gif(4) interface. Add new option "ignore_source" for gif(4) interface.
When it is enabled, gif's encapcheck function requires match only for
packet's destination address.
Differential Revision: https://reviews.freebsd.org/D2004
Obtained from: Yandex LLC
MFC after: 2 weeks
Sponsored by: Yandex LLC
packets on tunnel interfaces. Add support of these ioctls to gre(4),
gif(4) and me(4) interfaces. For incoming packets M_SETFIB() should use
if_fib value from ifnet structure, use proper value in gre(4) and me(4).
Differential Revision: https://reviews.freebsd.org/D2462
No objection from: #network
MFC after: 2 weeks
Sponsored by: Yandex LLC
because a link where looped back NS messages are permanently observed
does not work with either NDP or ARP for IPv4.
- draft-ietf-6man-enhanced-dad is now RFC 7527.
Discussed with: hiren
MFC after: 3 days
- Add no_dad and ignoreloop per-IF knob. no_dad disables DAD completely,
and ignoreloop is to prevent infinite loop in loopback probing state when
loopback is permanently expected.
vxlan creates a virtual LAN by encapsulating the inner Ethernet frame in
a UDP packet. This implementation is based on RFC7348.
Currently, the IPv6 support is not fully compliant with the specification:
we should be able to receive UPDv6 packets with a zero checksum, but we
need to support RFC6935 first. Patches for this should come soon.
Encapsulation protocols such as vxlan emphasize the need for the FreeBSD
network stack to support batching, GRO, and GSO. Each frame has to make
two trips through the network stack, and each frame will be at most MTU
sized. Performance suffers accordingly.
Some latest generation NICs have begun to support vxlan HW offloads that
we should also take advantage of. VIMAGE support should also be added soon.
Differential Revision: https://reviews.freebsd.org/D384
Reviewed by: gnn
Relnotes: yes
if_lagg(4) interfaces which were cloned in a vnet jail.
Sysctl nodes which are dynamically generated for each cloned interface
(net.link.lagg.N.*) have been removed, and use_flowid and flowid_shift
ifconfig(8) parameters have been added instead. Flags and per-interface
statistics counters are displayed in "ifconfig -v".
CR: D842
The FreeBSD is the only system that has the FEC protocol, that is a simple alias
to loadbalance protocol and does not implement the ancient Cisco FEC standard.
From now on, we remove the fec protocol from the documentation and keep the FEC
code only for compatibility.
Phabric: D539
Reviewed by: glebius, thompsa
Approved by: glebius
Sponsored by: QNAP Systems Inc.
and receives frames on any port of the lagg(4).
Phabric: D549
Reviewed by: glebius, thompsa
Approved by: glebius
Obtained from: OpenBSD
Sponsored by: QNAP Systems Inc.
It affects the IPv6 source address selection algorithm (RFC 6724)
and allows override the last rule ("longest matching prefix") for
choosing among equivalent addresses. The address with `prefer_source'
will be preferred source address.
Obtained from: Yandex LLC
MFC after: 1 month
Sponsored by: Yandex LLC
AppleTalk was a network transport protocol for Apple Macintosh devices
in 80s and then 90s. Starting with Mac OS X in 2000 the AppleTalk was
a legacy protocol and primary networking protocol is TCP/IP. The last
Mac OS X release to support AppleTalk happened in 2009. The same year
routing equipment vendors (namely Cisco) end their support.
Thus, AppleTalk won't be supported in FreeBSD 11.0-RELEASE.
IPX was a network transport protocol in Novell's NetWare network operating
system from late 80s and then 90s. The NetWare itself switched to TCP/IP
as default transport in 1998. Later, in this century the Novell Open
Enterprise Server became successor of Novell NetWare. The last release
that claimed to still support IPX was OES 2 in 2007. Routing equipment
vendors (e.g. Cisco) discontinued support for IPX in 2011.
Thus, IPX won't be supported in FreeBSD 11.0-RELEASE.
with CARP.
Currently, we've got a problem that interface isn't IFF_UP at the time
we assign it a redundant address, and the latter gets stuck in INIT state.
Additional SIOCSIFFLAGS from ifconfig(8) kicks it to a working state.
A proper fix is kernel side and appeared to be non-trivial, not to be
checked in before 10.0-RELEASE.
Submitted by: Ole Myhre <ole.myhre dataoppdrag.no>
It stops treating the address on the interface as special by source
address selection rule even when the interface is outgoing interface.
This is desired in some situation.
