- Add pl310.disable tunable to disable L2 cache altogether. In
order to make sure that it's 100% disabled we use cache event
counters for cache line eviction and read allocate events
and panic if any of these counters increased. This is purely
for debugging purpose
- Direct access DEBUG_CTRL and CTRL might be unavailable in
unsecure mode, so use platform-specific functions for
these registers
- Replace #if 1 with proper erratum numbers
- Add erratum 753970 workaround
- Remove wait function for atomic operations
- Protect cache operations with spin mutex in order to prevent race condition
- Disable instruction cache prefetch and make sure data cache
prefetch is enabled in OMAP4-specific intialization
Interrupts must be disabled while handling a partial cache line flush,
as otherwise the interrupt handling code may modify data in the non-DMA
part of the cache line while we have it stashed away in the temporary
stack buffer, then we end up restoring a stale value.
PR: 160431
Submitted by: Ian Lepore
perhaps due to an interrupt configuration problem, do not try to free
device ivars that have not yet have been allocated.
MFC after: 1 week
Reviewed by: gonzo
Sponsored by: DARPA, AFRL
* Finish adding the HAL capability to announce whether a NIC supports
spectral scan or not;
* Add spectral scan methods to the HAL structure;
* Add HAL_SPECTRAL_PARAM for configuration of the spectral scan logic.
The capability ID and HAL_SPECTRAL_PARAM struct are from Qualcomm
Atheros.
the write start, by adding a variation of the vfs_write_resume(9)
which accepts flags.
Use the new function to prevent a deadlock between parallel suspension
and snapshotting a UFS mount. The ffs_snapshot() code performed
vfs_write_resume() followed by vn_start_write() while owning the
snaplock. If the suspension intervene between resume and
vn_start_write(), the deadlock occured after the suspending thread
tried to lock the snaplock, most typically during the write in the
ffs_copyonwrite().
Reported and tested by: Andreas Longwitz <longwitz@incore.de>
Reviewed by: mckusick
MFC after: 2 weeks
X-MFC-note: make the vfs_write_resume(9) function a macro after the MFC,
in HEAD
- Remove unused br_prod_bufs member
- Fixup r241037: buf_ring pads br_prod_* and br_cons_* members at 128
bytes, assuming a fixed cache line size for all the architectures.
However, the above mentioned revision broke the padding.
Use explicit padding to the CACHE_LINE_SIZE on the members that
mark the initial new padded sections. Of course, the padding is not
important for performance reasons in the DEBUG_BUFRING case, leaving
br_cons members to share the cache line with br_lock.
- Fixup r244732: by removing incorrectly added membar in
buf_ring_dequeue_sc() where surrounding locking shoud be enough.
- Drastically reduce the number of membar used (pratically reverting
r244732) by switching rmb() in buf_ring_dequeue_mc() and wmb() in
buf_ring_enqueue() to be complete barriers. This, along with
br_prod_bufs departure, should fix ordering issues as explained in
the provided comments.
This patch is not targeted for MFC.
Sponsored by: EMC / Isilon storage division
Reviewed by: glebius
- Add my copyright to files I've touched a lot this year.
- Add dash in front of all copyright notices according to style(9).
- Move $OpenBSD$ down below copyright notices.
- Remove extra line between cdefs.h and __FBSDID.
Basically it's replica of VersatilePB code which is replica of XBox FB
code. All of them are linear framebuffers and should have common bits
moved to reusable framework.
- Disable interrupt when updating compare value in order to
make this operation atomical
- Increase minimum period for event timer. Systimer on BCM2835
is compare timer, so if minimum period is too small it might
be less then fraction of time between "read current value" and
"set compare timer" operations. It means that when timer is armed
actual counter value is more then compare value and it will take
whole cycle (~32sec for 1MHz timer) to fire interrupt.
Submitted by: Daisuke Aoyama <aoyama at peach.ne.jp>
signal bug_ring ownership. However, instructions can be reordered
around members write leading to stale values for ie. br_prod_bufs.
Use correct memory barriers to ensure proper ordering of the
ownership tokens updates.
Sponsored by: EMC / Isilon storage division
MFC after: 2 weeks
typically do not handle the SYNCHRONIZE_CACHE command - they either
return an error or the firmware enters a reset loop.
Reviewed by: hselasky
Approved by: rstone (co-mentor)
MFC after: 2 weeks
As pointed out by hselasky@, USB_IF_CSI is the wrong macro here since we want
to declare the device's interface class, subclass and protocol, not class,
subclass and driver info.
Follow-up to r244704.
PR: kern/174707
Approved by: glebius
MFC after: 1 week
case. There is no point in optimizing further the code and use a TRUE
litteral for a path that does heavyweight stuff anyway (like lock acq),
at the price of obfuscated code.
Use the appropriate check where necessary and remove a macro.
Sponsored by: EMC / Isilon storage division
MFC after: 3 days
to the current demotion factor instead of assigning it.
This allows external scripts to control demotion factor together
with kernel in a raceless manner.
all interested parties in case if interface flag IFF_UP has changed.
However, not only SIOCSIFFLAGS can raise the flag, but SIOCAIFADDR
and SIOCAIFADDR_IN6 can, too. The actual |= is done not in the protocol
code, but in code of interface drivers. To fix this historical layering
violation, we will check whether ifp->if_ioctl(SIOCSIFADDR) raised the
IFF_UP flag, and if it did, run the if_up() handler.
This fixes configuring an address under CARP control on an interface
that was initially !IFF_UP.
P.S. I intentionally omitted handling the IFF_SMART flag. This flag was
never ever used in any driver since it was introduced, and since it
means another layering violation, it should be garbage collected instead
of pretended to be supported.
- Use spinlock_enter()/spinlock_exit() to prevent a thread holding a
debug lock from being preempted to prevent other threads waiting
on that lock from starvation.
- Handle the possibility of CPU migration in between the fetch of curcpu
and the call to spinlock_enter() by saving curcpu in a local variable.
- Use memory barriers to prevent reordering of loads and stores of the
data protected by the lock outside of the critical section
- Eliminate false sharing of the locks by moving them into the structures
that they protect and aligning them to a cacheline boundary.
- Record the owning thread in the lock to make debugging future problems
easier.
Reviewed by: rpaulo (initial version)
MFC after: 2 weeks
'"'. Mangling is only done for label names read from file system
metadata. Encoding resembles URL encoding. For example, the space
character becomes %20.
Help by: kib
Discussed with: imp, kib, pjd
