eliminate TLB invalidations when permissions are relaxed, such as when a
read-only mapping is changed to a read/write mapping. Additionally,
eliminate TLB invalidations when bits that are ignored by the hardware,
such as PG_W ("wired mapping"), are changed.
Reviewed by: tegge
On entry or exit from the kernel the 'alltraps' and 'doreti' code
used taken by normal traps disables interrupts to protect the
critical sections where it is setting up %gs.
This protection is insufficient in the presence of NMIs since NMIs
can be taken even when the processor has disabled normal interrupts.
Thus the NMI handler needs to actually read MSR_GBASE on entry to
the kernel to determine whether a swap of %gs using 'swapgs' is
needed. However, reads of MSRs are expensive and integrating this
check into the 'alltraps'/'doreti' path would penalize normal
interrupts.
- Teach DDB about the 'nmi_calltrap' symbol.
Reviewed by: bde, peter (older versions of this change)
1. The amd64 pmap, unlike the i386 pmap, maintains a reference count
for each page directory (PD) page. However, in the transformation
of the i386 pmap into the amd64 pmap, operations, such as
pmap_copy() and pmap_object_init_pt(), that create 2MB "superpage"
mappings by setting the PG_PS bit in a PD entry were not modified
to adjust the underlying PD page's reference count. Consequently,
superpage mappings could disappear prematurely.
2. pmap_object_init_pt() could crash or corrupt memory if either the
virtual address range being mapped crosses a 1GB boundary in the
virtual address space or nothing is mapped in the 1GB area.
3. When pmap_allocpte() destroys a 2MB "superpage" mapping it does not
reduce the pmap's resident count accordingly. It should. (This
bug is inherited from i386.)
Discussed with: peter
Reviewed by: tegge
than ~PDRMASK to extract the physical address of a superpage from a PDE.
The use of ~PDRMASK is problematic if the PDE has PG_NX set. Specifically,
the PG_NX bit will be included in the physical address if ~PDRMASK is used.
Reviewed by: peter
it to __MINSIGSTKSZ. Define MINSIGSTKSZ in <sys/signal.h>.
This is done in order to use MINSIGSTKSZ for the macro PTHREAD_STACK_MIN
in <pthread.h> (soon <limits.h>) without having to include the whole
<sys/signal.h> header.
Discussed with: bde
made in pmap_protect(): The pmap's resident count should not be reduced
unless mappings are removed.
The errant change to the pmap's resident count could result in a later
pmap_remove() failing to remove any mappings if the errant change has set
the pmap's resident count to zero.
chips are commonly found, it makes sense to have it in GENERIC. This
is a candidate for a RELENG_6 MFC.
Approved by; peter
Requested by: pav
Tested by: pav
and return a printable representation.
This fixes recognition of the PC Engines WRAP and improves the
recognition of the Soekris boards (Bios version can now be
seen in the dmesg output for instance).
Also, add watchdog support for PCM-582x platforms.
Submitted by: Adrian Steinmann <ast@marabu.ch>
Slightly changed by: phk
PR: 81360
by Vladimir Dergachev for inclusion in DRM CVS, with minor modifications for
FreeBSD CVS and the appropriate license from Nicolai Haehnle on r300_reg.h.
Fixes hangs when using r300.sf.net userland, tested on a Radeon 9600 on amd64.
variables rather than void * variables. This makes it easier and simpler
to get asm constraints and volatile keywords correct.
MFC after: 3 days
Tested on: i386, alpha, sparc64
Compiled on: ia64, powerpc, amd64
Kernel toolchain busted on: arm
- Make sure timer0_max_count is set to a correct value in the lapic case.
- Revert i8254_restore() to explicitly reprogram timer 0 rather than
calling set_timer_freq() to do it. set_timer_freq() only reprograms
the counter if the max count changes which it never does on resume. This
unbreaks suspend/resume for several people.
Tested by: marks, others
Reviewed by: bde
MFC after: 3 days
address, writting non-canonical address can cause kernel a panic,
by restricting base values to 0..VM_MAXUSER_ADDRESS, ensuring
only canonical values get written to the registers.
Reviewed by: peter, Josepha Koshy < joseph.koshy at gmail dot com >
Approved by: re (scottl)
further changes and fixes in the future:
- Use aliases via macros rather than duplicated inlines wherever possible.
- Move all the aliases to the bottom of these files and the inline
functions to the top.
- Add various comments.
- On alpha, drop atomic_{load_acq,store_rel}_{8,char,16,short}().
- On i386 and amd64, don't duplicate the extern declarations for functions
in the two non-inline cases (KLD_MODULE and compiler doesn't do inlines),
instead, consolidate those two cases.
