boot issues when booting with FDT. It is planned to re-enable this at a
later date.
Obtained from: ABT Systems Ltd
Sponsored by: The FreeBSD Foundation
Set MMC_CAP_4_BIT_DATA and MMC_CAP_8_BIT_DATA based on the "bus-width"
DT property and reduce maximum bus frequency from 52MHz to 50MHz to match
the capabilities of the clock provider.
Tested on a BananaPi BPI-M3 (A83T).
Since the sub-channel offers are synchronized, we can do our own
channel setup without using the sub-channel creation callback.
This paves the way to whack the sub-channel creation callback.
MFC after: 1 week
Sponsored by: Microsoft OSTC
Since the sub-channel offers are synchronized, we can do our own
channel setup without using the sub-channel creation callback.
This paves the way to whack the sub-channel creation callback.
MFC after: 1 week
Sponsored by: Microsoft OSTC
This fixes the sub-channel offer race after Hyper-V device probe/attach
is moved to vmbus SYSINIT/attach.
MFC after: 1 week
Sponsored by: Microsoft OSTC
I'm seeing 5GHz association work but data not work until the rate drops,
so I need way more information about what's being programmed into the
transmit descriptors.
Tested:
* 7260AC, STA mode
This enables LDPC receive support for the AR9300 chips that support it.
It'll announce LDPC support via net80211.
Tested:
* AR9380, STA mode
* AR9331, (to verify the HAL didn't attach it to a chip which
doesn't support LDPC.)
TODO:
* Add in net80211 machinery to make this configurable at runtime.
Add support for the FHT_STBC_TX flag in iv_flags_ht, so it'll now obey
the per-vap ifconfig stbctx flag.
This means that we can do STBC TX on one vap and not another VAP.
(As well as STBC RX on said vap; that changes the HTCAP announcement.)
This is in preparation for exposing configuring STBC flags up to ifconfig
so STBC TX/RX can be configured at runtime.
* Set the FHT_STBC flags for TX/RX if the HT capabilitiex exist
* Clear the RX STBC HT capability flag when creating a HTCAP IE, so
we only announce it if it's configured in the FHT flags.
Tested:
* AR9331 (carambola2), AP/STA modes
Always print out the firmware panic info before restarting; don't
put it behind IWM_DEBUG.
Submitted by: bapt
Differential Revision: https://reviews.freebsd.org/D6081
This allows for the long function components encountered in www/firefox.
This constant is part of DTrace's userland ABI, so this change may not be
MFC'ed.
PR: 207735
Without this change, DTrace will refuse to load a DOF section if the
function component of any of its probes exceeds DTRACE_FUNCNAMELEN (128).
Probes in C++ programs can have very long function components. Rather than
rejecting all probes if a single probe exceeds the limit, simply skip the
invalid probe and emit a warning. This ensures that valid probes are
instantiated.
PR: 207735
MFC after: 2 weeks
When this flag is turned on, DOF and DIF validation errors are printed to
the kernel message buffer. This is useful for debugging.
Also remove the debug.dtrace.debug sysctl, which has no effect.