Requested by: hrs
Reviewed by: IHANet folks including hrs
MFC after: 1 week
seemingly mysterious actions that are not done by ifconfig itself, but
by devd triggering on events caused by ifconfig.
PR: docs/173405
Submitted by: Mateusz Kwiatkowski <mateusz.kwiatkowski@atlashost.eu>
MFC after: 1 week
implementation of RFC 3484 for this purpose for a long time and "prefer_source"
was never implemented actually. ND6_IFF_PREFER_SOURCE macro is left intact.
headers for TSO but also for generic checksum offloading. Ideally we
would only have one common function shared amongst all drivers, and
perhaps when updating them for IPv6 we should introduce that.
Eventually we should provide the meta information along with mbufs to
avoid (re-)parsing entirely.
To not break IPv6 (checksums and offload) and to be able to MFC the
changes without risking to hurt 3rd party drivers, duplicate the v4
framework, as other OSes have done as well.
Introduce interface capability flags for TX/RX checksum offload with
IPv6, to allow independent toggling (where possible). Add CSUM_*_IPV6
flags for UDP/TCP over IPv6, and reserve further for SCTP, and IPv6
fragmentation. Define CSUM_DELAY_DATA_IPV6 as we do for legacy IP and
add an alias for CSUM_DATA_VALID_IPV6.
This pretty much brings IPv6 handling in line with IPv4.
TSO is still handled in a different way and not via if_hwassist.
Update ifconfig to allow (un)setting of the new capability flags.
Update loopback to announce the new capabilities and if_hwassist flags.
Individual driver updates will have to follow, as will SCTP.
Reported by: gallatin, dim, ..
Reviewed by: gallatin (glanced at?)
MFC after: 3 days
X-MFC with: r235961,235959,235958
Allow tso4 and tso6 be set individually given we have the bits.
This will help with drivers not working as expected during the
transition time and later.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn
MFC After: 1 week
reality:
1. Only 12-bit VLAN Identifiers, not full 16-bit VLAN tags can be set using
ifconfig vlan.
2. When we mean VLAN Identifiers, spell it that way, rather than as VLAN tag.
MFC after: 3 days
Sponsored by: Adara Networks, Inc.
from scratch, copying needed functionality from the old implemenation
on demand, with a thorough review of all code. The main change is that
interface layer has been removed from the CARP. Now redundant addresses
are configured exactly on the interfaces, they run on.
The CARP configuration itself is, as before, configured and read via
SIOCSVH/SIOCGVH ioctls. A new prefix created with SIOCAIFADDR or
SIOCAIFADDR_IN6 may now be configured to a particular virtual host id,
which makes the prefix redundant.
ifconfig(8) semantics has been changed too: now one doesn't need
to clone carpXX interface, he/she should directly configure a vhid
on a Ethernet interface.
To supply vhid data from the kernel to an application the getifaddrs(8)
function had been changed to pass ifam_data with each address. [1]
The new implementation definitely closes all PRs related to carp(4)
being an interface, and may close several others. It also allows
to run a single redundant IP per interface.
Big thanks to Bjoern Zeeb for his help with inet6 part of patch, for
idea on using ifam_data and for several rounds of reviewing!
PR: kern/117000, kern/126945, kern/126714, kern/120130, kern/117448
Reviewed by: bz
Submitted by: bz [1]
to be assigned to a non-default FIB instance.
You may need to recompile world or ports due to the change of struct ifnet.
Submitted by: cjsp
Submitted by: Alexander V. Chernikov (melifaro ipfw.ru)
(original versions)
Reviewed by: julian
Reviewed by: Alexander V. Chernikov (melifaro ipfw.ru)
MFC after: 2 weeks
X-MFC: use spare in struct ifnet
If compiled in for dual-stack use, test with feature_present(3)
to see if we should register the IPv4/IPv6 address family related
options.
In case there is no "inet" support we would love to go with the
usage() and make the address family mandatory (as it is for anything
but inet in theory). Unfortunately people are used to
ifconfig IF up/down
etc. as well, so use a fallback of "link". Adjust the man page
to reflect these minor details.
Improve error handling printing a warning in addition to the usage
telling that we do not know the given address family in two places.
Reviewed by: hrs, rwatson
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
MFC after: 2 weeks
was incorrect - 'list scan' does not actually do a scan, but instead lists
the results of the background 'scan' cache.
Submitted by: Fabian Keil (freebsd-listen of fabiankeil de) (via email)
Discussed with: bschmidt
MFC after: 3 days
