Engine (GCE) images with an updated version of Google's tools.
PR: 221714
Submitted by: helen _dot_ koike _@_ collabora_dot_com (original)
MFC after: 5 days
Sponsored by: The FreeBSD Foundation
Rather than repeatedly nesting loops, separate concerns with a single loop
per call stack level. Use a table to drive the recursive routine. Handle
missing topology layers more gracefully (infer a single unit).
Analyze some additional optional layers which may be present on e.g. AMD Zen
systems (groups, aka dies, per package; and cachegroups, aka CCXes, per
group).
Display that additional information in the boot-time topology information,
when it is relevent (non-one).
Reviewed by: markj@, mjoras@ (earlier version)
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D12019
The aggregation created by llquantize() partitions values into buckets; the
lower bound of the bucket containing the largest values is b^{m+1}, where
b and m are the second and fourth parameters to the action, respectively.
Bucket bounds are stored in a 64-bit integer, and so the llquantize()
validation checks need to verify that b^{m+1} fits in 64 bits. However, it
was only verifying that b^{m-1} fits in 64 bits, so certain parameter
combinations could trigger assertion failures in libdtrace.
PR: 219451
MFC after: 1 week
sysctls to display stats, stats polled every 2 seconds
Modify QLA_LOCK()/QLA_UNLOCK() to not sleep after acquiring mtx_lock
Add support to turn OFF/ON error recovery following heartbeat failure for
debug purposes.
Set default max values to 32 Tx/Rx/SDS rings
MFC after:5 days
and r322101), adding atf_expect_fail() before chflags(8) is invoked
if the filesystem is ZFS, which does not support UF_IMMUTABLE.
MFC after: 3 days
Sponsored by: The FreeBSD Foundation
The full system memory barrier around a TLB invalidation is stricter than
required. It needs to wait on accesses to main memory, with just the weaker
store variant before the invalidate. As such use the dsb istst, tlbi, dlb
ish sequence already used in pmap.
The tlbi instruction in this sequence is also unnecessarily using a
broadcast invalidate when it just needs to invalidate the local CPUs TLB.
Switch to a non-broadcast variant of this instruction.
Sponsored by: DARPA, AFRL
These builtins were listed in the mips-specific Symbol.map for libc but
were not implemented. Compiling mips with recent clang requires these
symbols.
Sponsored by: DARPA / AFRL
instructions, if supported both by CPU and kernel.
Reviewed by: jhb (previous version)
Tested by: pho (previous version)
Sponsored by: The FreeBSD Foundation
MFC after: 3 weeks
Differential revision: https://reviews.freebsd.org/D12023
Right now, we enable the CR4.FSGSBASE bit on CPUs which support the
facility (Ivy and later), to allow usermode to read fs and gs bases
without syscalls. This bit also controls the write access to bases
from userspace, but WRFSBASE and WRGSBASE instructions currently
cannot be used, because return path from both exceptions or interrupts
overrides bases with the values from pcb.
Supporting the instructions is useful because this means that usermode
can implement green-threads completely in userspace without issuing
syscalls to change all of the machine context.
Support is implemented by saving the fs base and user gs base when
PCB_FULL_IRET flag is set. The flag is set on the context switch,
which potentially causes clobber of the bases due to activation of
another context, and when explicit modification of the user context by
a syscall or exception handler is performed. In particular, the patch
moves setting of the flag before syscalls change context.
The changes to doreti_exit and PUSH_FRAME to clear PCB_FULL_IRET on
entry from userspace can be considered a bug fixes on its own.
Reviewed by: jhb (previous version)
Tested by: pho (previous version)
Sponsored by: The FreeBSD Foundation
MFC after: 3 weeks
Differential revision: https://reviews.freebsd.org/D12023
softdep_count_dependencies().
Buffer's b_dep list is protected by the SU mount lock. Owning the
buffer lock is not enough to guarantee the stability of the list.
Calculation of the UFS mount owning the workitems from the buffer must
be much more careful to not dereference the work item which might be
freed meantime. To get to ump, use the pointers chain which does not
involve workitems at all.
Reported and tested by: pho
Reviewed by: mckusick
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
When a security policy should match TCP connection with specific ports,
the SYN+ACK segment send by syncache_respond() is considered as forwarded
packet, because at this moment TCP connection does not have PCB structure,
and ip_output() is called without inpcb pointer. In this case SPIDX filled
for SP lookup will not contain TCP ports and security policy will not
be found. This can lead to unencrypted SYN+ACK on the wire.
This patch restores the old behavior, when ports will not be filled only
for forwarded packets.
Reported by: Dewayne Geraghty <dewayne.geraghty at heuristicsystems.com.au>
MFC after: 1 week
Deadlock condition:
The return value of TDQ_LOCKPTR(td) is the same for two threads.
1) The first thread signals a wakeup while keeping the rcu_read_lock().
This invokes sched_add() which in turn will try to lock TDQ_LOCK().
2) The second thread is calling synchronize_rcu() calling mi_switch() over
and over again trying to yield(). This prevents the first thread from running
and releasing the RCU reader lock.
Solution:
Release the thread lock while yielding to allow other threads to acquire the
lock pointed to by TDQ_LOCKPTR(td).
