnet member, if_l2com.
This change removes the size of these structures from the kernel ABI and
will allow us to better manage them as interfaces come and go.
Other changes of note:
- Struct arpcom is no longer referenced in normal interface code.
Instead the Ethernet address is accessed via the IFP2ENADDR() macro.
To enforce this ac_enaddr has been renamed to _ac_enaddr.
- The second argument to ether_ifattach is now always the mac address
from driver private storage rather than sometimes being ac_enaddr.
Reviewed by: sobomax, sam
it; instead pass the space occupied by the header down into the
crypto modules (except in the demic case which needs it only when
doing int in s/w)
o while here fix defrag to strip the header from 2nd and later frames
o teach decap code how to handle 4-address frames
- Do not edit pullup_len outside M_CHECK macro.
- Do not reimplement NG_FWD_NEW_DATA().
- Remove redundant check for item being not NULL.
Submitted by: ru
do the subsequent ip_output() in IPFW. In ipfw_tick(), the keep-alive
packets must be generated from the data that resides under the
stateful lock, but they must not be sent at that time, as this would
cause a lock order reversal with the normal ordering (interface's
lock, then locks belonging to the pfil hooks).
In practice, this caused deadlocks when using IPFW and if_bridge(4)
together to do stateful transparent filtering.
MFC after: 1 week
- Initialize val_ec with the content of the volume EC register
for ACPI_IBM_METHOD_VOLUME and ACPI_IBM_METHOD_MUTE in acpi_ibm_sysctl_set()
if there is no CMOS handle present. This fixes setting volume and mute on
such models.
Submitted by: ru
Approved by: philip
hack MSS of packets outgoing via interface with small MTU, to workaround
path MTU discovery problems.
Written by Alexey Popov, with some cleanups from me. There are also plans
to improve mpd port, so that it uses this node, instead of doing MSS
hacking in userland, when 'enable tcpmssfix' option is on.
Submitted by: Alexey Popov <lollypop@flexuser.ru>
vm_page's machine-dependent fields. Use this function in
vm_pageq_add_new_page() so that the vm_page's machine-dependent and
machine-independent fields are initialized at the same time.
Remove code from pmap_init() for initializing the vm_page's
machine-dependent fields.
Remove stale comments from pmap_init().
Eliminate the Boolean variable pmap_initialized from the alpha, amd64,
i386, and ia64 pmap implementations. Its use is no longer required
because of the above changes and earlier changes that result in physical
memory that is being mapped at initialization time being mapped without
pv entries.
Tested by: cognet, kensmith, marcel
