date: 2001/08/15 00:04:59; author: augustss;
Add a little infrastructure so that individual drivers can easily check
if thee was a vendor+product locator match.
$ cat pkg.tgz | pkg_add -
The above command line will fail on -CURRENT or -STABLE, and
therefore, so will sysinstall if you try to install additional
packages through the network (FTP) from a multiuser system. Because
of the different environment during installation (wrt the playpen),
this bug does not manifest itself during initial installs, and users
may install packages from the network just fine at that time.
This bug was fixed in OpenBSD 4 years ago.
----------------------------
revision 1.4
date: 1998/04/07 05:56:13; author: marc; state: Exp; lines: +13 -8
fix package input from standard input -- the program tried to process
stdin twice. Note: it assumes stdin is a compressed tar file.
----------------------------
PR: conf/36606
Obtained from: OpenBSD
MFC after: 2 weeks
DIOCGMEDIASIZE instead.
The partition type check has been XXX'ed out since we cannot expect
that a BSD disklabel with a type field be available on all platforms.
revision 1.50
date: 2001/04/12 01:18:24; author: thorpej; state: Exp; lines: +6 -2
Only if __HAVE_GENERIC_SOFT_INTERRUPTS is then splusb == splsoftnet
(because we register the interrupt with IPL_SOFTNET). However, if
we're using a callout, then splusb == splsoftclock (because the
callouts happen from the softclock interrupt).
Note that splsoftnet blocks softclock interrupts, but this is
meant to better describe what's going on.
constructs an ELF image, consisting of the ELF header, for
each memory region a program header, followed by the memory
contents for each region. It does blocked I/O for the headers
as they are typically smaller than DEV_BSIZE.
date: 2001/01/21 19:00:06; author: augustss;
Change the operation of the USB event thread. Before it only
performed USB device discovery, now it can also perform (short)
tasks for device drivers that need a process context, but don't
have one. This is not pretty, but better than using busy-wait
in an interrupt context.
Rename memlock to sysctllock, and MEMLOCK()/MEMUNLOCK() to SYSCTL_LOCK()/
SYSCTL_UNLOCK() and related changes to make the lock names make more
sense.
Submitted by: Jonathan Mini <mini@haikugeek.com>
o 3Com 3crwe62092a
o Addtron awp100
o No Wires Necessary WLAN 550 and 1148
o Proxim RANGELANDS 8340
and reorder linksys to be in proper sort order.
Obtained from: OpenBSD (mostly)
following sysctl variables:
debug.mutex.prof.enable enable / disable profiling
debug.mutex.prof.acquisitions number of mutex acquisitions recorded
debug.mutex.prof.records number of acquisition points recorded
debug.mutex.prof.maxrecords max number of acquisition points
debug.mutex.prof.rejected number of rejections (due to full table)
debug.mutex.prof.hashsize hash size
debug.mutex.prof.collisions number of hash collisions
debug.mutex.prof.stats profiling statistics
The code records four numbers for each acquisition point (identified by
source file name and line number): longest time held, total time held,
number of non-recursive acquisitions, average time held. The measurements
are in clock cycles (as returned by get_cyclecount(9)); this may cause
measurements on some SMP systems to be unreliable. This can probably be
worked around by replacing get_cyclecount(9) by some incarnation of
nanotime(9).
This work was derived from initial patches by eivind.