- Some whitespace fixes.
Approved by: re (scottl)
copied and pasted. I had actually tested without this change in my
trees as had the other testers.
Reported by: bde, Rostislav Krasny rosti dot bsd at gmail dot com
Approved by: re (scottl)
Pointy hat to: jhb
packet filter. This would cause a panic on architectures that require strict
alignment such as sparc64 (tier1) and ia64/ppc (tier2).
This adds two new macros that check the alignment, these are compile time
dependent on __NO_STRICT_ALIGNMENT which is set for i386 and amd64 where
alignment isn't need so the cost is avoided.
IP_HDR_ALIGNED_P()
IP6_HDR_ALIGNED_P()
Move bridge_ip_checkbasic()/bridge_ip6_checkbasic() up so that the alignment
is checked for ipfw and dummynet too.
PR: ia64/81284
Obtained from: NetBSD
Approved by: re (dwhite), mlaier (mentor)
by amd64 and i386: For buffered writes we collect data and write it
out a ${DEV_BSIZE}-sized block at a time. The fragsz variable is used
to keep track of how much data we have collected in the buffer so far
and it's reset to zero immediately after writing a block to the dump
device.
When the last, possibly partially filled buffer is flushed, we didn't
reset fragsz to 0 and as such would stop reflecting reality. Since we
currently only need to do buffered writes once, this isn't a problem.
However, when kernel dumps are made by hand (say by callling doadump
from within DDB), the improperly cleared state from the first call to
dumpsys causes the next call to dumpsys to create an invalid code file.
This change resets fragsz after flushing the partially filled buffer so
that it fixes the two problems at once.
Approved by: re (scottl)
This is good enough to be able to run a RELENG_4 gdb binary against
a RELENG_4 application, along with various other tools (eg: 4.x gcore).
We use this at work.
ia32_reg.[ch]: handle the 32 bit register file format, used by ptrace,
procfs and core dumps.
procfs_*regs.c: vary the format of proc/XXX/*regs depending on the client
and target application.
procfs_map.c: Don't print a 64 bit value to 32 bit consumers, or their
sscanf fails. They expect an unsigned long.
imgact_elf.c: produce a valid 32 bit coredump for 32 bit apps.
sys_process.c: handle 32 bit consumers debugging 32 bit targets. Note
that 64 bit consumers can still debug 32 bit targets.
IA64 has got stubs for ia32_reg.c.
Known limitations: a 5.x/6.x gdb uses get/setcontext(), which isn't
implemented in the 32/64 wrapper yet. We also make a tiny patch to
gdb pacify it over conflicting formats of ld-elf.so.1.
Approved by: re
* Add ichwd (The Intel EM64T folks have an ICH)
* Cosmetic comment syncs
* Merge cpufreq change over to NOTES
* add pbio (it compiles, but isn't useful since no boxes have ISA slots)
* copy ath settings (note: wlan disabled here since its in global NOTES)
* copy profiling, including fixing a previous i386->amd64 merge typo.
Approved by: re (blanket i386 <-> amd64 sync/convergence)
be possible to get the swapgs state reversed if doreti traps during
the iretq. Attempt to handle this. load_gs() might need special
handling too. Running the kernel with the user's TLS and the
kernel's PCPU space interchanged would be bad(TM).
Discovered as a result of a conversation with: bde
Approved by: re
dump format. The key reason to do this is so that we can dump sparse
address space. For example, we need to be able to skip the PCI hole
just below the 4GB boundary. Trying to destructively dump MMIO device
registers is Really Bad(TM). The frequent result of trying to do a
crash dump on a machine with 4GB or more ram was ugly (lockup or reboot).
This code has been taken directly from the IA64 dump_machdep.c code,
with just a few (mostly minor) mods.
Introduce a dump_avail[] array in the machdep.c code so that we have a
source of truth for what memory is present in a machine that needs to be
dumped. We can't use phys_avail[] because all sorts of things slice
memory out of it that we really need to dump. eg: the vm page array
and the dmesg buffer. dump_avail[] is pretty much an unmolested version
of phys_avail[]. It does have Maxmem correction.
Bump the i386 and amd64 dump format to version 2, but nothing actually
uses this. amd64 was actually using the i386 dump version number.
libkvm support to follow.
Approved by: re
exec_copyin_strings() to catch up to rev 1.266 of kern_exec.c. This fixes
panics on amd64 with compat binaries since exec_free_args() was freeing
more memory than these functions were allocating and the mismatch could
cause memory to be freed out from under other concurrent execs.
Approved by: re (scottl)