Found by: KrishnamRaju ErapaRaju <Krishna2@chelsio.com>
MFC after: 1 week
Sponsored by: Mellanox Technologies
/etc/{group,master.passwd}. This was originally turned on for all of
/etc/{aliases,group,master.passwd} in r55196, but then backed out
only for the latter two in r56697, as the adaption of the sed(1)ing
done in r56308 was incorrect. This left us with inconsistent diff(1)
formats in the daily output of periodic(8) ever since, despite in
r56697 having been promised to be revisited. So properly adapt the
password hash filtering to the unified format and turn the later on
again for /etc/{group,master.passwd}, too.
Currently several paths in the NFS client upgrade the shared vnode
lock to exclusive, which might cause temporal dropping of the lock.
This action appears to be fatal for nullfs mounts over NFS. If the
operation is performed over nullfs vnode, then bypassed down to NFS
VOP, and the lock is dropped, other thread might reclaim the upper
nullfs vnode. Since on reclaim the nullfs vnode lock and NFS vnode
lock are split, the original lock state of the nullfs vnode is not
restored. As result, VFS operations receive not locked vnode after a
VOP call.
Stop upgrading the vnode lock when we check the consistency or flush
buffers as result of detected inconsistency. Instead, allocate a new
lockmgr lock for each NFS node, which is locked exclusive instead of
the vnode lock upgrade. In other words, the other parallel
modification of the vnode are excluded by either vnode lock conflict
or exclusivity of the new lock when the vnode lock is shared.
Also revert r316529 because now the vnode cannot be reclaimed during
ncl_vinvalbuf().
In collaboration with: pho
Reviewed by: rmacklem
Reported and tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D12083
This mode allows other clean buffers to arrive while we flush the buf
lists for the vnode, which is fine for the targeted use. We only need
that all buffers existed at the time of the function start were
flushed. In fact, only one assert has to be relaxed.
In collaboration with: pho
Reviewed by: rmacklem
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
X-Differential revision: https://reviews.freebsd.org/D12083
- Use more relevant name 'signo' instead of 'i' for the local variable
which contains a signal number to send for the current exception.
- Eliminate two labels 'userout' and 'out' which point to the very end
of the trap() function. Instead use return directly.
- Re-indent the prot_fault_translation block by reducing if() nesting.
- Some more monor style changes.
Requested and reviewed by: bde
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
This information is normally available via acpi_perf, but in case it is not,
add support for fetching the information via MSRs on AMD family 17h (Zen)
processors. Zen uses a slightly different formula than previous generation
AMD CPUs.
This was inspired by, but does not fix, PR 221621.
Reported by: Sean P. R. <seanpr AT swbell.net>
Reviewed by: mjoras@
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D12082
There was already a per-vty defaults field, but it was useless since it was
only initialized when propagating the global settings and thus no different
from the current global settings and not per-vty. The global defaults field
was also invariant after boot time, but not quite so useless.
Fix this by adding a second selection bit the the control flags of the
relevant ioctl(). vidcontrol doesn't support this yet. Setting either
default propagates the change to the current setting for the same level
and then to all lower levels.
Improve the 3-way escape sequence used by termcap to control the cursor.
The "normal" (ve) case has always used reset, so the user could set
it to anything, but since the reset is to a global value this is not
very useful, especially since the "very visible" (vs) case doesn't
reset but inconsistently forces to a blinking block. Change vs to
first reset and then XOR the blinking bit so that it is predictably
different from ve.
attribute field is curs_attr. The base field holds user data translated
in a reversible way and is needed because current field holds this in
an irreversible way for efficiency.
Factor out some common code for the reversible translation. This is
slightly simpler now, and much easier to expand.
Translate the magic flags value -1 to a single control flag internally
up front so other flags can be trusted later. This can be used for the
relevant ioctl() too.
Remove CONS_CURSOR_FLAGS which contained all the control flags. It was
unused and not useful. After adding more flags, there will be tests on
a couple at a time but never on them all. This API should have used this
to disallow unknown flags.
Make sure that %eflags.D flag is cleared for hook.
Improve comments.
When #UD dtrace code checks for a registered hook before checking that
the exception was raised from kernel mode, we might run with the user
%ds, trapping on access. Exception entry from userspace automatically
load valid %ss, which we can use there instead.
Noted and reviewed by: bde
Sponsored by: The FreeBSD Foundation
MFC after: 3 days
redundant initializations.
Hard-code base = 0, height = (approx. 1/8 of the boot-time font height)
in all cases, and remove the BIOS/MD support for setting these values.
This asks for an underline cursor sized for the boot-time font instead
of various less hard-coded but worse values. I used that think that
the x86 BIOS always gave the same values as the above hard-coding, but
on 1 of my systems it gives the wrong value of base = 1.
The remaining BIOS fields are shift_state and bell_pitch. These are now
consistently not explicitly reinitialized to 0. All sc_get_bios_value()
functions except x86's are now empty, and the only useful thing that x86
returns is shift_state. This really belongs in atkbdc, but heavier
use of the BIOS to read the more useful typematic rate has been removed
there. fb still makes much heavier use of the BIOS.
