be accessed by root. It uses unsigned ints instead of size_t
to preserve the ABI.
PR: 207627
Submitted by: ryan@ryanday.net (with slight tweaks)
MFC after: 1 month
This change reverts most of r281985.
The method did not map to anything defined by SMBus protocol and could
not be implemented for SMBus controllers.
This change is obviously not backwards compatible, but I have good
reasons to believe that there have never been any users of SMB_TRANS.
Discussed with: grembo, jhb
MFC after: 6 weeks
To enable event sourcing from atkbd kern.evdev.rcpt_mask value
should have bit 3 set.
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D8381
The device doesn't accurately update the CHANCMP address with the device state
when the device is suspended or halted. So, read the CHANSTS register to check
for those states.
We still need to read the CHANCMP address for the last completed descriptor.
Sponsored by: Dell EMC Isilon
we never try to sleep while the thread is on a sleepqueue.
Reviewed by: jhb
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D8422
that are apparently misconfigured by the manufacturer and cause the mapping
logic to fail. The fallback allows drive numbers to be assigned based on the
PHY number that they're attached to. Add sysctls and tunables to overrid
this new behavior, but they should be considered only necessary for debugging.
Reviewed by: imp, smh
Obtained from: Netflix
MFC after: 3 days
Sponsored by: D8403
* Rename ARM_HAVE_MP_EXTENSIONS to ARM_USE_MP_EXTENSIONS and extend it to
handle more cases, including when SMP is not enabled.
* Check ARM_USE_MP_EXTENSIONS when building for ARMv7+, even if no SMP.
* Use ARM_USE_MP_EXTENSIONS in pmap-v6.c to detect when to set PRRR_NS1.
With this we should be able to boot on all ARMv7+ Cortex-A cores with
32-bit support.
Reviewed by: mmel, imp (earlier version)
Relnotes: yes
Sponsored by: ABT Systems Ltd
Differential Revision: https://reviews.freebsd.org/D8335
If dotdot lookup does not escape from the file descriptor passed as
the lookup root, we can allow the component traversal. Track the
directories traversed, and check the result of dotdot lookup against
the recorded list of the directory vnodes.
Dotdot lookups are enabled by sysctl vfs.lookup_cap_dotdot, currently
disabled by default until more verification of the approach is done.
Disallow non-local filesystems for dotdot, since remote server might
conspire with the local process to allow it to escape the namespace.
This might be too cautious, provide the knob
vfs.lookup_cap_dotdot_nonlocal to override as well.
Idea by: rwatson
Discussed with: emaste, jonathan, rwatson
Reviewed by: mjg (previous version)
Tested by: pho (previous version)
Sponsored by: The FreeBSD Foundation
MFC after: 2 week
Differential revision: https://reviews.freebsd.org/D8110
process of being unmounted. Previously it would skip them, even if the
unmount eventually failed eg due to the filesystem being busy.
This behaviour broke autounmountd(8) - if you tried to manually unmount
a mounted filesystem, using 'automount -u', and the autounmountd attempted
to refresh the filesystem list in that very moment, it would conclude that
the filesystem got unmounted and not try to unmount it afterwards.
Reviewed by: kib@
Tested by: pho@
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D8030
While I'm here, move message status codes to hv_utilreg.h, since they
will be used by the upcoming VSS stuffs.
Submitted by: Hongjiang Zhang <honzhan microsoft com>
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8391
lsdev should display detailed information about net devices only with -v
switch. This will make EFI and BIOS version of the loader to have the
same behavior.
Reviewed by: bapt, imp
Approved by: imp (mentor)
Differential Revision: https://reviews.freebsd.org/D8415
With guest trackpoint present trackpoint probing switched synaptics
device to absolute mode with different protocol instead of keeping it
in relative mode.
PR: 213757
Submitted by: Vladimir Kondratyev <wulf@cicgroup.ru>
MFC after: 1 week
Summary:
i.MX5 and PowerPC use a very similar eSDHC controller, which is also
similar to the uSDHC controller used by i.MX6. The imx_sdhci driver works
almost completely with PowerPC, with some minor tweaks.
There is one caveat with this: reset currently does not work on PowerPC, so has
been #ifdef'd out until this can be tracked down and fixed. If resets are done
the controller will timeout all data transactions. Without a reset, it appears
to work just fine.
This is part 3, following up r308186 and r308187.
Test Plan:
This has been tested on a PowerPC QorIQ P1022 board. It has not been
tested on i.MX, but no regressions are expected.
Reviewed By: imp
Differential Revision: https://reviews.freebsd.org/D8407
Some controllers (namely Freescale's eSDHC, tested) will continue to assert
the card removed or card insert interrupts even after being handled. To work
around this, disable watching the interrupt that just occurred until the
opposite interrupt is triggered.
Linux has a similar change in its driver to address the same problem.
* Starting a scan from wpa_supplicant or via ifconfig while associated,
should no longer cause firmware panics or abort early.
Tested:
* AC7260, STA mode
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8412
* SYNC_RESP_STRUCT and SYNC_RESP_PTR originate from the OpenBSD version of
iwm, and they weren't serving any real purpose in the FreeBSD port.
* We just do a single bus_dmamap_sync for syncing the complete received frame,
instead of explicitly bus_dmamap_sync-ing subranges of the frame like in
the OpenBSD iwm code.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D7939
This allows us to make strong assertions about descriptor address
validity. Additionally, future generations of the ioat(4) hardware will
require contiguous descriptors.
Reviewed by: markj
Sponsored by: Dell EMC Isilon
This paves the way for a contiguous descriptor array.
A contiguous descriptor array has the benefit that we can make strong
assertions about whether an address is a valid descriptor or not. The
other benefit is that future generations of I/OAT hardware will require
a contiguous descriptor array anyway. The downside is that after system
boot, big chunks of contiguous memory is much harder to find. So
dynamic scaling after boot is basically impossible.
Reviewed by: markj
Sponsored by: Dell EMC Isilon
for dummynet, use the correct argument for that, remove the false coment
about the presence of struct ifnet.
Fixes the input match of dummynet l2 rules.
Obtained from: pfSense
MFC after: 2 weeks
Sponsored by: Rubicon Communications, LLC (Netgate)
in-progress count and the vnode. Prior to r188331, we always acquired
the vnode lock before incrementing the object's paging-in-progress count.
Now, we increment it before attempting to acquire the vnode lock with
LK_NOWAIT, but we never sleep acquiring the vnode lock while we have the
count incremented.
Reviewed by: kib
MFC after: 3 days
Before this an earlier writes to a ZVOL opened without FSYNC could get to
ZIL after later writes to the same ZVOL opened with FSYNC. Fix this by
replicating functionality of ZPL (zv_sync_cnt equivalent to z_sync_cnt),
marking all log records sync if anybody opened the ZVOL with FSYNC.
MFC after: 2 weeks
And put them under HN_IFSTART_SUPPORT, which is by default on until
we whack the if_start related bits from base system.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8392
